Ablation, energy source

In ICP-AES and ICP-MS, sample mineralisation is the Achilles heel. Sample introduction systems for ICP-AES are numerous gas-phase introduction, pneumatic nebulisation (PN), direct-injection nebulisation (DIN), thermal spray, ultrasonic nebulisation (USN), electrothermal vaporisation (ETV) (furnace, cup, filament), hydride generation, electroerosion, laser ablation and direct sample insertion. Atomisation is an essential process in many fields where a dispersion of liquid particles in a gas is required. Pneumatic nebulisation is most commonly used in conjunction with a spray chamber that serves as a droplet separator, allowing droplets with average diameters of typically <10 xm to pass and enter the ICP. Spray chambers, which reduce solvent load and deal with coarse aerosols, should be as small as possible (micro-nebulisation [177]). Direct injection in the plasma torch is feasible [178]. Ultrasonic atomisers are designed to specifically operate from a vibrational energy source [179]. 

Inertial Confinement. In the inertial approach, the fuel is heated as it is compressed to a very high density, estimated at about I(KK) times that or the normal density of the solid fuel. An intense energy source is focused onto Ihe outer surface of a specially formed spherical pellet. This produces ablation on the outer surface somewhat similar lo the ablation of a rocket as it is exposed to extremely high temperatures. The energy also causes an implosion (an inward bursting) of the deuterium-tritium fuel mixture in the inneT portion of Ihe pellet. The compression process heats the fuel to ignition temperature and also contributes to the quantity of fuel that can be burned. Inasmuch as the compressed fuel is restrained by its own inertia, the fuel hums before it can fly apart. This is a time span of a billionth of a second or less. ... 

Much of the energy deposited in a sample by a laser pulse or beam ablates as neutral material and not ions. Ordinarily, the neutral substances are simply pumped away, and the ions are analyzed by the mass spectrometer. To increase the number of ions formed, there is often a second ion source to produce ions from the neutral materials, thereby enhancing the total ion yield. This secondary or additional mode of ionization can be effected by electrons (electron ionization, El), reagent gases (chemical ionization. Cl), a plasma torch, or even a second laser pulse. The additional ionization is often organized as a pulse (electrons, reagent gas, or laser) that follows very shortly after the... 

Figure 6. Schematic outline of the first commercially available multiple collector ICPMS, the Plasma 54, after Halhday et al. (1995). This instrument uses Nier-Johnson double-focusing and is equipped with eight independently adjustable Faraday collectors. The axial collector can be wound down to provide access to a Daly detector equipped with ion counting capabilities and a second-stage energy filter for high abundance sensitivity measurements. The sample may be introduced to the plasma source by either solution aspiration or laser ablation.

There have been fewer studies of the reactions of M ions with potential ligand molecules. Laser ablation, which has been the major ionization source for the production of bare metal ions, produces very few negative ions. Electron impact with low-energy electrons (12 eV) of metal carbonyls has been used to produce [Co(CO)4]- and Fc( CO)4 from Co2(CO)8 and Fe(CO)5. Collision-induced dissociation of these two anions produced Co- and Fc, which could be isolated. Both Co- and Fe were reacted with H2S, aliphatic thiols, aromatic thiols, CS2, and disulfides (153). Reactions with H2S gave the metal monosulfide anion [MS]-, which reacted with H2S by two pathways. 

---