Acids Diones

Lee and Chang (1978) have compared the ability of linear polyethers, crown ethers, and quaternary ammonium compounds to catalyse oxidations with KMn04 under liquid-liquid and liquid-solid conditions. In the presence of acetic acid as a scavenger for the KOH produced, the products of olefin oxidation were carboxylic acids, diones, diols and ketols. The three different classes of catalysts exhibited about the same activity in liquid-solid systems. 

Mouse epidermal JB6 cells Mannose Retinoic acid Dion et at. (1981)... 

It is also possible to carry out permanganate oxidations in organic solvents by using crown ethers or phase transfer agents to effect solubilization of permanganate salts. Studies using 5-decene and cyclododecene as typical alkenes revealed that mixtures of carboxylic acids, diones, ketols, and diols were obtained, but that the ratio of the various products could be controlled, within limits, by the amount of... 

In the following examples, pinacol is oxidised to acetone, which is identified as its semicarba2one and its 2,4 dinitrophenylhydra2one, and glycerol is oxidised to formaldehyde and formic acid. The formaldehy de is readily detected by the condensation product which it gives with dimedone, 5,5-dimethylcyclohexan-i,3-dione (p, 277). 

Whilst the solution is still hot, add dilute hydrochloric acid until the stirred solution is just acid to litmus, and then distil off as much ethanol as possible, using the water-bath. Now add more dilute hydrochloric acid to the residual hot solution until it is just acid to methyl-orange. The 5,5-dimethyl-cyclohexan-1,3-dione separates as an oil which solidifies on cooling. Filter the product at the pump, wash it with ice-cold water, and dry it in a desiccator. Yield of the pale cream-coloured crystals, 12 g. m.p. 136-145 (preliminary softening). 

Ninhydrin (also named 1 2 3-triketoindane or 1 2 3-triketohydrindene hydrate) is prepared most simply from the inexpensive phthahc anhydride (I). The latter is condensed with acetic anhydride In the presence of potassium acetate to give phthalylacetlc acid (II) reaction of the latter with sodium methoxide in methanol yields 1 3-indanedionecarboxyhc acid, which is decomposed upon warming with dilute hydrochloric or sulphuric acid to indane-1 3-dione (or 1 3-diketohydrindene) (HI). Selenium dioxide oxidation of (III) afibrds indane-1 2 3-trione hydrate (ninhydrin) (IV). 

Indane-1 3-dione (1 3-diketohydrindene). Method A. To a solution of sodium methoxide, prepared from 6 1 g. of sodium and 200 ml. of anhydrous methanol, add 15 g. of phthalylacetic acid and allow to stand for 1 hour at room temperature collect the yellow precipitate by suction filtration. Mix the yellow solid with 150 ml. of 10 per cent, sulphuric acid, heat on a steam bath until no more carbon dioxide is evolved (15-20 minutes), filter the hot solution and allow to cool. Collect the yellow crystals by filtration at the pump, wash with a httle water and dry at 100°. The yield of crude 1 3-indanedione, m.p. 125-126°, is 7 g. RecrystaUise from hght petroleum, b.p. 80-100°, and thus obtain the pure product, m.p. 129-130°. 

Thermal electrocyclizations of perhalogenated 1,3-butadienes yield perhalogenated cyclobutenes which can be solvolysed to 3,4-dihydroxy-3-cydobutene-l,2-dione ( squaric acid") and its derivatives (G. Maahs, 1966 H. Knorr, 1978 A.H. Schmidt, 1978). Double CO extrusion from fused cyclobutenediones has been used to produce cycloalkynes, e.g., benzyne from benzocyclobutenedione by irradiation in an argon matrix (O.L. Chapman, 1973) and cyc/o-Ci8, cyclo-Cn, etc. by laser desorption mass spectroscopy of appropriate precursors (see section 4.9.8). 

Cydopentane reagents used in synthesis are usually derived from cyclopentanone (R.A. Ellison, 1973). Classically they are made by base-catalyzed intramolecular aldol or ester condensations (see also p. 55). An important example is 2-methylcydopentane-l,3-dione. It is synthesized by intramolecular acylation of diethyl propionylsucdnate dianion followed by saponification and decarboxylation. This cyclization only worked with potassium t-butoxide in boiling xylene (R. Bucourt, 1965). Faster routes to this diketone start with succinic acid or its anhydride. A Friedel-Crafts acylation with 2-acetoxy-2-butene in nitrobenzene or with pro-pionyl chloride in nitromethane leads to acylated adducts, which are deacylated in aqueous acids (V.J. Grenda, 1967 L.E. Schick, 1969). A new promising route to substituted cyclopent-2-enones makes use of intermediate 5-nitro-l,3-diones (D. Seebach, 1977). 

The 3.8-nonadienoate 91, obtained by dimerization-carbonylation, has been converted into several natural products. The synthesis of brevicomin is described in Chapter 3, Section 2.3. Another royal jelly acid [2-decenedioic acid (149)] was prepared by cobalt carbonyl-catalyzed carbonylation of the terminal double bond, followed by isomerization of the double bond to the conjugated position to afford 149[122], Hexadecane-2,15-dione (150) can be prepared by Pd-catalyzed oxidation of the terminal double bond, hydrogenation of the internal double bond, and coupling by Kolbe electrolysis. Aldol condensation mediated by an organoaluminum reagent gave the unsaturated cyclic ketone 151 in 65% yield. Finally, the reduction of 151 afforded muscone (152)[123]. n-Octanol is produced commercially as described beforc[32]. 

Folyphosphoric acid trimethylsilyl ester (PPSE)[1] can be used in sulfolane, CH,Cl2 or nitromethane. It is similar to polyphosphoric acid but the overall conditions arc milder and the work-up more convenient. PPSE has been used in the cydization of ris-arylhydrazones of cyclohexane-l,2-diones to give indolo[2,3-a]carbazole analogues[2],... 

P4ALEIC ANHYDRIDE, MALEIC ACID AND FUMARIC ACID] (Vol 15) 9a,21-dichloro-17-[(2-furanyl-carbonyl)oxyl]-llb-hydroxy-16a-methyl-pregna-l,4-diene-3,20-dione. See Mometasone fluroate. 

Methylation of hydrocortisone/prednisolone ia positions C-4, C-7, C-12, and C-21 failed to give useful products. Methylation at C-16, ia contrast, led to 16a- and 16P-methyl-9a- uoroprednisolones which were exceptionally useful. Both series were prepared usiag 3a-acetoxy-5a-pregn-16-ene-ll,20-dione derived from desoxychoHc acid (80). A much shorter route was subsequentiy developed from... 

Acylated Corticoids. The corticoid side-chain of (30) was converted iato the cycHc ortho ester (96) by reaction with a lower alkyl ortho ester RC(OR )2 iu benzene solution ia the presence of i ra-toluenesulfonic acid (88). Acid hydrolysis of the product at room temperature led to the formation of the 17-monoesters (97) ia nearly quantitative yield. The 17-monoesters (97) underwent acyl migration to the 21-monoesters (98) on careful heating with. In this way, prednisolone 17a,21-methylorthovalerate was converted quantitatively iato prednisolone 17-valerate, which is a very active antiinflammatory agent (89). The iatermediate ortho esters also are active. Thus, 17a,21-(l -methoxy)-pentyhdenedioxy-l,4-pregnadiene-liP-ol-3,20-dione [(96), R = CH3, R = C Hg] is at least 70 times more potent than prednisolone (89). The above conversions... 

A second class of herbicides primarily affects ( -carotene desaturase. These herbicides are apparent feedback inhibitors of PD as well. This class of compounds includes dihydropyrones like LS 80707 [90936-96-2] (56) and 6-methylpyridines (57,58). The third class consists of the ben2oylcyclohexane-diones, eg, 2-(4-chloro-2-nitroben2oyl)-5,5-dimethyl-cyclohexane-I,3-dione. This class of atypical bleaching herbicides induces phytoene accumulation when appHed either pre- or post-emergence. However, it does not inhibit phytoene desaturase activity in vitro (59). Amitrole also has been considered a bleaching herbicide, though its main mode of action is inhibition of amino acid synthesis. 

Because lactic acid has both hydroxyl and carboxyl functional groups, it undergoes iatramolecular or self-esterificatioa and forms linear polyesters, lactoyUactic acid (4) and higher poly(lactic acid)s, or the cycUc dimer 3,6-dimethyl-/)-dioxane-2,5-dione [95-96-5] (dilactide) (5). Whereas the linear polyesters, lactoyUactic acid and poly(lactic acid)s, are produced under typical condensation conditions such as by removal of water ia the preseace of acidic catalysts, the formation of dilactide with high yield and selectivity requires the use of special catalysts which are primarily weakly basic. The use of tin and ziac oxides and organostaimates and -titanates has been reported (6,21,22). 

Cychc diacyl peroxides can be generated from suitable dibasic acid chlorides and sodium or hydrogen peroxide, especially in dilute solutions (187,205), eg, 2,3-ben2odioxin-l,4-dione [4733-52-2] from phthaloyl chloride ... 

Fig. 2. Synthesis of uma2enil (18). The isonitrosoacetanihde is synthesized from 4-f1iioroani1ine. Cyclization using sulfuric acid is followed by oxidization using peracetic acid to the isatoic anhydride. Reaction of sarcosine in DMF and acetic acid leads to the benzodiazepine-2,5-dione. Deprotonation, phosphorylation, and subsequent reaction with diethyl malonate leads to the diester. After selective hydrolysis and decarboxylation the resulting monoester is nitrosated and catalyticaHy hydrogenated to the aminoester. Introduction of the final carbon atom is accompHshed by reaction of triethyl orthoformate to...

---