Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Welding-neck flanges

If fhe bore of a welding neck flange IS smaller then the pipe bore, it must be tapered ot on ongle to motch. [Pg.954]

Butt-welded joint, reducer, or weld-neck flange Double-welded slip-on flange Fillet welded joint or pocket-weld flange... [Pg.1000]

OUTSIDE PROJECTION, INCHES USING WELDING NECK FLANGE... [Pg.344]

Steel welding-neck flanges for nominal pressure ratings of 6, 10, 25, 40 bar. [Pg.960]

STEEL WELDING NECK FLANGES Nominal pressure 6 bar (1 bar = 105 N/m2)... [Pg.961]

Welding neck flanges are permitted in sizes and pressure classes established in ASME B16.5, MSS SP-44, and ASME B16.47 for large flanges. The bore of the flange should correspond to the inside diameter of the pipe used. For allowable weld end detail, see para. GR-3.4.5. [Pg.134]

Attachment of suction and discharge nozzles shall be by means of full-fusion, full-penetration welds. Weld neck flanges are required for pumps handling flammable or hazardous liquids. Dissimilar metal weldments are not allowed. [Pg.40]

Figure 1332. standard flange dimensions for welding neck flanges based on ASME B16.5 Annex F. [Pg.1029]

See other pages where Welding-neck flanges is mentioned: [Pg.953]    [Pg.955]    [Pg.61]    [Pg.61]    [Pg.61]    [Pg.22]    [Pg.24]    [Pg.58]    [Pg.61]    [Pg.61]    [Pg.61]    [Pg.858]    [Pg.858]    [Pg.858]    [Pg.864]    [Pg.866]    [Pg.48]    [Pg.82]    [Pg.86]    [Pg.67]    [Pg.778]    [Pg.855]    [Pg.855]    [Pg.855]    [Pg.861]    [Pg.864]    [Pg.813]    [Pg.1022]    [Pg.1022]    [Pg.1022]    [Pg.1026]   
See also in sourсe #XX -- [ Pg.858 , Pg.859 ]

See also in sourсe #XX -- [ Pg.855 ]

See also in sourсe #XX -- [ Pg.1022 ]



SEARCH



Flanges weld neck design

Neck

Weld neck flanges

Weld neck flanges

© 2024 chempedia.info