Allylic compounds catalytic reactions

Cleavage of the C-O bond in various allylic substrates by oxidative addition to M(0) species gives r 3-allylic complexes, which undergo nucleophilic attack to produce allylic compounds catalytically. A base is needed in most cases to remove HOX and to drive the catalytic cycle. There are a lot of synthetic reactions utilizing allylic oxygen bond cleavage catalyzed by palladium complexes [6, 7, 19-21]. 

TT-Aliylpalladium chloride reacts with a soft carbon nucleophile such as mal-onate and acetoacetate in DMSO as a coordinating solvent, and facile carbon-carbon bond formation takes place[l2,265], This reaction constitutes the basis of both stoichiometric and catalytic 7r-allylpalladium chemistry. Depending on the way in which 7r-allylpalladium complexes are prepared, the reaction becomes stoichiometric or catalytic. Preparation of the 7r-allylpalladium complexes 298 by the oxidative addition of Pd(0) to various allylic compounds (esters, carbonates etc.), and their reactions with nucleophiles, are catalytic, because Pd(0) is regenerated after the reaction with the nucleophile, and reacts again with allylic compounds. These catalytic reactions are treated in Chapter 4, Section 2. On the other hand, the preparation of the 7r-allyl complexes 299 from alkenes requires Pd(II) salts. The subsequent reaction with the nucleophile forms Pd(0). The whole process consumes Pd(ll), and ends as a stoichiometric process, because the in situ reoxidation of Pd(0) is hardly attainable. These stoichiometric reactions are treated in this section. 

Several Pd(0) complexes are effective catalysts of a variety of reactions, and these catalytic reactions are particularly useful because they are catalytic without adding other oxidants and proceed with catalytic amounts of expensive Pd compounds. These reactions are treated in this chapter. Among many substrates used for the catalytic reactions, organic halides and allylic esters are two of the most widely used, and they undergo facile oxidative additions to Pd(0) to form complexes which have o-Pd—C bonds. These intermediate complexes undergo several different transformations. Regeneration of Pd(0) species in the final step makes the reaction catalytic. These reactions of organic halides except allylic halides are treated in Section 1 and the reactions of various allylic compounds are surveyed in Section 2. Catalytic reactions of dienes, alkynes. and alkenes are treated in other sections. These reactions offer unique methods for carbon-carbon bond formation, which are impossible by other means. 

Reaction Patterns and Various Allylic Compounds Used for Catalytic Reactions... 

In addition, a catalytic version of Tt-allylpalladium chemistry has been devel-oped[6,7]. Formation of the Tr-allylpalladium complexes by the oxidative addition of various allylic compounds to Pd(0) and subsequent reaction of the complex with soft carbon nucleophiles are the basis of catalytic allylation. After the reaction, Pd(0) is reformed, and undergoes oxidative addition to the allylic compounds again, making the reaction catalytic.-In addition to the soft carbon nucleophiles, hard carbon nucleophiles of organometallic compounds of main group metals are allylated with 7r-allylpalladium complexes. The reaction proceeds via transmetallation. These catalytic reactions are treated in this chapter. 

In addition to the catalytic allylation of carbon nucleophiles, several other catalytic transformations of allylic compounds are known as illustrated. Sometimes these reactions are competitive with each other, and the chemo-selectivity depends on reactants and reaction conditions. 

Mainly allylic esters are used as the substrates for the catalytic reactions. In addition, the allylic compounds shown are known to react with Pd(0) to form TT-allylpalladium complexes. Even allylic nitro compounds[8,9] and sul-fones[KM2] are used for the allylation. The reactivities of these allylic compounds arc very different. 

The following conclusions can be drawn (a) ir-Allylnickel compounds are probably not involved in the catalytic dimerization of cyclooctene, because the highest reaction rate occurs when only traces of these compounds can be detected further, the concentration of the new 7r-allyl-nickel compound (19) becomes significant only after the catalytic reaction has ceased, (b) The complex formed between the original 7r-allylnickel compound (11) and the Lewis acid is transformed immediately upon addition of cyclooctene to the catalytically active nickel complex or complexes. In contrast to 7r-allylnickel compounds, this species decomposes to give metallic nickel on treatment of the catalyst solution with ammonia, (c) The transformation of the catalytically active nickel complex to the more stable 7r-allylnickel complex occurs parallel with the catalytic dimerization reaction. This process is obviously of importance in stabilizing the catalyst system in the absence of reactive olefins. In... 

Some synthetically useful isomerization reactions of alkenes, other than nitrogen- or oxygen-substituted allylic compounds, were reported by the use of a catalytic amount of transition metal complexes. The palladium complex, /ra r-Pd(C6HsCN)2Gl2, effectively catalyzed the stereoselective isomerization of /3,7-unsaturated esters to a,/3-unsaturated esters (Equation (26)). 

In the Pd-catalyzed cross-coupling reactions of acylzirconocene chlorides with allylic halides and/or acetates (Section 5.4.4.4), the isolation of the expected p,y-unsaturated ketone is hampered by the formation of the a, P-un saturated ketone, which arises from isomerization of the p,y-double bond. This undesirable formation of the unsaturated ketone can be avoided by the use of a Cu(I) catalyst instead of a Pd catalyst [35], Most Cu(I) salts, with the exception of CuBr - SMe2, can be used as efficient catalysts Thus the reactions of acylzirconocene chlorides with allyl compounds (Table 5 8 and Scheme 5 30) or propargyl halides (Table 5.9) in the presence of a catalytic amount (10 mol%) of Cu(I) in DMF or THF are completed within 1 h at 0°C to give ffie acyl--allyl or acyl-allenyl coupled products, respectively, in good yields. ill... 

The Simmons-Smith reaction " and its variants are widely used for the stereospecific synthesis of cyclopropane compounds. The methodology involves the use of copper-treated zinc metal (the zinc-copper couple) with diiodomethane to add methylene to a carbon-carbon double bond. Alternative use of diazomethane in catalytic reactions does not offer the same synthetic advantages and is usually avoided because of safety considerations. As significant as is the Simmons-Smith reaction for cyclopropane formation, its employment for organic synthesis was markedly advanced by the discovery that allylic and homoallylic hydroxyl groups accelerate and exert stereochemical control over cyclopropanation of alkenes (e.g, Eq. 21), and this acceleration has been explained by a transition state model... 

Hiyama and coworkers produced the same allylation compounds via the in situ reaction of l,l-difluoro-3-(dimethylphenylsilyl)propene and aldehydes with catalytic tris(diethyl-aminojsulfonium difluorotrimethylsilicate (TASF) or potassium f-butoxide (equation 85)78-79. 

With respect to the large number of unsaturated diazo and diazocarbonyl compounds that have recently been used for intramolecular transition metal catalyzed cyclopropanation reactions (6-8), it is remarkable that 1,3-dipolar cycloadditions with retention of the azo moiety have only been occasionally observed. This finding is probably due to the fact that these [3 + 2]-cycloaddition reactions require thermal activation while the catalytic reactions are carried out at ambient temperature. /V-Allyl carboxamides appear to be rather amenable to intramolecular cycloaddition. Compounds 254-256 (Scheme 8.61) cyclize intra-molecularly even at room temperature. The faster reaction of 254c (310) and diethoxyphosphoryl-substituted diazoamides 255 (311) as compared with diazoacetamides 254a (312) (x1/2 25 h at 22 °C) and 254b (310), points to a LUMO (dipole) — HOMO(dipolarophile) controlled process. The A -pyrazolines expected... 

Allyl alcohols can be produced catalytically by oxidation of alkenes with TBHP in the presence of small amounts of Se02 (equation 128). In contrast to the stoichiometric reaction, this catalytic oxidation can be performed under mild conditions (r.t., CH2C12 solvent).356 Alkynic compounds undergo a predominant allylic dihydroxylation upon reaction with TBHP/CH2C12 (equation 129) 357... 

Although this catalytic reaction appeared to be of synthetic interest, it has since then neither been applied in synthesis nor further developed. This might be attributed in part to problems with reproducibility and catalyst stability under the reaction conditions, although the Hieber complex was used in a stoichiometric manner for the preparation of a variety of 7i-allyl-Fe complexes. These latter compounds served as starting materials for a plethora of subsequent reactions [34]. The results obtained by Nakanishi and coworkers on the stability and reactivity of n-allyl-Fe-nitrosyl complexes proved such intermediates to be reactive towards a variety of nucleophiles however, the Fe complexes formed upon nucleophilic substitution were catalytically inactive. Hence, in order to maintain the catalytic activity, the formation of intermediate 7i-allyl-Fe complexes had to be circumvented. About 3 years ago we started our research in this field and envisioned the use of a monodentate ligand to be a suitable way to stabilize the proposed catalytically active G-allyl complex. The replacement of one CO by a non-volatile basic ligand was thought to prevent the formation of the catalytically inactive 7t-allyl-Fe complex (Scheme 7.21). 

Both stoichiometric and catalytic reactions of allylic compounds via 7r-allyl complexes are known. Reactions of nucleophilic 71-allyl complexes with electrophiles involve oxidation of metals and hence constitutes stoichiometric reactions. 7i-Allyl complexes of Ni, Fe, Mo, Co and others are nucleophilic and undergo the stoichiometric reaction with electrophiles. However, electrophilic 71-allyl complexes react with nucleophiles, accompanying reduction of metals. For example, 71-allylnickel chloride (2) reacts with electrophiles such as aldehydes, generating Ni(II), and hence the reaction is stoichiometric. In contrast, electrophilic 7i-allylpalladium chloride (3) reacts with nucleophiles such as malonate and Pd(0) is generated. Thus repeated oxidative addition of allylic compounds to Pd(0) constitutes a catalytic reaction. 

The stoichiometric reactions of allylic compounds is treated in Section 4.2, and the more useful catalytic reactions are treated in Section 4.3. 

A number of allylic leaving groups shown in Scheme 4.2 are cleaved by Pd catalysts. Mainly allylic esters are used as substrates for the catalytic reactions. In addition, even allylic nitro compounds [29,30] and sulfones [31-33] are known to form 7r-allylpalladium complexes. 

---