Catalytic hydrogenation activation energy

Figure 1 show hydrogen conversions for dehydrocondensation at different temperatures of catalysts. It has been found that catalytic dehydrocondensation reaction displays the second order. Dehyd-rocondensation reaction rate constants are determined, and catalytic dehydrocondensation activation energies are calculated /, act = 28.1 -28.5 kJ/Mole. As a consequence, for anhydrous caustic potash and platinum hydrochloric acid application as the catalyst activation energies are almost the same. 

Chlorination of Methane. Methane can be chlorinated thermally, photochemicaHy, or catalyticaHy. Thermal chlorination, the most difficult method, may be carried out in the absence of light or catalysts. It is a free-radical chain reaction limited by the presence of oxygen and other free-radical inhibitors. The first step in the reaction is the thermal dissociation of the chlorine molecules for which the activation energy is about 84 kj/mol (20 kcal/mol), which is 33 kJ (8 kcal) higher than for catalytic chlorination. This dissociation occurs sufficiendy rapidly in the 400 to 500°C temperature range. The chlorine atoms react with methane to form hydrogen chloride and a methyl radical. The methyl radical in turn reacts with a chlorine molecule to form methyl chloride and another chlorine atom that can continue the reaction. The methane raw material may be natural gas, coke oven gas, or gas from petroleum refining. 

Both PtRu/MgO catalysts prepared from cluster precursor and organometallic mixture were active for ethylene hydrogenation. The apparent activation energy of the former catalyst obtained from the Arrhenius plot during -40 to -25°C was 5.2 kcal/mol and that of the latter catalyst obtained during -50 to -30°C was 6.0 kcal/mol. The catalytic activity in terms of turn over frequency (TOP) was calculated on the assumption that all metal particles were accessible for reactant gas. Lower TOP of catalyst prepared from cluster A at -40°C, 57.3 x lO" s" was observed probably due to Pt-Ru contribution compared to that prepared from acac precursors. 

Vreactor=70 ml VCh=Vrcn=10 ml (0.045 mole) 111 1 =0.3 g PH2=80 bar (at RT) was not maintained during reaction NH3/RCN=0.25 without ammonia, selectivity of SB is higher at lower temperatures. The selectivity to RNH2 decreased with reaction time for the experiment performed without NH3. The apparent activation energy of the hydrogenation of RCN on RNi-L catalyst was 30.5 kJ/mol, which is close to the value 46 kJ/mol measured in the liquid phase hydrogenation of acetonitrile on CoB amorphous alloy catalyt [7], RNi-C is more active than RNi-L catalyst (compare Table 1 No 4 and 6 and Table 2 No 7 and 8). 

The WGS reaction is a reversible reaction that is, the WGS reaction attains equilibrium with the reverse WGS reaction. Thus, the fact that the WGS reaction is promoted by H20 (a reactant), in turn implies that the reverse WGS reaction may also be promoted by a reactant, H2 or C02. In fact, the decomposition of the surface formates produced from H2+C02 was promoted 8-10 times by gas-phase hydrogen. The WGS and reverse WGS reactions conceivably proceed on different formate sites of the ZnO surface unlike usual catalytic reaction kinetics, while the occurrence of the reactant-promoted reactions does not violate the principle of microscopic reversibility. The activation energy for the decomposition of the formates (produced from H20+CO) in vacuum is 155 kJ/mol, and the activation energy for the decomposition of the formates (produced from H2+C02) in vacuum is 171 kJ/mol. The selectivity for the decomposition of the formates produced from H20+ CO at 533 K is 74% for H20 + CO and 26% for H2+C02, while the selectivity for the decomposition of the formates produced from H2+C02 at 533 K is 71% for H2+C02 and 29% for H20+C0 as shown in Scheme 8.3. The drastic difference in selectivity is not presently understood. It is clear, however, that this should not be ascribed to the difference of the bonding feature in the zinc formate species because v(CH), vav(OCO), and v/OCO) for both bidentate formates produced from H20+C0 and H2+C02 show nearly the same frequencies. Note that the origin (HzO+CO or H2+C02) from which the formate is produced is remembered as a main decomposition path under vacuum, while the origin is forgotten by coadsorbed H20. 

A 90% reduction in activation energy, not an unreasonable expectation for catalysts in general, reduces the peak temperature below 0 C. Clearly, only a small amount of catalytic action is required to make dramatic reductions in the release temperature. This implies that, with careful control of the invented process, it should be possible to dial-in the desorption temperature for hydrogen desorption. This allows us to assess how this hydrogen storage media can be applied. 

---