Surfactant absorption

Figure 7.12 Representation of three forms of absorption-surfactant concentration profile (see text for discussion).

Humectants and low vapor pressure cosolvents are added to inhibit drying of ink in the no22les. Surfactants or cosolvents that lower surface tension are added to promote absorption of ink vehicle by the paper and to prevent bleed. For improvements in durabiUty, additional materials such as film-forming polymers have been added. Ink developments are providing ink-jet prints with improved lightfastness, waterfastness, and durabiUty. As a result, such prints are beginning to rival the quaUty of electrophotographic prints. 

Poly(vinyl acetate) chains are also stabilized as aqueous-soluble anionic species by complexation with a surfactant. The charge on the water-soluble species prevents their absorption into the particle (114). 

Neutralizing removes the large amount of hexavalent chromium from the surface of the part. Hexavalent chromium shortens the life of the catalyst, and trace amounts completely inhibit electroless nickel deposition. The neutralizer is usually a mildly acidic or basic reducing agent, but other types of neutralizers are available, especially for substrates that are difficult to plate. The neutralizer may also contain surfactants (qv) or other compounds that increase catalyst absorption absorption promoters are often needed for non-ABS plastics. 

THE INFLUENCE OF SURFACTANTS NATURE AND CONCENTRATION ON THE ANALYTICAL SIGNAL IN THE ATOMIC ABSORPTION DETERMINATION OF LEAD, CADMIUM AND CHROMIUM... 

The substitution of water-borne versions of these primers is increasing as environmental restrictions on the use of organic solvents become stricter. These are generally aqueous emulsions of epoxy novolac or phenolic based resins stabilized by surfactants [34]. Non-ionic surfactants are preferred, as they are non-hygroscopic in the dried primer films. Hygroscopic ionic surfactants could result in excessive water absorption by the primer film in service. 

In the latter function, the reagent behaves as a surfactant and forms a cationic micelle at a concentration above the critical micelle concentration (1 x 10 4M for CTMB). The complexation reactions occurring on the surface of the micelles differ from those in simple aqueous solution and result in the formation of a complex of higher ligand to metal ratio than in the simple aqueous system this effect is usually accompanied by a substantial increase in molar absorptivity of the metal complex. 

PMs are orange-colored, with an absorption maximum at 488 nm (Fig. 9.6). The absorption characteristics and chemiluminescence activities of those compounds are shown in Table 9.4. All PMs are brightly fluorescent in yellow in organic solvents and also in aqueous solutions containing a surfactant (emission maxima 520-530 nm). The chemiluminescence spectra of PMs are significantly affected by the... 

Davies et al. (D9) have recently measured the rates of absorption of various gases into turbulently stirred water both with carefully cleaned surfaces and with surfaces covered with varying amounts of surfactants. That hydrodynamic resistances, rather than monolayer resistances, are predominant in their work is consistent with the high sensitivity of kL to very small amounts of surface contamination and also with the observation that a limit to the reduction in kL is found (D7, D9). This is in agreement with the results of Lindland and Terjesen (L9), who found that after a small concentration of surfactant had been used further additions caused but little change in terminal velocity (L9). 

American Society for Testing and Materials, Standard for Qualitative Classification of Surfactants by Infrared Absorption, D2357-74 (Reapproved 1989). 1916 Race St., Philadelphia, PA 19103. 

Alcohol and alcohol ether sulfates have also been studied to determine their toxicity by percutaneous absorption in rats and guinea pigs [354-356]. Alcohol ether sulfates penetrate in the order of 1 ng/cm2/day and alcohol sulfates are less penetrant by a factor of 10. The surfactant absorbed was metabolized. Since it is known that human skin is less permeable than animal skin, only very small amounts of alcohol or alcohol ether sulfates can be absorbed even in the case of complete body exposure. 

Surfactants have a unique long-chain molecular structure composed of a hydrophilic head and hydrophobic tail. Based on the nature of the hydrophilic part surfactants are generally categorized as anionic, non-ionic, cationic, and zwitter-ionic. They all have a natural tendency to adsorb at surfaces and interfaces when added in low concentration in water. Surfactant absorption/desorption at the vapor-liquid interface alters the surface tension, which decreases continually with increasing concentrations until the critical micelle concentration (CMC), at which micelles (colloid-sized clusters or aggregates of monomers) start to form is reached (Manglik et al. 2001 Hetsroni et al. 2003c). 

For example, for alkyl (8-16) glycoside (Plantacare 818 UP) non-ionic surfactant solution of molecular weight 390 g/mol, an increase in surfactant concentration up to 300 ppm (CMC concentration) leads to a significant decrease in surface tension. In the range 300 < C < 1,200 ppm the surface tension was almost independent of concentration. In all cases an increase in liquid temperature leads to a decrease in surface tension. This surface tension relaxation is a diffusion rate-dependent process, which typically depends on the type of surfactant, its diffusion/absorption kinetics, micellar dynamics, and bulk concentration levels. As the CMC is approached the absorption becomes independent of the bulk concentration, and the surfactant... 

The luminescence of macrocrystalline cadmium and zinc sulfides has been studied very thoroughly The colloidal solutions of these compounds also fluoresce, the intensity and wavelengths of emission depending on how the colloids were prepared. We will divide the description of the fluorescence phenomena into two parts. In this section we will discuss the fluorescence of larger colloidal particles, i.e. of CdS particles which are yellow as the macrocrystalline material, and of ZnS particles whose absorption spectrum also resembles that of the macrocrystals. These colloids are obtained by precipitating CdS or ZnS in the presence of the silicon dioxide stabilizer mentioned in Sect. 3.2, or in the presence of 10 M sodium polyphosphate , or surfactants such as sodium dodecyl sulfate and cetyldimethylbenzyl-ammonium... 

Maldotti (96) studied the kinetics of the formation of the pyrazine-bridged Fe(II) porphyrin shish-kebab polymer by means of flash kinetic experiments. Upon irradiation of a deaerated alkaline water/ethanol solution of Fe(III) protoporphyrin IX and pyrazine with a short intense flash of light, the 2 1 Fe(II) porphyrin (pyrazine)2 complex is formed, but it immediately polymerizes with second-order kinetics. This can be monitored in the UV-Vis absorption spectrum, with the disappearance of a band at 550 nm together with the emergence of a new band due to the polymer at 800 nm. The process is accelerated by the addition of LiCl, which augments hydrophobic interactions, and is diminished by the presence of a surfactant. A shish-kebab polymer is also formed upon photoreduction of Fe(III) porphyrins in presence of piperazine or 4,4 -bipyridine ligands (97). 

---