Aerodynamic design

Dallenback F., The Aerodynamic Design and Performance of Centrifugal and Mixed-Flow Compressors, SAE International Congress, January 1961. 

Shahpar S., A Comparative Study of Optimization Methods for Aerodynamic Design of Turbomachinery Blades, 2000-GT-523. 

Fixed ventilation has to be weatherproof to some degree. If it were not, then a simple hole in the wall or roof would be sufficient. The normal form of fixed ventilator is the louver panel. At its simplest, this may be a number of slats of wood mounted at 45-60° in a door or wall opening, and at its most sophisticated an aerodynamically designed two- or three-bank chevron of roll-formed or extruded aluminum (Figure 28.6). 

Aungier, R. H. (1999) Centrifugal Compressors A Strategy for Aerodynamic Design and Analysis (American Society of Mechanical Engineers). 

The temperature below which fouling can be prevented varies with each process, compressor, and application. Monitoring of process conditions is necessary to establish a threshold temperature in each case. In some cases, fouling cannot be prevented with an existing compressor. It may be necessary to modify the aerodynamic design and/or add cooling. 

Soderman, R T. Hazen, N. L. Brune, W. H. Aerodynamic Design of Gas and Aerosol Samplers for Aircraft NASA Technical Memo 103854, 1991. 

Aerodynamic Design of Cooling Tower Drift Eliminators... 

The form of a wind turbine power curve is shown in Figure 2.2. The wind turbine starts producing electricity when wind speed exceeds the cut-in threshold. From that point up to the nominal wind speed, power increases proportionally to the cube of wind speed. For higher wind speeds, power is kept close to the nominal value due to the blades aerodynamic design (passive stall control). Alternatively, a... 

Nemec, M. and Zingg, D.W. (2002). Newton-Kryolv algorithm for aerodynamic design using the Navier-Stokes equations. AIAA J., 40(6), 1146-1154. 

Viken, J.K. (1983). Aerodynamic design considerations and theoriti-cal results for a high Reynolds number natural laminar flow airfoil. M.S. Thesis. The School of Engineering and Applied Science, George Washington Univ, USA. 

Centrifuges where the rotors are run in a high vacuum chamber are called ultracentrifuges. Their maximum speed is not limited by air friction, and thus the rotors do not have to be aerodynamically designed because of this they can reach very high speeds. Ultracentrifuges are made for both analytical and preparative applications. 

Francis Hettinger Clauser obtained his BS degree in 1934, and the PhD degree in aeronautics in 1937 from Caltech. He was for the next ten years engineer of aerodynamic design with Douglas Aircraft Corp., from 1946 to 1960 then professor of aeronautics and department ehairman at Johns Hopkins University,... 

Kuethe, A.M., Chow, C.-Y. (1986). Foundations of aerodynamics Bases of aerodynamic design. Wiley New York. 

---