Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Boiling range distribution

Simulated Distillation of Bitumen Sample. The boiling-range distribution of the recovered bitumen was determined by simulated distillation gas-liquid chromatography using the procedure of Poulson et al. (15). Boiling points are determined by calibration with a mixture of n-paraffins ranging from Cn to C42. The upper limit for boiling point determination in this analysis is about 540°C (1000°F). [Pg.127]

Standard Method of Test for Boiling Range Distribution of Petroleum... [Pg.111]

Boiling Range Distribution. The distribution of boiling range was obtained by a simulated distillation procedure, using an automated GC equipped with a flame ionization detector (FID) using automatic data... [Pg.234]

ASTM D 2887 (2006) Standard test method for boiling range distribution of petroleum fractions by gas chromatography. (ASTM International). [Pg.225]

ASTM D2887-93. Boiling Range Distribution of Petroleum Fractions by Gas Chromatography. In Section 5 Annual Book of ASTM Standards, 1996 192-201. Conshohocken, PA. [Pg.671]

Thus one of the most important physical parameters is the boiling range distribution (ASTM D-86, ASTM D-1078, ASTM D-2887, ASTM D-2892, IP 123). The significance of the distillation test is the indication of volatility, which dictates the evaporation rate, an important property for naphtha used in coatings and similar applications where the premise is that the naphtha evaporates over time, leaving the coating applied to the surface. [Pg.101]

One of the most important physical parameters defining these products is their boiling range distribution, which can be determined using a low-efficiency, one-theoretical plate distillation procedure (ASTM D-86). This has been adequate for product specification purposes however, engineer-... [Pg.173]

Different crude oils contain different proportions of these classes of organic components and also vary in the boiling range distribution of their components. The main factors affecting crude oil selection for the manufacture of base oils are the following ... [Pg.8]

ISO 3924-99. Petroleum products - Determination of boiling range distribution - Gas chromatography method. [Pg.1071]

Standard Test Method for Purity of Methyl Ethyl Ketone by GC Standard Test Method for Boiling Range Distribution of Petroleum Fractions by GC... [Pg.174]

D3695 Standard Test Method for Volatile Alcohols in Water by Direct Aqueous-Injection GC D3710 Boiling Range Distribution of... [Pg.175]

Boiling Range Distribution of Non-fully Eluting Petroleum Fractions by GC... [Pg.178]

This is evident in Figure 2, which shows the relationship between boiling point (and the associated Noack volatility) for a basestock with a typical boiling range distribution versus kinematic viscosity. Each curve represents a class of lube hydrocarbons that have been assayed into fractions with viscosities spanning the typical lube range of 10 to 1000 cSt at 40°C... [Pg.81]

See other pages where Boiling range distribution is mentioned: [Pg.267]    [Pg.267]    [Pg.268]    [Pg.131]    [Pg.321]    [Pg.29]    [Pg.101]    [Pg.102]    [Pg.127]    [Pg.127]    [Pg.128]    [Pg.153]    [Pg.153]    [Pg.174]    [Pg.184]    [Pg.195]    [Pg.214]    [Pg.636]    [Pg.637]    [Pg.637]    [Pg.675]    [Pg.684]    [Pg.81]    [Pg.100]   
See also in sourсe #XX -- [ Pg.234 ]

See also in sourсe #XX -- [ Pg.637 ]



SEARCH



Boiling range

Range distributions

© 2024 chempedia.info