REDUCTIONS WITH BOROHYDRIDE

Sodium bisulphite reagent, 332 Sodium borohydride, reductions with, 881-882... 

Hyperforin is not reduced by sodium borohydride. Reduction with hydride-transfer reagents such as lithium aluminium hydride (LAH), RED-AL, and DIBAL-H, gave varied products in good yields. Its two dicarbonyl systems are amenable to reduction or deoxygenation upon treatment with alane reducing agents and pave the way to new and interesting modifications of the natural product.301... 

Blumenfeld and Gallop (1962b) have used lithium borohydride reduction, with subsequent chromatographic separation of the amino alcohols produced, to identify the carboxyl donor of the ester links previously found by Gallop et al. (1959) using hydroxylamine and hydrazine. The peaks obtained on the chromatogram for the two products in question, namely homoserine and /3-amino-7-hydroxybutyric acid, are very small, but nonetheless seem to establish that a- and /3-carboxyl groups of aspartic acid participate in the hydroxylamine-sensitive links. 

By modification of the reaction condition, biaryl lactones could be efficiently reduced to the corresponding biaryl products by this cobalt-catalyzed system. Various axially chiral biaryl compounds were obtained with high ee values (80-93% ee) by the atmpo-enantioselective borohydride reduction with the dynamic kinetic resolution of biaryl lactones in the presence of EtOH and l-(2-pyridinyl)ethanol (eq 39). 

Hydroboration attracted several theoretical studies in 1978. Publications which have appeared include an ab initio study of the reaction of BHs with ethylene, a CNDO/2 study of the nature of the ethylene-borane complex, the transition state in the hydroboration reaction, a MNDO study of hydroboration of alkenes and alkynes, and a MNDO study of hydroboration and borohydride reduction with implications concerning cyclic conjugation and pericyclic reactions. Finally, HaBCHO was one of the molecules which has been studied with regard to banana bonds of the carbonyl group. ... 

Direct Borohydride Reduction of Alcohols to Alkanes with Phosphonium Anhydride Activation N-Proovlbenzene. To a solution of 5.56 g (20 mmol) of triphenylphosphine oxide in 30mL of dry methylene chloride at CfC was added dropwise a solution of 1.57 mL (10 mmol) of triflic anhydride in 30mL of dry methylene chloride. After 15 min when the precipitate appeared, a solution of 1.36g (10 mmol) of 3-phenyl-1-propanol in 10 mL of dry methylene chloride was added and the precipitate vanished in 5 min. An amount of 1.5g (40 mmol) of sodium borohydride was added as a solid all at once and the slurry was stirred at room temperature for... 

The alkaline conditions of the reduction with aqueous sodium borohydride leads to competitive reactions of the OH nucleophile, but the product usually obtained from a thiazolium salt (195) is the corresponding thiazolidine (196). 

Sodium borohydride and lithium aluminum hydride react with carbonyl compounds in much the same way that Grignard reagents do except that they function as hydride donors rather than as carbanion sources Figure 15 2 outlines the general mechanism for the sodium borohydride reduction of an aldehyde or ketone (R2C=0) Two points are especially important about this process... 

Reduction to alcohols (Section 15 2) Aide hydes are reduced to primary alcohols and ketones are reduced to secondary alcohols by a variety of reducing agents Catalytic hydrogenation over a metal catalyst and reduction with sodium borohydride or lithium aluminum hydride are general methods... 

Nucleophilic addition to carbonyl groups sometimes leads to a mixture of stereoisomeric products The direction of attack is often controlled by stenc factors with the nude ophile approaching the carbonyl group at its less hindered face Sodium borohydride reduction of 7 7 dimethylbicyclo[2 2 IJheptan 2 one illustrates this point... 

Higher nitroalkanes are prepared from lower primary nitroalkanes by a one-pot synthesis (69). Successive condensations with aldehydes and acylating agents are followed by reduction with sodium borohydride. Overall conversions in the 75—80% range are reported. 

Reduction. Quinoline may be reduced rather selectively, depending on the reaction conditions. Raney nickel at 70—100°C and 6—7 MPa (60—70 atm) results in a 70% yield of 1,2,3,4-tetrahydroquinoline (32). Temperatures of 210—270°C produce only a slightly lower yield of decahydroquinoline [2051-28-7]. Catalytic reduction with platinum oxide in strongly acidic solution at ambient temperature and moderate pressure also gives a 70% yield of 5,6,7,8-tetrahydroquinoline [10500-57-9] (33). Further reduction of this material with sodium—ethanol produces 90% of /ra/ j -decahydroquinoline [767-92-0] (34). Reductions of the quinoline heterocycHc ring accompanied by alkylation have been reported (35). Yields vary widely sodium borohydride—acetic acid gives 17% of l,2,3,4-tetrahydro-l-(trifluoromethyl)quinoline [57928-03-7] and 79% of 1,2,3,4-tetrahydro-l-isopropylquinoline [21863-25-2]. This latter compound is obtained in the presence of acetone the use of cyanoborohydride reduces the pyridine ring without alkylation. 

A McMurry coupling of (176, X = O Y = /5H) provides ( )-9,ll-dehydroesterone methyl ether [1670-49-1] (177) in 56% yield. 9,11-Dehydroestrone methyl ether (177) can be converted to estrone methyl ether by stereoselective reduction of the C —double bond with triethyi silane in triduoroacetic acid. In turn, estrone methyl ether can be converted to estradiol methyl ether by sodium borohydride reduction of the C17 ketone (199,200). 

Synthesis. The parent compound, bora2iae [6569-51-3] is best prepared by a two-step process involving formation of B-trichlorobora2iQe followed by reduction with sodium borohydride. These reactions have been studied ia some detail (96). 

Recent papers by a manufacturer of sodium borohydride, NaBH (145,146), have demonstrated that excellent removal of metals and color of acid, direct, and reactive dyes for textiles and paper can be achieved with bisulfite-catalyzed borohydride reduction in combination with polymer flocculation. 

The least troublesome routes to 3,4-dihydro- and 1,2,3,4-tetrahydro-quinazoline are probably the reduction of quinazoline by sodium borohydride, in water for the former or in methanol for the latter. Both must be isolated as salts. The dihydroquinazoline may be formed also by reduction with LAH in ether (65JHC157). In contrast, 5,6,7,8-tetrahy-droquinazoline is best made by primary synthesis from 2-formylcyclohexanone and for-mamide (57CB942) or from cyclohexanone and trisformamidomethane (60CB1402). 

Few reactions of this type are recorded. The azidopyridazinone ester (349) on reduction with triethyl phosphite, hydrazine or borohydride furnished the pyrido[2,3-c]pyridazin-7-one (350) (79JHC1559), whilst an A-aminopyrido[2,3-c]pyridazine (352) resulted from the... 

The reduction of 3,5-diphenylisoxazoline with sodium cyanoborohydride produced a mixture of isomeric 3,5-diphenylisoxazolidines. The H and NMR spectra were utilized to distinguish the isomers SOLAIOI). Sodium borohydride reductions likewise reduce isoxazolines to isoxazolidines (equation 56) (80JA4265). 

Borohydride reduction of 3-aryl-l,2-benzisothiazole 1,1-dioxides gives the 2,3-dihydro compounds 73JMC1170). Reduction of either 2-methylsaccharin or 2-hydroxymethylsac-charin with lithium aluminum hydride gives the same product, iV-methyl-o-hydroxymethyl-benzenesulfonamide (73AHC(15)233). 

---