Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

ASTM ASTMD

For the above polyol blend viscosity (Brookfield, ASTM D-2196) = 1500 mPa-S at 23° C. For the reaction mixture working (pot) life 20 min Gardner circular dry times [72°F, 54% relative humidity (RH)] surface dry = 1.0 h, hard dry = 2.0 h, mar free = 3.5 h. For the finished coating gloss (ASTM D-523) = 90+ at 60° impact (ASTM D-2794) = 60 in.-lb direct, 10 in.-lb reverse Tabor abrasion (ASTMD-4060,1000 g load, 1000cycles, CS-17 wheel) = 95.6 mg pendulum hardness = 180 s MEK double rubs (ASTM D4752-95, 50 double rubs) = softened. [Pg.253]

ASTMD 635, Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Self-Supporting Plastics in a Horizontal Position, Annual Book ASTM Standards, American Society for Testing and Materials, West Conshohocken, PA. [Pg.665]

The specific gravity of product gases, including LPG, may be determined conveniently by a number of methods and a variety of instruments (ASTM D-1070,ASTMD-4891). [Pg.61]

Aromatic content is a key property of low-boiling distillates such as naphtha and gasoline because the aromatic constituents influence a variety of properties including boiling range (ASTM D-86, IP 123), viscosity (ASTM D-88,ASTMD-445,ASTM D-2161,IP71),stability (ASTMD-525, IP 40), and compatibility (ASTM D-1133) with a variety of solutes. [Pg.91]

ASTMD-2863 sponsor ASTM (LOl limiting oxygen index)... [Pg.250]

ASTMD-5033-90, Standard guide fOT development of ASTM standards relating to recycling and use of reeyeled plastics (2000)... [Pg.337]

American Society for Testing and Materials (ASTM) Specification. 1981. Piles under axial compressive load, ASTMD 1143, Part 19, Philadelphia, PA. [Pg.161]

Methods of Test for Impact Resistance of Plastics and Electrical Insulating Materials, ASTMD 256-54T, ASTM Standards, Part 6, p. 182 (1955). Also ASTM D-256-56, ASTM Standards 1956. American Society for Testing Materials, Baltimore, 1955 and 1956. [Pg.607]

ASTMD 1925 ASTM D1925-70 (1988) Test Method for Yellowness Index of Plastics (withdrawn 1995, no replacement)... [Pg.1377]

ASTMD 3257-06(2012). Standard test methods for aromatics in mineral spirits by gas chromatography. ASTM D 1685-05. Standard test method for traces of thiophene in benzene by spectrophotometry. Withdrawn 2009. [Pg.286]

Component Type NLGI No. Minimum ASTMD 217-68 Minimum ASTM D566-76 Corrosion Test... [Pg.450]

See other pages where ASTM ASTMD is mentioned: [Pg.243]    [Pg.54]    [Pg.262]    [Pg.453]    [Pg.909]    [Pg.85]    [Pg.197]    [Pg.198]    [Pg.131]    [Pg.114]   
See also in sourсe #XX -- [ Pg.69 , Pg.472 ]



SEARCH



ASTM

ASTMD

© 2024 chempedia.info