Camphor, reaction with

The zinc complex of 1,1,1,5,5,5-hexafluoroacetylacetonate forms coordination polymers in reaction with either 2,5-bis(4-ethynylpyridyl)furan or l,2-bis(4-ethynylpyridyl)benzene. The X-ray crystal structures demonstrate an isotactic helical structure for the former and a syndio-tactic structure for the latter in the solid state. Low-temperature 1H and 19F NMR studies gave information on the solution structures of oligomers. Chiral polymers were prepared from L2Zn where L = 3-((trifluoromethyl)hydroxymethylene)-(+)-camphorate. Reaction with 2,5-bis(4-ethy-nylpyridyl)furan gave a linear zigzag structure and reaction with tris(4-pyridyl)methanol a homo-chiral helical polymer.479... 

The cyclized analog of meralluride is prepared by a similar synthesis. Thus, condensation of camphoric acid (42) (obtained by oxidation of camphor) with ammonia gives the bicyclic succinimide (44). Reaction with allyl isocyanate followed by ring opening and then reaction with mercuric acetate affords the mercury derivative (45) as the acetate rather than the hydroxide as above. Reaction with sodium chloride converts that acetate to the halide (46). Displacement on mercury with the disodium salt of thioglycollic acid affords the diuretic mercaptomerine (47). ... 

The most important group of derivatives for the amino function (Fig. 7-4) is the carbamate group, which can be formed by reactions with acids, acid chlorides or acid anhydrides. A series of chlorides as 2-chloroisovalerylchloride [1], chrysanthe-moylchloride [2] and especially chloride compounds of terpene derivatives (cam-phanic acid chloride [3], camphor-10-sulfonyl chloride [4]) are used. The a-methoxy-a-trifluoromethylphenylacetic acid or the corresponding acid chloride introduced by Mosher in the 1970s are very useful reagents for the derivatization of amines and alcohols [5]. 

Sulfinic esters, aromatic, by oxidation of disulfides in alcohols, 46, 64 Sulfonation ot d,l camphor to d,l-10-camphorsulfomc acid, 45,12 Sulfoxides, table of examples of preparation from sulfides with sodium metapenodate, 46,79 Sulfur dioxide, reaction with styrene phosphorus pentachlonde to give styrylphosphomc diclilonde, 46,... 

Corey and Chaykovsky were the first to investigate the reaction of dimethyl sulphoxide anion (dimsyl anion) with aldehydes and ketones400,401. They found that the reaction with non-enolizable carbonyl compounds results in the formation of /1-hydroxyalkyl sulphoxides in good yields (e.g. Ph2CO—86%, PhCHO—50%). However, with enolizable carbonyl compounds, particularly with cycloalkanones, poor yields of hydroxyalkyl products are observed (e.g. camphor—28%, cyclohexanone—17%, but... 

Kim B. H., Curran D. P. Asymmetric Thermal Reactions With Oppolzer s Camphor Sultam Tetrahedron 1992 49 293-318... 

In THF at -20°C the N-trimethylsilylated 2-pyrrolidinone 388 is converted by LDA into the a-anion which, on reaction with 1949 and subsequent acidification with AcOH, gives 43% 3-hydroxy-2-pyrrolidinone 1962 [150]. Lithium enolates of ketones such as camphor react with BTSP 1949 to give >95% of a mixture of exo-and mdo-2-hydroxycamphor [151]. Lithiated methyl heterocycles such as lithiated 2-methylpyridine 1963 are converted into mixtures of the 0-SiMe3 1964 and C-SiMe3 1965 compounds and C-methylated compounds such 1966 [152]. 2-Lithioto-luene 1967 is oxidized by 1949 into 1968 [140, 145] (Scheme 12.42). 

Scheme 1.33 Test reaction with (+ )-camphor-derived pyridine thioether ligand.

A rich family of 2-alkoxycarbonyl-l,3,2-oxazaphospholidine-2-oxides 179-181 was prepared from the reaction of camphor derived aminoalcohols 177 and 178 with either methoxycarbonyl phosphonic dichloride or ethyl dichlorophosphite followed by the reaction with methyl bromoacetate. The reaction with aminoalcohol 177a afforded the phosphorus epimers 179 and 180, in ratios from 1/1 to 12/1 depending on the iV-substituent which could be separated easily by column chromatography. The reaction with aminoalcohols 178a-c, however, gave a single epimer 181a-c in each case (Scheme 50) [81]. 

The reaction of camphor enolate with selenium in the presence of methyl iodide,19,20 followed by areal oxidation, affords 1,3-diselenetanes formed by dimerization of the putative selenoketone intermediate (Scheme 22). These... 

It is also possible to carry out a substrate-controlled reaction with aldehydes in an asymmetric way by starting with an acetylene bearing an optically active ester group, as shown in Eq. 9.8 [22]. The titanium—acetylene complexes derived from silyl propiolates having a camphor-derived auxiliary react with aldehydes with excellent diastereoselectivity. The reaction thus offers a convenient entry to optically active Baylis—Hillman-type allyl alcohols bearing a substituent (3 to the acrylate group, which have hitherto proved difficult to prepare by the Baylis—Hillman reaction itself. 

Asymmetric cyclopropanol formation has been achieved with olefmic acylsulfonamides, which act like olefmic esters. Thus, their reaction with 1 provides a method for synthesizing cyclopropanols in an optically active form. As represented by Eq. 9.41, alkylation of Oppolzer s camphor sultam and reaction of the resulting unsaturated acylsulfonamides with 1 provides optically active bicyclic cyclopropanols having exclusively the structure shown in the equation [76],... 

Tolman and co-workers (67) investigated a series of pyrazolyl-derived ligands for this reaction. Initial investigations centered on the use of tris(pyrazolyl) phosphine oxide (95) as a ligand with chirality derived from camphor. Diastereoselectivities with ethyl diazoacetate are poor, slightly favoring the cis isomer, and enantioselectivities are modest, Eq. 50. The BHT esters greatly increase the diastereoselectivity of this process (96 4) at the expense of enantioselectivity (10% ee for trans isomer). 

As reported by Steel et al. three structural isomers of bis(camphor-pyrazol-l-yl)methane (21a, 21b and 21c) are formed by coupling of camphorpyrazole 10 [i.e., (4S,7i )-7,8,8-trimethyl-4,5,6,7-tetrahydro-4,7-methano-l(2)H-indazole] with CH2CI2 (121). Isomer 21c can be separated from the other two structural isomers by crystallization or column chomatography. Deprotonation at the bridging carbon atom, subsequent reaction with carbon dioxide and acidic workup yields the enantiopure bis(camphorpyrazol-l-yl)acetic acid Hbpa (8) (Scheme 17, Fig. 19) (116). Due to missing substituents at the p5rrazolyl carbon C5 and a hence likely ortho metallation, isomers 21a and 21b are not suited for his reaction (72). 

In the presence of excess monoalkylamine, carbonyl compounds in aqueous solution are in equilibrium with the corresponding imine. In most cases these imines cannot be isolated but they are reduced at a less negative potential than the carbonyl compound. Selective reduction of such equilibrium mixtures is a useful route to alkylamines from ketones in yields of 70-90%. The process fails with hindered ketones such as camphor and with bulky amines such as fert.-butyl amine. Overall the reaction has advantages of lower costs and simpler work-up compared to the use of cyanoborohydride reducing agents. In the electrochemical reaction, protonation of carbanion intermediates occurs from the more hindered side and where two isomeric products are fomied, the least hindered amine predominates [193]. 

The camphor-derived chiral acrylate 160a was used in reactions with nitrones by Olsson (272) (Scheme 12.51). They observed low endo/exo-selectivity, but excellent diastereofacial discrimination in the reactions of cyclic nitrones with 160a. They also studied the reactions of nitrile oxides with 160a,b. Fair selectivity of up to 68-75% de was obtained. However, for the reaction of the crotonyl derivative 160b with nitrile oxides, mixtures of regiomers were obtained. 

The auxihary acrylates 161 and 162 have been used in 1,3-dipolar cycloadditions with nitrile oxides. The camphor-derived acrylate 161 underwent a 1,3-dipolar cycloaddition with benzonitrile oxide with up to 56% de (Scheme 12.51) (263). The auxiliary in acrylate 162 is derived from naturally occurring L-quebrachitol, and provided an effective shielding of the re-face of the alkene in the reaction with benzonitrile oxide, as 90% de was obtained (273). Compound 163 was used in a reaction with the nitrone 1-pyrrole-1-oxide, and the reaction proceeded to give a complex mixture of products (274). 

The a,p-unsaturated amides 180-188a have all been used in 1,3-dipolar cycloadditions with nitrile oxides, and some of them represent the most diastereoselective reactions of nitrile oxides. The camphor derivative 180 of Chen and co-workers (294), the sultam 181 of Oppolzer et al. (295), and the two Kemp s acid derived compounds 186 (296) and 187 (297) described by Curran et al. (296) are excellent partners for diastereoselective reactions with nitrile oxides, as very high diastereos-electivities have been observed for all of them. In particular, compound 186 gave, with few exceptions, complete diastereoselection in reactions with a wide range of different nitrile oxides. Good selectivities were also observed when using compounds 183 (298) and 184 (299-301) in nitrile oxide cycloadditions, and they have the advantage that they are more readily available. Curran and co-workers also studied the 1,3-dipolar cycloaddition of 187 with silyl nitronates. However, compared to the reactions of nitrile oxides, lower selectivities of up to 86% de were obtained (302). 

---