Heat detectors, active protection systems

Smoke detectors are employed where the type of fire anticipated and equipment protection needs a faster response time than heat detectors. A smoke detector will detect the generation of the invisible and visible products of combustion before temperature changes are sufficient to activate heat detectors. The ability of a smoke detector to sense a fire is dependent on the rise, spread, rate-of-bum, coagulation and air movement of the smoke itself. Where the safety of personnel is a concern, it is crucial to detect a fire incident at its early stages because of the toxic gases, lack of oxygen that may develop, and obscuration of escape routes. Smoke detection systems should be considered when these factors are present. 

The fire protection system consists not only of a deluge system activated by the ultraviolet sensors, but also of fusible link type fire systems. The deluge system has a trip mechanism from mercury checks activated by heat-activated-devices, a manual release on the deluge valve, a pneumatic remote trip station, and an electrical push button along with the electrical trip mechanism from the U/V detectors. The remote trip stations are located by escape routes so it is possible for the operator to trip the systems as he exits the building without exposing himself to further danger. 

Active fire protection systems (e.g. smoke or heat detectors, deluge sprinkler systems or foam systems). 

In this example a sensor (e.g. an automatic fire detector) is activated by combustion products such as smoke, heat or combustion gases. After activating the control unit (e.g. a fire alarm or detection system), it initiates programmed Controls of Fire Protection Systems (CFPS) or activates other actuators in the building. An actuator is for example a... 

The preaction system. In libraries, museums, or other locations where special contents may be housed, the preaction sprinkler system must be used. Any operation of the sprinkler system in the absence of fire would be devastating to the building contents. Most fire safety professionals identify two events that must take place in order to activate the system. First, the heat of a fire will melt the fusible link in the sealed sprinkler heads. Second, a detector must open the deluge valve to admit the water. In the absence of either of these two events, the sprinkler system will not function. The biggest disadvantage of this system is the cost. However, when contents of great value must be protected, the expense of a preaction system may not be restrictive. 

---