Weight loss with

The TG analysis for pure PP proves a steep weight loss with a maximum in the DTG curve placed at 520 °C, which corresponds with the thermal degradation of this polyolefin. Fig 1 and 2 show TG analysis of PP/H-ZSM5 and PP/Ti-MCM41 catalyst mixture with 10 % catalyst content. 

Antidepressants. Short-term studies of desipramine and fluoxetine indicate that both medications reduce binging in patients with BED. In addition, fluoxetine-treated patients may also experience a modest reduction in weight during short-term treatment. However, this early weight loss with fluoxetine may not be sustained despite continued treatment. 

Polymer films of approximately 1000 microns wet film thickness were laid down with a bar applicator on PTFE coated glass panels and the solvent allowed to evaporate at ambient temperature for a standard period of seven days. A typical plot of solvent weight loss with time is shown in Figure 2. The thickness of the wet film was dictated by the need to have adequate mechanical strength in the dry films in order that they might be suitable for subsequent mechanical test procedures. Dry film thicknesses were approximately 300 microns as measured by micrometer. The dried polymer films were examined by dynamic mechanical thermal analysis (DMTA) (Polymer Laboratories Ltd.). Typical DMTA data for a polymer and paint are... 

Jensen, L. B., Kollerup, G., Quaade, F., and Sorensen, O. H. (2001). Bone mineral changes in obese women during a moderate weight loss with and without calcium supplementation. JBMR 16,141-147. 

Correlations between the changes seen (e.g., correlation of early maternal weight loss with resorption incidence). 

Figure 3.15 Comparison of model prediction weight loss with time.

Weight loss with topiramate can occasionally be extensive (1127). 

Rotatori AF, Fox R, Wicks A. Weight loss with psychiatric residents in a behavioral self control program. Psychol Rep 1980 46(2) 483-6. 

Wirth A, Krause J (2001) Long-term weight loss with sibutramine a randomized controlled trial. Jama 286 1331-1339... 

Figure 1.36 Oxidation rate loss showing weight gain and weight loss with different kinetic forms. (Reproduced from Corrosion for Science and Engineering, Tretheway and Chamberlain, Copyright Pearson Education Ltd)...

Differential rate of weight loss vs. weight fraction plots indicate reaction orders between 0 and 1. Only minor differences between some artificially aged and control pulps were noted, whereas other pulp types showed an increased rate of weight loss with a slight displacement of the thermograms toward lower temperatures. No clear-cut interpretation of these differences is yet possible. 

Gasoline was the most active solvent, causing a 19% weight loss of asphaltic concrete compared with a 4% loss for 35-vol % sulfur-asphalt concrete using immersion testing. Jet and diesel fuels each had solvent actions that resulted in a 6% weight loss with normal paving compared with a 1% loss with 35-vol % sulfur-asphalt concrete. 

From TG/DTA analysis of the dried resin with Fe, the resin was found to show a major weight loss with an exothermic thermal decomposition at 473 873 K followed by a slight endothermic weight decrease at above 873K. About 20wt% of the carbonized resin remained at 1273K. 

---