Catalytic Heck reaction

Ozawa, F., Kubo, A. and Hayashi, T. (1992) Generation of tertiary phosphine-coordinated Pd(0) species from Pd(OAc)2 in the catalytic Heck reaction. Chem. Lett., 21, 2177-80. 

The first direct, clear-cut experimental evidence for the formation of Pd(IV) species by oxidative addition of an aryl iodide to Pd(II) was provided by the group of Vicente [204] (Scheme 1.20). The oxidative addition occurs intramolecularly on a paUadacycle 22 with a particularly electron-rich Pd(II) center to form 24 via intermediate 23. Although Pd(IV) complexes related to 24 can undergo insertion reactions with styrene and alkyl acrylates in a Heck process, the catalytic cycle involved is probably not particularly pertinent to most Heck catalytic Heck reactions [204b]. 

The possible involvement of Pd(iv) intermediates in catalytic Heck reactions has been put forward by several authors and a considerable debate has developed.All experimental evidence obtained so far seems to speak against a Pd(ii)/Pd(iv) mechanism and for a sequence involving only Pd(0) and Pd(ii). The subject has been very well reviewed recently. 

Use of Qi-acetamidoacrylate esters in the Heck reaction allows for the introduction of a dehydroalanine side-chain. The dehydrotryptophans can be reduced catalytically, and this reduction can be done enantioselectively[17]. 

Heck reaction, palladium-catalyzed cross-coupling reactions between organohalides or triflates with olefins (72JOC2320), can take place inter- or intra-molecularly. It is a powerful carbon-carbon bond forming reaction for the preparation of alkenyl- and aryl-substituted alkenes in which only a catalytic amount of a palladium(O) complex is required. 

The catalytic cycle of the Heck reaction can be formulated with four steps as follows ... 

For the performance of an enantioselective synthesis, it is of advantage when an asymmetric catalyst can be employed instead of a chiral reagent or auxiliary in stoichiometric amounts. The valuable enantiomerically pure substance is then required in small amounts only. For the Fleck reaction, catalytically active asymmetric substances have been developed. An illustrative example is the synthesis of the tricyclic compound 17, which represents a versatile synthetic intermediate for the synthesis of diterpenes. Instead of an aryl halide, a trifluoromethanesul-fonic acid arylester (ArOTf) 16 is used as the starting material. With the use of the / -enantiomer of 2,2 -Z7w-(diphenylphosphino)-l,F-binaphthyl ((R)-BINAP) as catalyst, the Heck reaction becomes regio- and face-selective. The reaction occurs preferentially at the trisubstituted double bond b, leading to the tricyclic product 17 with 95% ee. °... 

The original Sonogashira reaction uses copper(l) iodide as a co-catalyst, which converts the alkyne in situ into a copper acetylide. In a subsequent transmeta-lation reaction, the copper is replaced by the palladium complex. The reaction mechanism, with respect to the catalytic cycle, largely corresponds to the Heck reaction.Besides the usual aryl and vinyl halides, i.e. bromides and iodides, trifluoromethanesulfonates (triflates) may be employed. The Sonogashira reaction is well-suited for the synthesis of unsymmetrical bis-2xy ethynes, e.g. 23, which can be prepared as outlined in the following scheme, in a one-pot reaction by applying the so-called sila-Sonogashira reaction ... 

Many types of functional groups are tolerated in a Suzuki reaction, and the yields are often good to very good. The presence of a base, e.g. sodium hydroxide or sodium/potassium carbonate, is essential for this reaction. The base is likely to be involved in more than one step of the catalytic cycle, at least in the transmetal-lation step. Proper choice of the base is important in order to obtain good results." In contrast to the Heck reaction and the Stille reaction, the Suzuki reaction does not work under neutral conditions. 

Carbon-carbon bond formation reactions and the CH activation of methane are another example where NHC complexes have been used successfully in catalytic applications. Palladium-catalysed reactions include Heck-type reactions, especially the Mizoroki-Heck reaction itself [171-175], and various cross-coupling reactions [176-182]. They have also been found useful for related reactions like the Sonogashira coupling [183-185] or the Buchwald-Hartwig amination [186-189]. The reactions are similar concerning the first step of the catalytic cycle, the oxidative addition of aryl halides to palladium(O) species. This is facilitated by electron-donating substituents and therefore the development of highly active catalysts has focussed on NHC complexes. 

Larhed et al. investigated enantioselective Heck reactions with 2,3-dihydrofuran as alkene [86]. In the coupling with phenyl triflate, conditions previously reported by Pfaltz [87] were attempted under microwave irradiation. Interestingly, the catalytic system Pd2(dba)3/(4S)-4-t-butyl-2-[2-(diphenylphosphanyl)phenyl]-4,5-dihydro-l,3-oxazole, identified by the Swiss team, was found suitable for high-temperature microwave-assisted enantioselective Heck reactions (Scheme 76). Using a proton sponge as a base and benzene as a solvent gave the best conversions (Scheme 76). At tempera-... 

Microwave-assisted Heck reaction of (hetero)aryl bromides with N,N-dimethyl-2-[(2-phenylvinyl)oxy]ethanamine, using Herrmann s palladacycle as a precatalyst, yielded the corresponding /3-(hetero)arylated Heck products in a good EjZ selectivity (Scheme 79) [90]. The a/yd-regioselectivity can be explained by the chelation control in the insertion step. This selectivity is better than 10/90 when no severe steric hindrance is introduced in the (hetero)aryl bromides. The process does not require an inert atmosphere. There is evidence that a Pd(0)/Pd(II)- and not Pd(II)/Pd(IV)-based catalytic cycle is involved. Similarly, other j6-amino-substituted vinyl ethers such as... 

An interesting parallel was found while the microwave-enhanced Heck reaction was explored on the C-3 position of the pyrazinone system [29]. The additional problem here was caused by the capability of the alkene to undergo Diels-Alder reaction with the 2-azadiene system of the pyrazinone. An interesting competition between the Heck reaction and the Diels-Alder reaction has been noticed, while the outcome solely depended on the substrates and the catalyst system. Microwave irradiation of a mixture of pyrazinone (Re = H), ethyl acrylate (Y = COOEt) and Pd(dppf)Cl2 resulted in the formation of a mixture of the starting material together with the cycloaddition product in a 3 1 ratio (Scheme 15). On the contrary, when Pd(OAc)2 was used in combination with the bulky phosphine ligand 2-(di-t-butylphosphino)biphenyl [41-44], the Heck reaction product was obtained as the sole product. When a mixture of the pyrazinone (Re = Ar) with ethyl acrylate or styrene and Pd(dppf)Cl2 was irradiated at 150 °C for 15 min, both catalytic systems favored the Heck reaction product with no trace of Diels-Alder adduct. 

The Pd-catalysed Heck reaction performed with thiourea as the Ugand exhibit good activities for some catalysts. As for carbene ligands [104], steric hindrance improves catalytic results. Thus, thioureas wearing bulky substituents afford the formation of air- and moisture-stable Pd complexes [105]. For example, the catalyst obtained with 2mol% Pd(dba)2 and Ar,M -dimesitylene-ethylene thiourea (Scheme 24) was still active even after 2 months in an air atmosphere. 

The Mizoroki-Heck reaction is a metal catalysed transformation that involves the reaction of a non-functionalised olefin with an aryl or alkenyl group to yield a more substituted aUcene [11,12]. The reaction mechanism is described as a sequence of oxidative addition of the catalytic active species to an aryl halide, coordination of the alkene and migratory insertion, P-hydride elimination, and final reductive elimination of the hydride, facilitated by a base, to regenerate the active species and complete the catalytic cycle (Scheme 6.5). 

Scheme 6.5 Catalytic cycle for the Mizoroki-Heck reaction...

Scheme 6.13 Mizoroki-Heck reaction of non-activated aryl chlorides and diazo compounds using Seller s catalytic systems...

Abstract This chapter highlights the use of iV-heterocyclic carbenes as supporting ligands in arylation reactions different than the more common cross-coupling reactions, including C-F bond activation, catalytic arylation, homocoupling, direct arylation and oxidative Heck reactions. 

This method ensures the deposition of very reactive metal nanoparticles that require no activation steps before use. We shall review here the following examples of catalytic reactions that are of interest in line chemical synthesis (a) the hydrogenation of substituted arenes, (b) the selective hydrogenation of a, 3-unsaturated carbonyl compounds, (c) the arylation of alkenes with aryl halides (Heck reaction). The efficiency and selectivity of commercial catalysts and of differently prepared nanosized metal systems will be compared. 

Another important type of reactivity of palladium, namely oxidative addition to Pd(0), is the foundation for several methods of forming carbon-carbon bonds. Aryl126 and alkenyl127 halides react with alkenes in the presence of catalytic amounts of palladium to give net substitution of the halide by the alkenyl group. The reaction, known as the Heck reaction,128 is quite general and has been observed for simple alkenes, aryl-substituted alkenes, and substituted alkenes such as acrylate esters, vinyl ethers, and A-vinylamides.129... 

---