Carboxylic acids isomers

Trihydroxy-2,3-dihydro-l//-pyrimido[l,2-u]quinoline-3-car-boxylic acid and (420) and its (15)-1-carboxylic acid isomer were isolated from isopyoverdins (97ZN(C)549, 01T1019) and pyoverdins (99MI27), respectively, after acidic hydrolysis in 3 M HCl for 5 days at 110°C. 

Furoxans are very feeble bases, even when an amino group is attached to the ring. 4-Amino-3-methylfuroxan behaves as a Hammett base [15], as does benzofuroxan (2, R=H) [7]. By contrast, the two methylfuroxan carboxylic acid isomers show equal high dissociation constants [9]. 

The position of the amidino group makes little difference to the Factor Xa potency of these compounds but, interestingly, has a dramatic effect on the selectivity towards thrombin [62]. It was also observed that one carboxylic acid isomer (CX-9065a) was 7 times more potent on Factor Xa than the other. A second set of analogs shows a similar SAR [60]. 

The (aminomethyl)thiophene-2-carboxylic acid isomers were prepared from the corresponding methylthiophene-2-carboxylic acid esters, as exemplified for the 3-(aminomethyl) isomer 79 (Scheme 22))66 The 4-(aminomethyl) isomer was prepared in the same way, but with a low yield for the bromination step (7%))66,111 For the 5-(aminomethyl) isomer the bromomethyl compound was reacted with sodium azide, followed by catalytic reduction)74 The corresponding furan and pyridine analogues were prepared similarly. 

Draw and name the eight carboxylic acid isomers with the formula C( Hiji02. 

In hydrocarboxylations, as in the 0x0 process, selectivity of linear versus branched products is an important issue, because (in general) mixtures of isomeric carboxylic acids are obtained, owing not only the occurrence of both Markovni-kov and anti-Markovnikov addition of the alkene to the metal hydride, but also to metal-catalyzed alkene isomerization (eq. (2)). In the case of higher olefins, Co2(CO)g as catalyst leads to a number of different carboxylic acid isomers due to the isomerization activity of the catalyst. 

How can the following two carboxylic acid isomers be distinguished by infrared spectroscopy ... 

Carboxylic acids react with butadiene as alkali metal carboxylates. A mixture of isomeric 1- and 3-acetoxyoctadienes (39 and 40) is formed by the reaction of acetic acid[13]. The reaction is very slow in acetic acid alone. It is accelerated by forming acetate by the addition of a base[40]. Addition of an equal amount of triethylamine achieved complete conversion at 80 C after 2 h. AcONa or AcOK also can be used as a base. Trimethylolpropane phosphite (TMPP) completely eliminates the formation of 1,3,7-octatriene, and the acetoxyocta-dienes 39 and 40 are obtained in 81% and 9% yields by using N.N.N M -tetramethyl-l,3-diaminobutane at 50 in a 2 h reaction. These two isomers undergo Pd-catalyzed allylic rearrangement with each other. 

Both 1,2- and 2,1-benzisothiazoles react with electrophiles to give 5- and 7-substituted products (see Section 4.02.3.2). The isothiazole ring has little effect on the normal characteristics of the benzene ring. C-Linked substituents react almost wholly normally, the isothiazole ring having little effect except that phenyl substituents are deactivated (see Section 4.17.2.1). There are, however, considerable differences in the ease of decarboxylation of the carboxylic acids, the 4-isomer being the most stable (see Section 4.02.3.3). 

Hunig and Salzwedel (20) report that the acylation of the pyrrolidine enamine of 3-methylcyclohexanone with propionylchloride followed by the hydrolysis and the base cleavage of the resulting dione isomers (71) and (72) and subsequent reduction of the keto groups gave a 3 7 mixture of the carboxylic acids (73 and 74), respectively. Vig et al. (39), however, found o o o o... 

Finally, certain 3-substituted compounds can be prepared by utilizing the - meta) directing powet (cf. Section IV,B) of some groups in the 2-position which afterward can be removed. 3-Nitrothiophene is prepared by nitration of 2-thiophenesulfonyl chloride and by removal of the sulfonic acid group of the 4-nitro-2-sulfonyl chloride formed with superheated steam. Another approach to 3-nitrothio-phene is to nitrate 2-cyanothiophene, separate the 4-nitro-2-cyano-thiophene from the 5-isomer, hydrolyze, and decarboxylate. A final method of preparation of 3-nitrothiophene is by simultaneous de-bromination and decarboxylation of 5-bromo-4-nitro-2-thiophene-carboxylic acid obtained through the nitration of methyl 5-bromo-2-thiophenecarboxylate. 

The synthesis of isoxazolines usually takes the most thermodynamically favorable course to yield solely the more stable isomer. However, cinnamic acids (38) give not only isoxazoline-4-carboxylic acids (39) but also, as a by-product, the less stable isoxazoline-5-carboxylic acids (40)" which on heating undergo retro-addition. ... 

A solution of the above ester (207.8 grams) and 64.5 grams of sodium hydroxide in 80 cc of water and 600 cc of ethanol is refluxed for 9 hours. The carboxylic acid of 2-phenyl-cyclopropane is liberated with 200 cc of concentrated hydrochloric acid. The 2-phenyl-cyclopropanecarboxylic acid contains 3 to 4 parts of the trans isomer to 1 part of the cis isomer. The acid is recrystallized from hot water. The pure trans isomer comes out as crystalline material (solid) while the cis isomer stays in solution. 

Notable examples of general synthetic procedures in Volume 47 include the synthesis of aromatic aldehydes (from dichloro-methyl methyl ether), aliphatic aldehydes (from alkyl halides and trimethylamine oxide and by oxidation of alcohols using dimethyl sulfoxide, dicyclohexylcarbodiimide, and pyridinum trifluoro-acetate the latter method is particularly useful since the conditions are so mild), carbethoxycycloalkanones (from sodium hydride, diethyl carbonate, and the cycloalkanone), m-dialkylbenzenes (from the />-isomer by isomerization with hydrogen fluoride and boron trifluoride), and the deamination of amines (by conversion to the nitrosoamide and thermolysis to the ester). Other general methods are represented by the synthesis of 1 J-difluoroolefins (from sodium chlorodifluoroacetate, triphenyl phosphine, and an aldehyde or ketone), the nitration of aromatic rings (with ni-tronium tetrafluoroborate), the reductive methylation of aromatic nitro compounds (with formaldehyde and hydrogen), the synthesis of dialkyl ketones (from carboxylic acids and iron powder), and the preparation of 1-substituted cyclopropanols (from the condensation of a 1,3-dichloro-2-propanol derivative and ethyl-... 

Eq. (3), with lithium diisopropylamide (LDA) to a lithiospecies and in its subsequent reaction with C02 affording via the corresponding 4-carboxylic acid its ethyl ester 59. In the alternative version perchlorate 48e is electro-chemically reduced in acetonitrile to an anionic species that was converted either to a 3 1 mixture of isomers 56 (R = f-Bu) and 60 or to 4//-thiopyran 56 (R = PhCH2) with f-BuI or PhCH2Br, respectively (90ACS524). The kinetics of the benzylation procedure was followed by cyclic voltammetry [88ACS(B)269]. 

As with the isomers, 5-halogenation of 2,1-benzisoxazoles is favored, but this may be a consequence of an initially formed 4,5-addition product. Such an adduct has been isolated during chlorination [66T(S7)49 67AHC(8)277]. When 6-nitro-2,l-benzisoxazole-3-carboxylic acid (38)... 

Desilylation of the major jjw-isomer, followed by oxidative cleavage with sodium metaperiodate, liberates the 3-hydroxy-2-methyl carboxylic acids. The immolative character of this method, i.e., the destruction of the chiral auxiliary reagent in the final glycol cleavage, is a drawback. 

In his pioneering work, Sus (1944) assumed that the final product of photodediazoniation of 2,1-diazonaphthoquinone (10.75) is indene-l-carboxylic acid (10.79, not the 3-isomer 10.78). He came to this conclusion on the basis of some analogies (in addition to an elemental analysis). Cope et al. (1956) as well as Yates and Robb (1957) found that the infrared spectrum of the product was consistent with an a,P-unsaturated acid. Later, Melera et al. (1974) verified the structure 10.78 by H NMR spectroscopy. Friedrich and Taggart (1975) showed that the equilibrium between 10.78 and 10.79 at 233 K lies on the side of the latter, but 10.78 clearly predominates at or above 0°C. Ponomareva et al. (1980) showed that not only 2,1-, but also 1,2-diazo-naphthoquinone yields indene-3- and not -1-carboxylic acid. 

The t3rpe of carboxylic acid formed therefore depends on, amongst other things, the relative rates of carbonylation and of rearrangement or dimerization. The trialkylacetic acids are, from a technical point of view, the most valuable isomers (Vegter, 1970). 

The study of optical isomers has shown a similar development. First it was shown that the reduction potentials of several meso and racemic isomers were different (Elving et al., 1965 Feokstistov, 1968 Zavada et al., 1963) and later, studies have been made of the ratio of dljmeso compound isolated from electrolyses which form products capable of showing optical activity. Thus the conformation of the products from the pinacolization of ketones, the reduction of double bonds, the reduction of onium ions and the oxidation of carboxylic acids have been reported by several workers (reviewed by Feokstistov, 1968). Unfortunately, in many of these studies the electrolysis conditions were not controlled and it is therefore too early to draw definite conclusions about the stereochemistry of electrode processes and the possibilities for asymmetric syntheses. 

---