Carbon monoxide exchange reactions

Stanghellini, P. L., Cetini, G., Gambino, O., and Rossetti, R., Effect of solvents on carbon monoxide exchange reaction of Fe3(CO)9Te2, Inorg. Chim. Acta 3, 651 (1969). 

A Study of the carbon monoxide exchange reactions of [MnCl(CO)3L2] shows a decrease of rate in the order P(CsH5)3 > As(C6Hs)3 > Sb(CjH5)3,... 

It should be noted that cyclobutadiene always replaces carbon monoxide in reactions with metal carbonyl derivatives. Yields of product parallel the known rate of exchange of CO in the starting carbonyl 184). Highest yields of ligand transfer products are attained with nickel and cobalt carbonyls which are known to very rapidly exchange their CO groups by a D-type mechanism 185-188). Lowest yields have been reported with Mo and W complexes, the carbonyls of which exchange with CO very slowly 188). 

The reaction rate of the whole process in some reversible exothermic reactions, such as the carbon monoxide shift reaction, can be considerable. The heat needed to be extracted from unit volume of catalyst at the beginning and the ending stages of the reaction may vary by 10 times or more. These reactions require multi-stage heat exchange reactors. Other reactions, such as the ammonia synthesis... 

Papers have considered the carbon monoxide exchange of metal carbonyls themselves 54) and of metal carbonyl halides (55) as well as of base-substituted complexes. In the series [Ni(CO)4], [Ni(CO)3P(CfiHs)3], Ni(CO)2[P(C5H5)3]2, the rate of CO exchange (SnI) decreases in the ratio 420 70 1 54). This order clearly shows the strengthening effect of phosphine substitution on the remaining metal-carbon bond. The rate of the SnI reaction between P(C6Hs)3 and [Ni(CO)4] is the same as the rate of CO exchange of [Ni(CO)4] 66). 

About half of the wodd production comes from methanol carbonylation and about one-third from acetaldehyde oxidation. Another tenth of the wodd capacity can be attributed to butane—naphtha Hquid-phase oxidation. Appreciable quantities of acetic acid are recovered from reactions involving peracetic acid. Precise statistics on acetic acid production are compHcated by recycling of acid from cellulose acetate and poly(vinyl alcohol) production. Acetic acid that is by-product from peracetic acid [79-21-0] is normally designated as virgin acid, yet acid from hydrolysis of cellulose acetate or poly(vinyl acetate) is designated recycle acid. Indeterrninate quantities of acetic acid are coproduced with acetic anhydride from coal-based carbon monoxide and unknown amounts are bartered or exchanged between corporations as a device to lessen transport costs. 

H), followed by bromine-lithium exchange using 2 equivalents of tert-butyllithium to give the desired intermediate. This intermediate readily picked up carbon monoxide and work-up of the reaction mixture gave indigo (Fig. 17) (ref. 31). 

The authors developed a multi-layered microreactor system with a methanol reforma- to supply hydrogen for a small proton exchange membrane fiiel cell (PEMFC) to be used as a power source for portable electronic devices [6]. The microreactor consists of four units (a methanol reformer with catalytic combustor, a carbon monoxide remover, and two vaporizers), and was designed using thermal simulations to establish the rppropriate temperature distribution for each reaction, as shown in Fig. 3. 

Abstract This chapter focuses on carbon monoxide as a reagent in M-NHC catalysed reactions. The most important and popular of these reactions is hydro-formylation. Unfortunately, uncertainty exists as to the identity of the active catalyst and whether the NHC is bound to the catalyst in a number of the reported reactions. Mixed bidentate NHC complexes and cobalt-based complexes provide for better stability of the catalyst. Catalysts used for hydroaminomethylation and carbonyla-tion reactions show promise to rival traditional phosphine-based catalysts. Reports of decarbonylation are scarce, but the potential strength of the M-NHC bond is conducive to the harsh conditions required. This report will highlight, where appropriate, the potential benefits of exchanging traditional phosphorous ligands with iV-heterocyclic carbenes as well as cases where the role of the NHC might need re-evaluation. A review by the author on this topic has recently appeared [1]. 

Exchange reactions between bulk and adsorbed substances can be studied by on-line mass spectroscopy and isotope labeling. In this section the results on the interaction of methanol and carbon monoxide in solution with adsorbed methanol and carbon monoxide on platinum are reported [72], A flow cell for on-line MS measurements (Fig. 1.2) was used. 13C-labeled methanol was absorbed until the Pt surface became saturated. After solution exchange with base electrolyte a potential scan was applied. Parallel to the current-potential curve the mass intensity-potential for 13C02 was monitored. Both curves are given in Fig. 3.1a,b. A second scan was always taken to check the absence of bulk substances. 

MTBE is a well known enhancer of the number of octanes in gasoline and as excellent oxygentated fuel additives that decrease carbon monoxide emissions. Therefore, MTBE has been one of the fastest growing chemicals of the past decade. MTBE is produced by reacting methanol with isobutylene from mixed-C4 stream liquid phase over a strong acid ion-exchange resin as catalyst. An excess of methanol is used in order to improve the reaction conversion. This excess has to be separated from the final product. The pervaporation technique, more energy efficient and with lower cost process, has been proposed as alternative to distillation [74],... 

---