Wet abrasive blasting

Abrasive wet blasting is variation of abrasive particle-air blasting that involves introducing abrasives into a rapidly moving stream of water and air. The combination obviously cuts down on the atmospheric pollution experienced when using the dry abrasive alone. Inhibitors are often added to the water to reduce rusting of the clean steel before the prime coat is applied. 

Wet abrasive blast cleaning systems commonly encountered include air, water, or abrasive blast cleaning, which uses compressed air to propel the abrasive pressurized water or abrasive blast cleaning, which uses water to propel the abrasive and a combination of pressurized water or pressurized air with abrasives. The abrasive defines the profile. 

---

Dry abrasive blast cleaning should be used on new steelwork where the main contaminant is mill scale. For heavily rusted and pitted steelwork, increased durability can be obtained by the use of wet abrasive blasting where this is practicable. The water will be more effective in removing the potentially destructive and corrosive soluble iron-corrosion products that form at the bottom of corrosion pits. 

After major surface contaminants have been removed, e.g. by wet abrasive blasting of hot-rolled structural steel, application of a thin coat of an etch primer greatly reduces the incidence of underfilm corrosion, presumably by eleminating localised areas of poor adhesion. Phosphate pretreatments followed by effective rinsing have a similar effect over cold reduced sheets. 

Abrasive treatments consist of scouring, machining, hand sanding, and dry and wet abrasive blasting. The abrasive medium can be fine sandpaper, carborundum or alumina abrasives, metal wools, or abrasive shot. Mechanical abrasion is usually preceded and followed by solvent cleaning. The choice is generally determined by available production facilities and cost. 

Wet abrasive blast cleaning Compressed air propels abrasive against the surface. Water is injected into the abrasive stream either before or after the abrasive exits the nozzle. The abrasive, paint debris, and water are collected for disposal. 

Most painting contractors are not familiar with this method but, because of similarities to wet abrasive blasting and hydrojetting, they can easily adjust. Because the water mitigates the dust, exposure to airborne lead emissions is significantly reduced but not eliminated ingestion hazards still exist [15],... 

Abrasive treatments consist of scouring, machining, hand sanding, and dry and wet abrasive blasting. The choice is generally determined by available production facihties and... 

Polyimide (Vespel (A) Degrease in trichloroethane (A) Abrade with diy or wet abrasive blast. (A) ... 

Abrade with fine-grit (180—400 grit) sandpaper, or use abrasive scouring with small amounts of water, dry-grit blasting, or wet abrasive blasting... 

---