Acetates titanium carbonyl

The enolates of other carbonyl compounds can be used in mixed aldol reactions. Extensive use has been made of the enolates of esters, thiol esters, amides, and imides, including several that serve as chiral auxiliaries. The methods for formation of these enolates are similar to those for ketones. Lithium, boron, titanium, and tin derivatives have all been widely used. The silyl ethers of ester enolates, which are called silyl ketene acetals, show reactivity that is analogous to silyl enol ethers and are covalent equivalents of ester enolates. The silyl thioketene acetal derivatives of thiol esters are also useful. The reactions of these enolate equivalents are discussed in Section 2.1.4. 

Covalently bonded chiral auxiliaries readily induce high stereoselectivity for propionate enolates, while the case of acetate enolates has proved to be difficult. Alkylation of carbonyl compound with a novel cyclopentadienyl titanium carbohydrate complex has been found to give high stereoselectivity,44 and a variety of ft-hydroxyl carboxylic acids are accessible with 90-95% optical yields. This compound was also tested in enantioselective aldol reactions. Transmetalation of the relatively stable lithium enolate of t-butyl acetate with chloro(cyclopentadienyl)-bis(l,2 5,6-di-<9-isopropylidene-a-D-glucofuranose-3-0-yl)titanate provided the titanium enolate 66. Reaction of 66 with aldehydes gave -hydroxy esters in high ee (Scheme 3-23). 

In the hydroxycyclopropanation of alkenes, esters may be more reactive than N,N-dialkylcarboxamides, as is illustrated by the exclusive formation of the disubstituted cyclopropanol 75 from the succinic acid monoester monoamide 73 (Scheme 11.21) [91]. However, the reactivities of both ester- as well as amide-carbonyl groups can be significantly influenced by the steric bulk around them [81,91]. Thus, in intermolecular competitions for reaction with the titanacydopropane intermediate derived from an alkylmagnesium halide and titanium tetraisopropoxide or methyltitanium triisoprop-oxide, between N,N-dibenzylformamide (48) and tert-butyl acetate (76) as well as between N,N-dibenzylacetamide (78) and tert-butyl acetate (76), the amide won in both cases and only the corresponding cyclopropylamines 77 and 79, respectively, were obtained (Scheme 11.21) [62,119]. 

The present preparation illustrates a general and convenient method for a two-step deoxygenation of carbonyl compounds to olefins. Related procedures comprise the basic decomposition of p-toluenesulfonylhydrazones, the hydride reduction of enol ethers, enol acetates, enamines, the reduction of enol phosphates (and/or enol phosphorodiamidates) by lithium metal in ethylamine (or liquid ammonia),the reduction of enol phosphates by titanium metal... 

Balme G, Gore J (1983) Conversion of acetals and ketals to carbonyl compounds promoted by titanium tetrachloride. J Org Chem 48 3336-3338... 

Ruthenium, cobalt and halogen are the key elements of this catalysis (2), although ruthenium in combination with halogen-containing zirconium and titanium derivatives is also effective (3). In the case of the Ru-Oo couple, the highest yields of acetic acid may generally be achieved with ruthenium oxide, carbonyls and complex derivatives in combination with various cobalt halides dispersed in low-melting quaternary phosphonium halide salts (2). 

Carreira et al. used a chiral BlNOL-derived Schiff base-titanium complex as the catalyst for the aldol reactions of acetate-derived ketene silyl acetals (Scheme 8C.29) [64a]. The catalyst was prepared in toluene in the presence of salicylic acid, which was reported to be crucial to attain a high enantioselectivity. A similar Schiff base-titanium complex is also applicable to the carbonyl-ene type reaction with 2-methoxypropene [64b], Although the reaction, when con-... 

Imines and their derivatives could be used in an analogous way to aldehydes, ketones, or their derivatives this subject has been reviewed [79]. A competition experiment between an aldimine and the corresponding aldehyde in the addition to an enol silyl ether under titanium catalysis revealed that the former is less reactive than the latter (Eq. 14) [80]. In other words, TiCU works as a selective aldehyde activator, enabling chemoselective aldol reaction in the presence of the corresponding imine. (A,0)-Acetals could be considered as the equivalent of imines, because they react with enol silyl ethers in the presence of a titanium salt to give /5-amino carbonyl compounds, as shown in Eqs (15) [81] and (16) [79,82]. 

If the reaction between enol silyl ethers and a,/ -unsaturated ketones is attempted in the presence of a titanium Lewis acid, the mode of the reaction switches to 1,4-addition with reference to the unsaturated ketone [109-113]. The reaction of an enol silyl ether is shown in Eq. (30) [114]. Ketene silyl acetals react with a,j8-unsaturated ketones in similar 1,4-fashion, as exemplified in Eq. (31) [115]. Acrylic esters, which often tend to polymerize, are also acceptable substrates for a, -unsaturated carbonyl compounds [111]. A difluoroenol silyl ether participated in this cationic reaction (Eq. 32) [116], and an olefinic acetal can be used in place of the parent a-methylene ketone [111] to give the 1,5-diketone in good yield (Eq. 33) [117]. More results from titanium-catalyzed 1,4-addition of enol silyl ethers and silyl ketene acetals to a,f -unsaturated carbonyl compounds are summarized in Table 4. 

In addition to enol silyl ethers, an optically active boryl enolate underwent the highly anri-stereoselective aldol reaction with a wide variety of aldehydes in the presence of TiCU (Eq. 34) [120]. The vinyl sulfides shown in Eq. (35) reacted with a,fi-unsaturated ketones via the 1,4-addition pathway in the presence of a titanium salt, but the reaction was followed by the cleavage of a carbon-carbon bond in the cycloalkane to give open chain products in a stereoselective manner [121]. The 1,2-type addition was observed, if the olefinie acetal was used instead of the corresponding carbonyl compound, as shown in Eq. (36) [121], The successive scission of the carbon-carbon bond took place analogously to give the same type of products as shown in Eq. (35). 

Titanium tetrachloride promoted a three-component cyclization involving a carbonyl compound, an allylsilane, and an acetal, as shown in Eq. (69) [188]. The reaction was initiated by allyl addition to the aldehyde this was followed by acetal exchange and intramolecular Friedel-Crafts-type alkylation of the olefinic moiety. 

Titanium salts nicely promote acetalization, transacetalization, and deacetalization, etc. Acetals and related compounds are prepared from the parent carbonyl compounds or other acetals in the presence of a titanium salt. In addition to ordinary acetals, N,Oy or (5, 5)-acetals could be prepared by this method. Equation (234) illustrates the preparation of a mixed acetal with different alkoxide groups [533]. Table 20 shows the preparation of different acetals in the presence of titanium salts. 

Indirect replacement of the a-hydrogen atom of carboxylic esters by the nitroso group is remarkable. This procedure uses ketene 0-alkyl O -silyl acetals (1), generated from carboxylic esters, which are treated with nitric oxide or isopentyl nitrite in the presence of titanium(IV) chloride. In the absence of an a-hydrogen a-nitroso esters (2) are obtained. a-Nitroso esters with an a-hydrogen undergo isomerization to oximes of a-keto esters (3 equation 1). Similarly, silyl enol ethers of aldehydes or ketones can be used instead of the carbonyl compound itself for nitrosation. Thus, treatment of enol ether (4) with nitro-syl chloride gives the a-nitroso aldehyde (5 equation 2), which is quite stable at 0 C, but dimerizes at room temperature. 

Many other metal ions have been reported as catalysts for oxidations of paraffins or intermediates. Some of the more frequently mentioned ones include cerium, vanadium, molybdenum, nickel, titanium, and ruthenium [21, 77, 105, 106]. These are employed singly or in various combinations, including combinations with cobalt and/or manganese. Activators such as aldehydes or ketones are frequently used. The oxo forms of vanadium and molybdenum may very well have the heterolytic oxidation capability to catalyze the conversion of alcohols or hydroperoxides to carbonyl compounds (see the discussion of chromium, above). There is reported evidence that Ce can oxidize carbonyl compounds via an enol mechanism [107] (see discussion of manganese, above). Although little is reported about the effectiveness of these other catalysts for oxidation of paraffins to acetic acid, tests conducted by Hoechst Celanese have indicated that cerium salts are usable catalysts in liquid-phase oxidation of butane [108]. 

---