Angle of inclination

In Fig. 3a,b are shown respectively the modulus of the measured magnetic induction and the computed one. In Fig. 3c,d we compare the modulus and the Lissajous curves on a line j/ = 0. The results show a good agreement between simulated data and experimental data for the modulus. We can see a difference between the two curves in Fig. 3d this one can issue from the Born approximation. These results would be improved if we take into account the angle of inclination of the sensor. This work, which is one of our future developpements, makes necessary to calculate the radial component of the magnetic field due to the presence of flaw. This implies the calculation of a new Green s function. 

Customarily, it is assumed that e is unity and that ]l = p,cos 9, where 0 is the angle of inclination of the dipoles to the normal. Harkins and Fischer [86] point out the empirical nature of this interpretation and prefer to consider only that AV is proportional to the surface concentration F and that the proportionality constant is some quantity characteristic of the film. This was properly cautious as there are many indications that the surface of water is structured and that the structure is altered by the film (see Ref. 37). Accompanying any such structural rearrangement of the substrate at the surface should be a change in its contribution to the surface potential so that AV should not be assigned too literally to the film molecules. 

A typical belt conveyor arrangement is shown in Eigure 1. These conveyors can be arranged horizontally and with inclined or declined sections combined with convex and concave curves. The desired path of travel is limited only by the strength of the belt and the permissible angle of incline or decline for the particular situation. 

The area that is theoretically available for separation is equal to the sum of the projected areas or all channels on the horizontal plane. Figure 18-88 shows the horizontally projected area A, of a single channel in a clarifier of unit width. If X is the uniform distance between plates (measured perpendicularly to the plate surface), the clarifier will contain sin Ci/X channels per unit length and an effective collection area per unit clarifier length of A, sin O/X, where Ot is the angle of inclination of the plates to the horizontal. It follows that the total horizontally projected plate area per unit volume of sludge in the clarifier Aj is... 

In the oscillating screen the angle of inclination must be coordinated with the speed and stroke for best results. 

G = mass flux V = specific volume of stream P = stream pressure f= friction factor D = duct diameter L = flow length g = acceleration due to gravity b = angle of inclination from vertical... 

Fall-werk, n. drop machine stamp pile driver. -wiokel, m. angle of inclination angle of fall, -ziinder, m. percussion fuse. 

Neigungs-ebene,/, inclined plane, -messer, m. clinometer inclinometer, -winkel, m. angle of inclination, nein, interj, no. 

It is more convenient to use the procedure of the first kind for higher drawn fibers (over 350% of elongation) and the second procedure for fibers of smaller drawing. The value of the angle of inclination of the texture depends on the magnitude of the drawing applied. As a result of the investigations of one of the authors... 

Angle of inclination (angle of drift) The angle, in degrees, taken at one or at several points of variation from the vertical as revealed by a deviation survey sometimes called the inclination or angle of deviation. 

Build-and-hold wellbore A wellbore configuration where the inclination is increased to some terminal angle of inclination and maintained at that angle to the specified target. 

When the filming amine condenses, the hydrophilic polar radical of the molecule (the head) adsorbs onto the metal surface and the hydrophobic, long chain (the tail) is directed at a 90° angle of inclination away from the metal surface. Provided the feed rate is adequate, the critical concentration is eventually reached and a continuous monomolecular surface film is formed. At this stage, the physical size of the interstices between the polar groups is smaller than the molecules of water, carbon dioxide, or oxygen, and these molecules are thus physically prevented from reaching the metal surface. 

If B is the angle of inclination of the manometer (typically about 10-20°) and L is the movement of the column of liquid along the limb, then ... 

For adiabatic, steady-state, and developed gas-liquid two-phase flow in a smooth pipe, assuming immiscible and incompressible phases, the essential variables are pu, pG, Pl, Pg, cr, dh, g, 9, Uls, and Uas, where subscripts L and G represent liquid and gas (or vapor), respectively, p is the density, p is the viscosity, cr is the surface tension, dh is the channel hydraulic diameter, 9 is the channel angle of inclination with respect to the gravity force, or the contact angle, g is the acceleration due to gravity, and Uls and Ugs are the liquid and gas superficial velocities, respectively. The independent dimensionless parameters can be chosen as Ap/pu (where Ap = Pl-Pg), and... 

Fig. 6. Comparison of the responses of two grasses of contrasted growth rate and morphology to five intensities of shoot impedance, (a) Lolium perenne b) Festuca ovina. Each curve records the mean progress of shoot expansion in five replicate plants subjected to standardised resistances (indicated on each curve as the force in newtons required for initial deflection of weighted windows). Plants were grown individually within a transparent cone, from which the shoots, in order to escape, must deflect windows of standard dimensions and angle of inclination.

Sedimentation of particles follows the principle outlined above [Eq. (1)] in which particles in the Stokes regime of flow have attained terminal settling velocity. In the airways this phenomenon occurs under the influence of gravity. The angle of inclination, t /, of the tube of radius R, on which particles might impact, must be considered in any theoretical assessment of sedimentation [14,19]. Landahl s expression for the probability, S, of deposition by sedimentation took the form ... 

This equation can be derived from the laws of physics, in which case the parameteers a and b can be related to such factors as the muzzle velocity, projectile mass, angle of inclination of the gun, and wind resistance. The equation may also be empirical if measured values of z versus x are related by an equation of this form, with no reference to the laws of physics. 

Carbon tetrachloride (SG = 1.6) is pumped at a rate of 2 gpm through a pipe that is inclined upward at an angle of 30°. An inclined tube manometer (with a 10° angle of inclination) using mercury as the manometer fluid (SG = 13.6) is connected between two taps on the pipe that are 2 ft apart. The manometer... 

The character of the pattern does not alter when the angle of inclination of the specimen to the beam is changed. Thus the geometry of a polycrystalline pattern is a set of lengths, Hhki, i.e. set of inter-planar distances dhki characteristic of the crystal lattice. Polycrystal-type electron diffraction patterns provided a complete three dimensional set of diffraction reflections, however, two or more reflections, with different hkl can overlap in one ring of the pattern, especially in the cases where the material studied has large lattice parameters. 

Thompson and Wilson [78] operated a 21-L air-lift perfusion reactor coupled to an external lamella settler. The sedimentation device bearing an angle of inclination of 30° to the vertical was maintained at 37°C. They found a reasonable agreement between the theoretical and experimental values of breakthrough for viable and nonviable cells in the harvest stream. As expected (see Eq. 8), the maximum perfusion rates increased with an increasing settling area. 

---