Acetate rhodium, reaction with

Likewise, several stable S,C-ylides derived from benzo[ >]thiophene and some 2,3-disubstituted benzo[i>]thiophenes have been reported recently <9iT86l l> by rhodium(II) acetate-catalyzed reaction with -icarbonyl diazo compounds. Ylides (e.g. (140)) from benzo[ >]thiophene and dibenzo-thiophene have also been reported by franj-ylidation using phenyliodonium bis(phenylsulfonyl)-methylide <88JHC1599>. 

Cyclopropanation. Decomposition of dimethyl diazomalonate by direct photolysis or by transition metal catalysis in the presence of alkenes leads to cyclopropanation (eq 1). The use of alkynes to trap the carbenoid species affords cyclopropenes (eq 2). Rhodium(II) acetate-catalyzed reaction with allenes allows ready access to methylenecyclopropanes, which form the basis for a methylenecyclopentane annulation protocol (eq 3). ... 

Alkenation. Alkenation of thiolactones can be achieved by rhodium(II) acetate-catalyzed reaction with dimethyl diazomalonate (eq 12). Recently, an efficient alternative alkenation protocol has been demonstrated to be applicable to a variety of ketones and aldehydes by reaction with tributylstibine and dimethyl diazomalonate in the presence of copperfT) bromide (eq 13). This process is proposed to occur via tributylstibonium bis(methoxycarbonyl)methylide. 

The unit has virtually the same flow sheet (see Fig. 2) as that of methanol carbonylation to acetic acid (qv). Any water present in the methyl acetate feed is destroyed by recycle anhydride. Water impairs the catalyst. Carbonylation occurs in a sparged reactor, fitted with baffles to diminish entrainment of the catalyst-rich Hquid. Carbon monoxide is introduced at about 15—18 MPa from centrifugal, multistage compressors. Gaseous dimethyl ether from the reactor is recycled with the CO and occasional injections of methyl iodide and methyl acetate may be introduced. Near the end of the life of a catalyst charge, additional rhodium chloride, with or without a ligand, can be put into the system to increase anhydride production based on net noble metal introduced. The reaction is exothermic, thus no heat need be added and surplus heat can be recovered as low pressure steam. 

The use of dirhodium(II) catalysts for catalytic reactions with diazo compounds was initiated by Ph. Teyssie [14] in the 1970s and rapidly spread to other laboratories [1]. The first uses were with dirhodium(II) tetraacetate and the more soluble tetraoctanoate, Rh2(oct)4 [15]. Rhodium acetate, revealed to have the paddle wheel structure and exist with a Rh-Rh single bond [16], was conve-... 

Much of the early work into the rhodium(II)-catalysed formation of oxazoles from diazocarbonyl compounds was pioneered by the group of Helquist. They first reported, in 1986, the rhodium(II) acetate catalysed reaction of dimethyl diazomalonate with nitriles.<86TL5559, 93T5445, 960S(74)229> A range of nitriles was screened, including aromatic, alkyl and vinyl derivatives with unsaturated nitriles, cyclopropanation was found to be a competing reaction (Table 3). 

A series of catalysts was also screened in the reaction with benzonitrile to give methyl 2-phenyl-5-methoxyoxazole-4-carboxylate, with rhodium(II) acetate being the most effective (Table 4).<93T5445>... 

Other companies (e.g., Hoechst) have developed a slightly different process in which the water content is low in order to save CO feedstock. In the absence of water it turned out that the catalyst precipitates. Clearly, at low water concentrations the reduction of rhodium(III) back to rhodium(I) is much slower, but the formation of the trivalent rhodium species is reduced in the first place, because the HI content decreases with the water concentration. The water content is kept low by adding part of the methanol in the form of methyl acetate. Indeed, the shift reaction is now suppressed. Stabilization of the rhodium species and lowering of the HI content can be achieved by the addition of iodide salts. High reaction rates and low catalyst usage can be achieved at low reactor water concentration by the introduction of tertiary phosphine oxide additives.8 The kinetics of the title reaction with respect to [MeOH] change if H20 is used as a solvent instead of AcOH.9 Kinetic data for the Rh-catalyzed carbonylation of methanol have been critically analyzed. The discrepancy between the reaction rate constants is due to ignoring the effect of vapor-liquid equilibrium of the iodide promoter.10... 

Extensive investigations in our laboratories on the deactivation of rhodium and iridium catalysts has shown there to be a number of different mechanisms involved. Both, rhodium and iridium catalysts are generally less stable at higher temperatures, and have more labile ligands than their ruthenium counterparts. All of the catalysts are affected by pH, but the ruthenium catalysts seem to be more readily deactivated by acid. Indeed, these reactions are often quenched with acetic acid, whilst stronger acids are used to quench the rhodium reactions. Each of the catalysts can be deactivated by product inhibition, the ruthenium catalyst with aromatic substrates such as phenylethanol, and the rhodium and iridium ones by bidentate chelating products. 

Before turning to specific results we will have a look at the properties of rhodium(II) acetates/carboxamidates as catalysts for reactions with diazocompounds as the substrates via carbenoid intermediates. Rhodium(II) has a d7 electron configuration, forming the lantern type dimers with bridging carboxylates. The single electrons in the respective dz2 orbitals form an electron... 

Wenkert and Khatuya (51) examined the competition between direct insertion of a carbene into furan (via cyclopropanation) and ylide formation with reactive side-chain functionality such as esters, aldehydes, and acetals. They demonstrated the ease of formation of aldehyde derived carbonyl ylides (Scheme 4.30) as opposed to reaction with the electron-rich olefin of the furan. Treatment of 3-furfural (136) with ethyl diazoacetate (EDA) and rhodium acetate led to formation of ylide 137, followed by trapping with a second molecule of furfural to give the acetal 138 as an equal mixture of isomers at the acetal hydrogen position. 

The isomerization of allyl ethers to 1-propenyl ethers, which is usually performed with potassium tert-butoxide in dimethyl sulfoxide, can also be carried out under milder conditions using tris(triphen-ylphosphine)rhodium chloride,208 and by an ene reaction with diethyl azodicarboxylate,209,210 which affords a vinyl ether adduct. Removal of an O-allyl group may be achieved by oxidation with selenium dioxide in acetic acid,211 and by treatment with N-bromosuccinimide, followed by an aqueous base.201,212... 

A similar carbenoid route to the fused /Mactam 5 involves reaction of ethyl diazoacetoacetate with 4-acctoxyazetidin-2-one (4) catalyzed by rhodium(II) acetate. Rhodium(II) acetate may also promote the cyclizalion step.6 For another route to compounds related to 5 see 8, 36. 37. 

Over the last few years it has become clear that rhodium(II) acetate is more effective than the copper catalysts in generating cyclopropenes.12 126 As shown in Scheme 28,12S a range of functionality, including terminal alkynes, can be tolerated in the reaction with methyl diazoacetate. Reactions with phenyl-acetylene and ethoxyacetylene were unsuccessful, however, because the alkyne polymerized under the reaction conditions. 

The products formed in these reactions are very sensitive to the functionality on the carbenoid. A study of Schechter and coworkers132 using 2-diazo-1,3-indandione (152) nicely illustrates this point. The resulting carbenoid would be expected to be more electrophilic than the one generated from alkyl diazoacetate and consequently ihodium(II) acetate could be used as catalyst. The alkylation products (153) were formed in high yields without any evidence of cycloheptatrienes (Scheme 33). As can be seen in the case for anisole, the reaction was much more selective than the rhodium(II)-catalyzed decomposition of ethyl diazoacetate (Scheme 31), resulting in the exclusive formation of the para product. Application of this alkylation process to the synthesis of a novel p-quinodimethane has been reported.133 Similar alkylation products were formed when dimethyl diazomalonate was decomposed in the presence of aromatic systems, but as these earlier studies134 were carried out either photochemically or by copper catalysis, side reactions also occurred, as can be seen in the reaction with toluene (equation 36). 

---