Alkali solvated

Solutions of alkali metals in liquid ammonia are used in organic chemistry as reducing agents. The deep blue solutions effectively contain solvated electrons (p. 126), for example... 

Oxygen chelates such as those of edta and polyphosphates are of importance in analytical chemistry and in removing Ca ions from hard water. There is no unique. sequence of stabilities since these depend sensitively on a variety of factors where geometrical considerations are not important the smaller ions tend to form the stronger complexes but in polydentate macrocycles steric factors can be crucial. Thus dicyclohexyl-18-crown-6 (p. 96) forms much stronger complexes with Sr and Ba than with Ca (or the alkali metals) as shown in Fig. 5.6. Structural data are also available and an example of a solvated 8-coordinate Ca complex [(benzo-l5-crown-5)-Ca(NCS)2-MeOH] is shown in Fig. 5.7. The coordination polyhedron is not regular Ca lies above the mean plane of the 5 ether oxygens... 

Chemical reduction by alkali metals leads to solid fullerides which are sometimes solvated. 

Alkali metals in liquid ammonia can transfer an electron to the solvent, leading to so-called solvated electrons. These can add to the aromatic substrate 1 to give a reduced species, the radical anion 3 ... 

The theory of the structure of ice and water, proposed by Bernal and Fowler, has already been mentioned. They also discussed the solvation of atomic ions, comparing theoretical values of the heats of solvation with the observed values. As a result of these studies they came to the conclusion that at room temperature the situation of any alkali ion or any halide ion in water was very similar to that of a water molecule itself— namely, that the number of water molecules in contact with such an ion was usually four. At any rate the observed energies were consistent with this conclusion. This would mean that each atomic ion in solution occupies a position which, in pure water, would be occupied by a water moldfcule. In other words, each solute particle occupies a position normally occupied by a solvent particle as already mentioned, a solution of this kind is said to be formed by the process of one-for-one substitution (see also Sec. 39). 

Solution of alkali metals in liquid ammonia, containing the so-called solvating electrons, may be used as an alternative homogeneous system to initiate polymerization by an electron transfer process. This system suffers, however, from complications resulting from proton transfer from ammonia leading to the formation of NH2- ions, which in turn initiate further polymerization.4... 

Whereas the electrochemical decomposition of propylene carbonate (PC) on graphite electrodes at potentials between 1 and 0.8 V vs. Li/Li was already reported in 1970 [140], it took about four years to find out that this reaction is accompanied by a partially reversible electrochemical intercalation of solvated lithium ions, Li (solv)y, into the graphite host [64], In general, the intercalation of Li (and other alkali-metal) ions from electrolytes with organic donor solvents into fairly crystalline graphitic carbons quite often yields solvated (ternary) lithiated graphites, Li r(solv)yC 1 (Fig. 8) [7,24,26,65,66,141-146],... 

It is now well established that in lithium batteries (including lithium-ion batteries) containing either liquid or polymer electrolytes, the anode is always covered by a passivating layer called the SEI. However, the chemical and electrochemical formation reactions and properties of this layer are as yet not well understood. In this section we discuss the electrode surface and SEI characterizations, film formation reactions (chemical and electrochemical), and other phenomena taking place at the lithium or lithium-alloy anode, and at the Li. C6 anode/electrolyte interface in both liquid and polymer-electrolyte batteries. We focus on the lithium anode but the theoretical considerations are common to all alkali-metal anodes. We address also the initial electrochemical formation steps of the SEI, the role of the solvated-electron rate constant in the selection of SEI-building materials (precursors), and the correlation between SEI properties and battery quality and performance. 

Alkali and alkaline-earth metals have the most negative standard reduction potentials these potentials are (at least in ammonia, amines, and ethers) more negative than that of the solvated-electron electrode. As a result, alkali metals (M) dissolve in these highly purified solvents [9, 12] following reactions (1) and (2) to give the well-known blue solutions of solvated electrons. 

These reactions proceed to equilibrium when the potential of the solvated-electron electrode equals that of the alkali metal L13] ... 

PEO is found to be an ideal solvent for alkali-metal, alkaline-earth metal, transition-metal, lanthanide, and rare-earth metal cations. Its solvating properties parallel those of water, since water and ethers have very similar donicites and polarizabilities. Unlike water, ethers are unable to solvate the anion, which consequently plays an important role in polyether polymer-electrolyte formation. 

The alkali metals also release their valence electrons when they dissolve in liquid ammonia, but the outcome is different. Instead of reducing the ammonia, the electrons occupy cavities formed by groups of NH3 molecules and give ink-blue metal-ammonia solutions (Fig. 14.14). These solutions of solvated electrons (and cations of the metal) are often used to reduce organic compounds. As the metal concentration is increased, the blue gives way to a metallic bronze, and the solutions begin to conduct electricity like liquid metals. 

In Chapter 3, we saw that cryptands specifically solvate the alkali metal portion of salts like KF, KOAc, and so on. Synthetic advantage can be taken of this fact to allow anions to be freer, thus increasing the rates of nucleophilic substitutions and other reactions (see p. 455). 

The nonnuclear chemistry of Fr reduces to studies of coprecipitation in which Fr shows the behavior of the heavier alkali metal. Coprecipitation is followed by ion exchange to concentrate Fr Physical (mp, density, crystal parameters) and chemical (thermodynamics, solvation entropies) properties are theoretically derived or extrapolated from the trends exhibited by the other alkali metals. 

Mass spectrometry has been used to study the energetics of solvation and has shown that the enthalpies of attachment of successive water molecules to either alkali metal or halide ions become less exothermic as the number of water molecules increases (Kebarle, 1977). The Gibbs free energies of attachment for water molecules have also been found to be negative. 

In almost all theoretical studies of AGf , it is postulated or tacitly understood that when an ion is transferred across the 0/W interface, it strips off solvated molecules completely, and hence the crystal ionic radius is usually employed for the calculation of AGfr°. Although Abraham and Liszi [17], in considering the transfer between mutually saturated solvents, were aware of the effects of hydration of ions in organic solvents in which water is quite soluble (e.g., 1-octanol, 1-pentanol, and methylisobutyl ketone), they concluded that in solvents such as NB andl,2-DCE, the solubility of water is rather small and most ions in the water-saturated solvent exist as unhydrated entities. However, even a water-immiscible organic solvent such as NB dissolves a considerable amount of water (e.g., ca. 170mM H2O in NB). In such a medium, hydrophilic ions such as Li, Na, Ca, Ba, CH, and Br are selectively solvated by water. This phenomenon has become apparent since at least 1968 by solvent extraction studies with the Karl-Fischer method [35 5]. Rais et al. [35] and Iwachido and coworkers [36-39] determined hydration numbers, i.e., the number of coextracted water molecules, for alkali and alkaline earth metal... 

In solutions neither H+ nor e can exist in a free state they will be donated only if they are accepted within the solution, e.g., by another acceptor, which may be the solvent and thus cause solvation here the mere solvation of electrons is an exceptional case, but may occur, e.g., in liquid ammonia, where according to Kraus82 the strongly reducing alkali metals dissolve while dissociating into cations M+ and solvated electrons e, which, however, are soon converted into NH2" and H2 gas. Further, from the analogy with acid-base reactions and the definition of... 

On the other hand, anions formed by the ring cleavage of octaphenylcyclotetrasilane may be very unreactive due to steric hindrances as well as to the formation of the tight silyl ion pair with alkali metals. We have attempted to decrease these interactions by using cryptands in order to better solvate the alkali metals and form the loose,... 

---