Alcohols, with acyl halides catalyzed

The alcoholysis of anhydrides (Reaction XVI) is similar in scope to the reaction of alcohols with acyl halides. The reaction is catalyzed by general esterification catalysts, but usually they are not needed unless the anhydride is unreactive or the di-ester (such as a phthalate) is the product sought. 

Because of the special structural requirements of the resin-bound substrate, this type of cleavage reaction lacks general applicability. Some of the few examples that have been reported are listed in Table 3.19. Lactones have also been obtained by acid-catalyzed lactonization of resin-bound 4-hydroxy or 3-oxiranyl carboxylic acids [399]. Treatment of polystyrene-bound cyclic acetals with Jones reagent also leads to the release of lactones into solution (Entry 5, Table 3.19). Resin-bound benzylic aryl or alkyl carbonates have been converted into esters by treatment with acyl halides and Lewis acids (Entry 6, Table 3.19). Similarly, alcohols bound to insoluble supports as benzyl ethers can be cleaved from the support and simultaneously converted into esters by treatment with acyl halides [400]. Esters have also been prepared by treatment of carboxylic acids with an excess of polystyrene-bound triazenes here, diazo-nium salts are released into solution, which serve to O-alkylate the acid (Entry 7, Table 3.19). This strategy can also be used to prepare sulfonates [401]. 

The reaction between acyl halides and alcohols or phenols is the best general method for the preparation of carboxylic esters. It is believed to proceed by a 8 2 mechanism. As with 10-8, the mechanism can be S l or tetrahedral. Pyridine catalyzes the reaction by the nucleophilic catalysis route (see 10-9). The reaction is of wide scope, and many functional groups do not interfere. A base is frequently added to combine with the HX formed. When aqueous alkali is used, this is called the Schotten-Baumann procedure, but pyridine is also frequently used. Both R and R may be primary, secondary, or tertiary alkyl or aryl. Enolic esters can also be prepared by this method, though C-acylation competes in these cases. In difficult cases, especially with hindered acids or tertiary R, the alkoxide can be used instead of the alcohol. Activated alumina has also been used as a catalyst, for tertiary R. Thallium salts of phenols give very high yields of phenolic esters. Phase-transfer catalysis has been used for hindered phenols. Zinc has been used to couple... 

As noted in the preceding section, one of the most general methods of synthesis of esters is by reaction of alcohols with an acyl chloride or other activated carboxylic acid derivative. Section 3.2.5 dealt with two other important methods, namely, reactions with diazoalkanes and reactions of carboxylate salts with alkyl halides or sulfonate esters. There is also the acid-catalyzed reaction of carboxylic acids with alcohols, which is called the Fischer esterification. 

The most important reactions of alkyl substituents a and y to the ring heteroatom are those which proceed via base-catalyzed deprotonation. Treatment of 2- and 4-alkyl heterocycles with strong bases such as sodamide and liquid ammonia, alkyllithiums, LDA, etc., results in an essentially quantitative deprotonation and formation of the corresponding carbanions. These then react normally with a wide range of electrophiles such as alkyl halides and tosylates, acyl halides, carbon dioxide, aldehydes, ketones, formal-dehyde/dimethylamine, etc., to give the expected condensation products. Typical examples of these transformations are shown in Scheme 17. Deprotonation of alkyl groups by the use of either aqueous or alcoholic bases can also be readily demonstrated by NMR spectroscopy, and while the amount of deprotonation under these conditions is normally very small, under the appropriate conditions condensations with electrophiles proceed normally (Scheme 18). 

Less reactive than acyl halides, but still suitable for difficult couplings, are symmetric or mixed anhydrides (e.g. with pivalic or 2,6-dichlorobenzoic acid) and HOAt-derived active esters. HOBt esters smoothly acylate primary or secondary aliphatic amines, including amino acid esters or amides, without concomitant esterification of alcohols or phenols [34], HOBt esters are the most commonly used type of activated esters in automated solid-phase peptide synthesis. For reasons not yet fully understood, acylations with HOBt esters or halophenyl esters can be effectively catalyzed by HOBt and HOAt [3], and mixtures of BOP (in situ formation of HOBt esters) and HOBt are among the most efficient coupling agents for solid-phase peptide synthesis [2]. In acylations with activated amino acid derivatives, the addition of HOBt or HOAt also retards racemization [4,12,35]. 

The esterification of support-bound carboxylic acids has not been investigated as thoroughly as the esterification of support-bound alcohols. Resin-bound activated acid derivatives that are well suited to the preparation of esters include O-acylisoureas (formed from acids and carbodiimides), acyl halides [23,226-228], and mixed anhydrides (Table 13.15). A-Acylurea formation does not compete with esterifications as efficiently as it does with the formation of amides from support-bound acids. Esters can also be prepared from carboxylic acids on insoluble supports by acid-catalyzed esterification [152,229]. Alternatively, support-bound carboxylic acids can be esteri-fied by O-alkylation, either with primary or secondary aliphatic alcohols under Mitsu-nobu conditions or with reactive alkyl halides or sulfonates (Table 13.15). 

The reaction between acyl halides and alcohols or phenols is the best general method for the preparation of carboxylic esters. It is believed to proceed by a Sn2 mechanism.As with 16-57, the mechanism can be S l or tetrahedral. ° Pyridine catalyzes the reaction by the nucleophilic catalysis route (see 16-58). Lewis acids such as lithium perchlorate can be used. 

The synthesis of an alkylated aromatic compound 3 by reaction of an aromatic substrate 1 with an alkyl halide 2, catalyzed by a Lewis acid, is called the Friedel-Crafts alkylation This method is closely related to the Friedel-Crafts acylation. Instead of the alkyl halide, an alcohol or alkene can be used as reactant for the aromatic substrate under Friedel-Crafts conditions. The general principle is the intermediate formation of a carbenium ion species, which is capable of reacting as the electrophile in an electrophilic aromatic substitution reaction. 

Carbon monoxide rapidly inserts into the carbon—zirconium bond of alkyl- and alkenyl-zirconocene chlorides at low temperature with retention of configuration at carbon to give acylzirconocene chlorides 17 (Scheme 3.5). Acylzirconocene chlorides have found utility in synthesis, as described elsewhere in this volume [17]. Lewis acid catalyzed additions to enones, aldehydes, and imines, yielding a-keto allylic alcohols, a-hydroxy ketones, and a-amino ketones, respectively [18], and palladium-catalyzed addition to alkyl/aryl halides and a,[5-ynones [19] are examples. The acyl complex 18 formed by the insertion of carbon monoxide into dialkyl, alkylaryl, or diaryl zirconocenes may rearrange to a r 2-ketone complex 19 either thermally (particularly when R1 = R2 = Ph) or on addition of a Lewis acid [5,20,21]. The rearrangement proceeds through the less stable... 

One of the most common methods to catalyze acyl transfers is the addition of a nucleophile, particularly when using acid halide reactants. For example, consider the reaction of an alcohol or water with an acid halide, but with the addition of triethyl amine. We add the tri-ethylamine to neutralize the HX produced in this reaction, but it also significantly enhances the rate of the reaction (Eq. 10.109 also see Section 9.2.5 for a discussion of nucleophilic catalysis). Initial attack of the amine is faster than attack by the less nucleophilic alcohol or water, creating an intermediate with a positive charge. This is a highly reactive carbonyl that now adds nucleophiles faster than the starting acid halide. 

---