Acid anhydrides reagents

The acylation of ketones with acid anhydrides may be effected by means of the acid reagent boron trifluoride, for example ... 

A mixture of an acid anhydride and a ketone is saturated with boron trifluoride this is followed by treatment with aqueous sodium acetate. The quantity of boron trifluoride absorbed usually amounts to 100 mol per cent, (based on total mola of ketone and anhydride). Catalytic amounts of the reagent do not give satisfactory results. This is in line with the observation that the p diketone is produced in the reaction mixture as the boron difluoride complex, some of which have been isolated. A reasonable mechanism of the reaction postulates the conversion of the anhydride into a carbonium ion, such as (I) the ketone into an enol type of complex, such as (II) followed by condensation of (I) and (II) to yield the boron difluoride complex of the p diketone (III) ... 

The characteristic reaction of acyl chlorides acid anhydrides esters and amides is nucleophilic acyl substitution Addition of a nucleophilic reagent Nu—H to the carbonyl group leads to a tetrahedral mtermedi ate that dissociates to give the product of substitution... 

Section 20 6 Acid anhydrides are less reactive toward nucleophilic acyl substitution than acyl chlorides but are useful reagents for preparing esters and amides... 

Sulfonylation. Under Friedel-Crafts reaction conditions, sulfonyl haUdes and sulfonic acid anhydrides sulfonylate aromatics (139), a reaction that can be considered the analogue of the related acylation with acyl haUdes and anhydrides. The products are sulfones. Sulfonyl chlorides are the most frequently used reagents, although the bromides and fluorides also react ... 

The other analytical methods necessary to control the typical specification given in Table 5 are, for the most part, common quality-control procedures. When a chemical analysis for purity is desired, acetylation or phthalation procedures are commonly employed. In these cases, the alcohol reacts with a measured volume of either acetic or phthalic anhydride in pyridine solution. The loss in titratable acidity in the anhydride solution is a direct measure of the hydroxyl groups reacting in the sample. These procedures are generally free from interference by other functional groups, but both are affected adversely by the presence of excessive water, as this depletes the anhydride reagent strength to a level below that necessary to ensure complete reaction with the alcohol. Both procedures can be adapted to a semimicro- or even microscale deterrnination. 

Lithium aluminum hydride (LiAlH4) is the most powerful of the hydride reagents. It reduces acid chlorides, esters, lactones, acids, anhydrides, aldehydes, ketones and epoxides to alcohols amides, nitriles, imines and oximes to amines primary and secondary alkyl halides and toluenesulfonates to... 

Aryl perfluoroalkylsulfonaies, readily available by the reaction of the corresponding phenols and acid anhydrides or chlorides, are used as reagents in or-ganometallic coupling reactions (for a recent review, see reference 69)... 

The most important group of derivatives for the amino function (Fig. 7-4) is the carbamate group, which can be formed by reactions with acids, acid chlorides or acid anhydrides. A series of chlorides as 2-chloroisovalerylchloride [1], chrysanthe-moylchloride [2] and especially chloride compounds of terpene derivatives (cam-phanic acid chloride [3], camphor-10-sulfonyl chloride [4]) are used. The a-methoxy-a-trifluoromethylphenylacetic acid or the corresponding acid chloride introduced by Mosher in the 1970s are very useful reagents for the derivatization of amines and alcohols [5]. 

Note that the diorganocopper reaction occurs only with acid chlorides. Carboxylic acids, esters, acid anhydrides, and amides do not react with lithium diorganocopper reagents. 

Arsenic Pantoxide (Arsenic Acid Anhydride, Arsenic Oxide). As2Os, mw 229.84, white amorph powd, mp 315° (decompn), d 4.32g/cc. Sol in ale, acids, alkalies and w. Prepn is by heating a rnixt of As2 3 with coned HN03 (d 1.38g/cc) until the evoln of nitrogen oxides ceases. The soln of H3As04 is then evapd to dryness, redissolved in w and reevapd until a temp of over 300° is reached. It is used as a chemical reagent... 

There are some problems associated with the use of functional derivatives of carboxylic acids. Long-chain acid anhydrides are not commercially available, and one half of the acylation reagent is not utilized. Acyl chlorides require the use of tertiary base catalysts, whose double role has been explained before. Some of the intermediate acyl ammonium compounds formed are, however, insoluble in the solvent system. Examples include RCO - N+EtsCL in LiCl/DMAc, where RCO refers to the propionyl, hexanoyl, and stearoyl moiety, respectively. Hexanoyl- and stearoyl-pyridinium chlorides are also insoluble in the same solvent system [185]. 

Trichloromethyl chloroformate has proven effective in the preparation of N-carboxy-a-amino acid anhydrides from amino acids, and various compounds having isocyanate, acid chloride, and chloroformate groups.For example, trichloromethyl chloroformate may be used instead of phosgene in the preparation of 2-tert-butoxycarbonyloxyimino-2-phenylacetonitrile. The use of this reagent is illustrated here by the synthesis of 3-isocyanato-propanoyl chloride from 3-aminopropanoic acid hydrochloride. 

Whereas conversion of sulfoxides to the corresponding a-acyloxysulfides by acid anhydrides, for example acetic anhydride, the Pummerer reaction [1], has been known for quite a time, the conversion of sulfoxides with silylating reagents via the unstable intermediate O-silyl compounds to a-silyloxysulfides, the Sila-Pummerer reaction is a relatively new reaction, which has recently been reviewed [1—4-]. 

Attention has been drawn to the potential of phosphoric acid anhydrides of nucleoside 5 -carboxylic acids (14) as specific reagents for investigating the binding sites of enzymes. For example, (14 B = adenosine) inactivates adenylosuccinate lyase from E. coli almost completely, but has little effect on rabbit muscle AMP deaminase. The rate of hydrolysis of (14) is considerably faster than that of acetyl phosphate, suggesting intramolecular assistance by the 3 -hydroxyl group or the 3-nitrogen atom. 

The formation of halogenation products from Grignard reagents and sulfonic acid anhydrides is the result of an oxidative reaction pathway . This side-reaction can be reduced by using sulfonic acid esters, however, in these cases alkylations as well as twofold sulfonylations (cf. corresponding results with sulfonyl fluorides ) are competing (equations 64 and 65). 

The inclusion of DMAP to the extent of 5-20 mol % in acylations by acid anhydrides and acyl chlorides increases acylation rates by up to four orders of magnitude and permits successful acylation of tertiary and other hindered alcohols. The reagent combination of an acid anhydride with MgBr2 and a hindered tertiary amine, e.g., ( -Pr)2NC2H5 or 1,2,2,6,6,-pentamethylpiperidine, gives an even more reactive acylation system, which is useful for hindered and sensitive alcohols.105... 

---