Applications traction, secondary

By far the largest sector of the battery industry worldwide is based on the lead-acid aqueous cell whose dominance is due to a combination of low cost, versatility and the excellent reversibility of the electrochemical system, Lead-acid cells have extensive use both as portable power sources for vehicle service and traction, and in stationary applications ranging from small emergency supplies to load levelling systems. In terms of sales, the lead-acid battery occupies over 50% of the entire primary and secondary market, with an estimated value of 100 billion per annum before retail mark-up. 

The manufacture of secondary batteries based on aqueous electrolytes forms a major part of the world electrochemical industry. Of this sector, the lead-acid system (and in particular SLI power sources), as described in the last chapter, is by far the most important component, but secondary alkaline cells form a significant and distinct commercial market. They are more expensive, but are particularly suited for consumer products which have relatively low capacity requirements. They are also used where good low temperature characteristics, robustness and low maintenance are important, such as in aircraft applications. Until recently the secondary alkaline industry has been dominated by the cadmium-nickel oxide ( nickel-cadmium ) cell, but two new systems are making major inroads, and may eventually displace the cadmium-nickel oxide cell - at least in the sealed cell market. These are the so-called nickel-metal hydride cell and the rechargeable zinc-manganese dioxide cell. There are also a group of important but more specialized alkaline cell systems which are in use or are under further development for traction, submarine and other applications. 

Those applications in which the secondary battery is discharged (similar in use to a primary battery) and recharged after use, either in the equipment in which it was discharged or separately. Secondary batteries are used in this manner for convenience, for cost savings (as they can be recharged rather than replaced), or for power drains beyond the capability of primary batteries. Most consumer electronics, electric-vehicle, traction, industrial truck, and some stationary battery applications fall in this category. 

---