Aldehyde lithium enolates aldol reaction

The foregoing results clearly constitute an encouraging lead, and represent the best that has yet been done with chiral auxiliaries for lithium enolate aldol reactions. Although the chiral auxiliary is not covalently attached to either reactant, it is still used stoichiometrically. Furthermore, the process has only been demonstrated with the aldol reaction in equation (133). It will be interesting to see if the efficacy of this method will extend to other enolates and aldehydes. 

Besides their application in asymmetric alkylation, sultams can also be used as good chiral auxiliaries for asymmetric aldol reactions, and a / -product can be obtained with good selectivity. As can be seen in Scheme 3-14, reaction of the propionates derived from chiral auxiliary R -OH with LICA in THF affords the lithium enolates. Subsequent reaction with TBSC1 furnishes the 0-silyl ketene acetals 31, 33, and 35 with good yields.31 Upon reaction with TiCU complexes of an aldehyde, product /i-hydroxy carboxylates 32, 34, and 36 are obtained with high diastereoselectivity and good yield. Products from direct aldol reaction of the lithium enolate without conversion to the corresponding silyl ethers show no stereoselectivity.32... 

Paterson et al. achieved the convergent synthesis of the immunosuppressive agent discodermolide 205 by using a lithium-mediated aldol reaction with a chiral aldehyde (Scheme 8.31). The 2,6-dimethylphenyl ester 200 was derived to -enolate 201 by employing lithium 2,2,6,6-... 

Stereoselectivities of 99% are also obtained by Mukaiyama type aldol reactions (cf. p. 58) of the titanium enolate of Masamune s chired a-silyloxy ketone with aldehydes. An excess of titanium reagent (s 2 mol) must be used to prevent interference by the lithium salt formed, when the titanium enolate is generated via the lithium enolate (C. Siegel, 1989). The mechanism and the stereochemistry are the same as with the boron enolate. 

In contrast, fluorinated ketones have been used as both nucleophilic and electrophilic reaction constituents The (Z)-lithium enolate of 1 fluoro 3,3-di-methylbutanone can be selectively prepared and undergoes highly diastereoselec-tive aldol condensations with aldehydes [7] (equation 8) (Table 4)... 

In general the reaction of an aldehyde with a ketone is synthetically useful. Even if both reactants can form an enol, the a-carbon of the ketone usually adds to the carbonyl group of the aldehyde. The opposite case—the addition of the a-carbon of an aldehyde to the carbonyl group of a ketone—can be achieved by the directed aldol reaction The general procedure is to convert one reactant into a preformed enol derivative or a related species, prior to the intended aldol reaction. For instance, an aldehyde may be converted into an aldimine 7, which can be deprotonated by lithium diisopropylamide (EDA) and then add to the carbonyl group of a ketone ... 

Transmetalation of lithium enolate 1 a (M = Li ) by treatment with tin(II) chloride at — 42 °C generates the tin enolate that reacts with prostereogenic aldehydes at — 78 °C to preferentially produce the opposite aldol diastereomer 3. Diastereoselectivities of this process may be as high as 97 3. This reaction appears to require less exacting conditions since similar results are obtained if one or two equivalents of tin(ll) chloride arc used. The somewhat less reactive tin enolate requires a temperature of —42 C for the reaction to proceed at an acceptable rate. The steric requirements of the tin chloride counterion are probably less than those of the diethyla-luminum ion (vide supra), which has led to the suggestion26 44 that the chair-like transition state I is preferentially adopted26 44. This is consistent with the observed diastereoselective production of aldol product 3, which is of opposite configuration at the / -carbon to the major product obtained from aluminum enolates. 

In contrast, transmetalation of the lithium enolate at —40 C by treatment with one equivalent of copper cyanide generated a species 10b (M = Cu ) that reacted with acetaldehyde to selectively provide a 25 75 mixture of diastereomers 11 and 12 (R = CH3) which are separable by chromatography on alumina. Other diastereomers were not observed. Similar transmetalation of 10a (M = Li0) with excess diethylaluminum chloride, followed by reaction with acetaldehyde, produced a mixture of the same two diastereomers, but with a reversed ratio (80 20). Similar results were obtained upon aldol additions to other aldehydes (see the following table)49. 

Alternatively, Cushman has devised a facile route to pyrroles by the reaction of Boc-a-amino aldehydes or ketones 14 with the lithium enolates of ketones 15 to afford aldol intermediates 16 which cyclize to pyrroles 17 under mild acidic conditions <96JOC4999>. This method offers several advantages over the Knorr since it employs readily available Boc-a-amino aldehydes or ketones and utilizes simple ketones instead of the p-diketo compounds or p-keto esters normally used in the Knorr. 

Aldol Reactions of Lithium Enolates. Entries 1 to 4 in Scheme 2.1 represent cases in which the nucleophilic component is a lithium enolate formed by kinetically controlled deprotonation, as discussed in Section 1.1. Lithium enolates are usually highly reactive toward aldehydes and addition occurs rapidly when the aldehyde is added, even at low temperature. The low temperature ensures kinetic control and enhances selectivity. When the addition step is complete, the reaction is stopped by neutralization and the product is isolated. 

In the presence of zinc chloride, stereoselective aldol reactions can be carried out. The aldol reaction with the lithium enolate of /-butyl malonate and various a-alkoxy aldehydes gave anti-l,2-diols in high yields, and 2-trityloxypropanal yielded the syn-l,2-diol under the same conditions.633 Stoichiometric amounts of zinc chloride contribute to the formation of aminoni-tropyridines by direct amination of nitropyridines with methoxyamine under basic conditions.634 Zinc chloride can also be used as a radical initiator.635... 

Compound 17 is the so-called (+)-Prelog-Djerassi lactonic acid derived via the degradation of either methymycin or narbomycin. This compound embodies important architectural features common to a series of macrolide antibiotics and has served as a focal point for the development of a variety of new stereoselective syntheses. Another preparation of compound 17 is shown in Scheme 3-7.11 Starting from 8, by treating the boron enolate with an aldehyde, 20 can be synthesized via an asymmetric aldol reaction with the expected stereochemistry at C-2 and C-2. Treating the lithium enolate of 8 with an electrophile affords 19 with the expected stereochemistry at C-5. Note that the stereochemistries in the aldol reaction and in a-alkylation are opposite each other. The combination of 19 and 20 gives the final product 17. 

Covalently bonded chiral auxiliaries readily induce high stereoselectivity for propionate enolates, while the case of acetate enolates has proved to be difficult. Alkylation of carbonyl compound with a novel cyclopentadienyl titanium carbohydrate complex has been found to give high stereoselectivity,44 and a variety of ft-hydroxyl carboxylic acids are accessible with 90-95% optical yields. This compound was also tested in enantioselective aldol reactions. Transmetalation of the relatively stable lithium enolate of t-butyl acetate with chloro(cyclopentadienyl)-bis(l,2 5,6-di-<9-isopropylidene-a-D-glucofuranose-3-0-yl)titanate provided the titanium enolate 66. Reaction of 66 with aldehydes gave -hydroxy esters in high ee (Scheme 3-23). 

The next step to erythronolide A is the coupling of fragments A and B. Asymmetric aldol reaction of aldehyde 2 with a lithium enolate generated from... 

Aldol reactions of 1 and 2 can be used to obtain any one of the four possible stereoisomers of a,3-dihydroxy esters.3 Thus 1 reacts with aldehydes to provide (2S)-aldols, and 2 reacts to provide (2R)-aldols. The syn/anti ratio of the aldols can be controlled by the choice of the enolate counterion. Thus lithium or magnesium enolates provide mainly an/i-aldols, whereas 5yn-aldols predominate with zirconium enolates. Ethanolysis of the purified adducts yields the optically pure a,p-dihydroxy esters without epimerization with recovery of 8-phenylmenthol. 

Murai and coworkers reported on operationally simple aldol reactions with lithium enolates generated from carbonylation of silylmethyl lithium species [57]. Upon 1,2-silicon shift, a-silyl acyllithium species can be stereo-selectively converted to (E) lithium enolates that undergo addition to aldehydes to give /3-hydroxy acylsilanes (Scheme 14). 

Our second approach involved condensation of the lithium enolate of acetate 32 with aldehyde 28. In the event, the aldol reaction afforded an 85 % yield of a ca. 5 1 mixture of C3 epimers with the desired diastereomer (35) comprising the major product. 

Three tactical approaches were surveyed in the evolution of our program. As outlined in Scheme 2.7, initially the aldol reaction (Path A) was performed direcdy between aldehyde 63 and the dianion derived from tricarbonyl 58. In this way, it was indeed possible to generate the Z-lithium enolate of 58 as shown in Scheme 2.7 which underwent successful aldol condensation. However, the resultant C7 P-hydroxyl functionality tended to cyclize to the C3 carbonyl group, thereby affording a rather unmanageable mixture of hydroxy ketone 59a and lactol 59b products. Lac-tol formation could be reversed following treatment of the crude aldol product under the conditions shown (Scheme 2.7) however, under these conditions an inseparable 4 1 mixture of diastereomeric products, 60 (a or b) 61 (a or b) [30], was obtained. This avenue was further impeded when it became apparent that neither the acetate nor TES groups were compatible with the remainder of the synthesis. 

Traditional models for diastereoface selectivity were first advanced by Cram and later by Felkin for predicting the stereochemical outcome of aldol reactions occurring between an enolate and a chiral aldehyde. [37] During our investigations directed toward a practical synthesis of dEpoB, we were pleased to discover an unanticipated bias in the relative diastereoface selectivity observed in the aldol condensation between the Z-lithium enolate B and aldehyde C, Scheme 2.6. The aldol reaction proceeds with the expected simple diastereoselectivity with the major product displaying the C6-C7 syn relationship shown in Scheme 2.7 (by ul addition) however, the C7-C8 relationship of the principal product was anti (by Ik addition). [38] Thus, the observed symanti relationship between C6-C7 C7-C8 in the aldol reaction between the Z-lithium enolate of 62 and aldehyde 63 was wholly unanticipated. These fortuitous results prompted us to investigate the cause for this unanticipated but fortunate occurrence. 

Earlier studies had demonstrated that such enolates would participate in aldol condensations with aldehydes however, the stereochemical aspects of the reaction were not investigated (68). For the cases summarized in Table 25, the zirconium enolates were prepared from the corresponding lithium enolates (eq. [54]). Control experiments indicated that no alteration in enolate geometry accompanies this ligand exchange process, and that the product ratio is kinetically controlled (35). From the cases illustrated, both ( )-enolates (entries A-E) and (Z)-enolates (entries F-H) exhibit predominant kinetic erythro diastereoselection. Although a detailed explanation of these observations is clearly speculative, certain aspects of a probable... 

In the aldol-Tishchenko reaction, a lithium enolate reacts with 2 mol of aldehyde, ultimately giving, via an intramolecular hydride transfer, a hydroxy ester (51) with up to three chiral centres (R, derived from rYhIO). The kinetics of the reaction of the lithium enolate of p-(phenylsulfonyl)isobutyrophenone with benzaldehyde have been measured in THF. ° A kinetic isotope effect of fee/ o = 2.0 was found, using benzaldehyde-fil. The results and proposed mechanism, with hydride transfer rate limiting, are supported by ab initio MO calculations. 

The mechanism of the aldol-Tishchenko reaction has been probed by determination of kinetics and isotope effects for formation of diol-monoester on reaction between the lithium enolate of p-(phenylsulfonyl)isobutyrophenone (LiSIBP) and two molecules of benzaldehyde. ". The results are consistent with the formation of an initial lithium aldolate (25) followed by reaction with a second aldehyde to form an acetal (26), and finally a rate-limiting intramolecular hydride transfer (Tishchenko... 

Lithium Enolates. The control of mixed aldol additions between aldehydes and ketones that present several possible sites for enolization is a challenging problem. Such reactions are normally carried out by complete conversion of the carbonyl compound that is to serve as the nucleophile to an enolate, silyl enol ether, or imine anion. The reactive nucleophile is then allowed to react with the second reaction component. As long as the addition step is faster than proton transfer, or other mechanisms of interconversion of the nucleophilic and electrophilic components, the adduct will have the desired... 

---