Vibrational spectroscopy inelastic scattering

Supplementary to other vibrational spectroscopies, inelastic neutron scattering (INS) spectroscopy is a very useful technique for studying organic molecules as it is extremely sensitive to the vibrations of hydrogen atoms. INS spectroscopy has been used to analyze the molecular dynamics of the energetic compound ANTA 5 <2005CPL(403)329>. 

M.H. Herzog-Cance, D.J. Jones, R.E1. Mejjad, J. Roziere J. Tomkinson (1992). J. Chem. Soc. Faraday Trans., 88, 2275-2281. Study of ion exchange and intercalation of organic bases in layered substrates by vibrational spectroscopy. Inelastic neutron scattering, infrared and Raman spectroscopies of aniline inserted alpha and gamma zirconium hydrogen phosphates. 

Electrons interact with solid surfaces by elastic and inelastic scattering, and these interactions are employed in electron spectroscopy. For example, electrons that elastically scatter will diffract from a single-crystal lattice. The diffraction pattern can be used as a means of stnictural detenuination, as in FEED. Electrons scatter inelastically by inducing electronic and vibrational excitations in the surface region. These losses fonu the basis of electron energy loss spectroscopy (EELS). An incident electron can also knock out an iimer-shell, or core, electron from an atom in the solid that will, in turn, initiate an Auger process. Electrons can also be used to induce stimulated desorption, as described in section Al.7.5.6. 

Vibrational spectroscopy provides detailed infonnation on both structure and dynamics of molecular species. Infrared (IR) and Raman spectroscopy are the most connnonly used methods, and will be covered in detail in this chapter. There exist other methods to obtain vibrational spectra, but those are somewhat more specialized and used less often. They are discussed in other chapters, and include inelastic neutron scattering (INS), helium atom scattering, electron energy loss spectroscopy (EELS), photoelectron spectroscopy, among others. 

Perhaps the best known and most used optical spectroscopy which relies on the use of lasers is Raman spectroscopy. Because Raman spectroscopy is based on the inelastic scattering of photons, the signals are usually weak, and are often masked by fluorescence and/or Rayleigh scattering processes. The interest in usmg Raman for the vibrational characterization of surfaces arises from the fact that the teclmique can be used in situ under non-vacuum enviromnents, and also because it follows selection rules that complement those of IR spectroscopy. 

Kearley, G. J., Pressman, H. A. Slade, R. C. T. (1986). The geometry of the HjOJ ion in dodecatungstophosphoric acid hexahydrate, (HjOJ)j (PWjjOfo), studied by inelastic neutron scattering vibrational spectroscopy. Journal of the Chemical Society Chemical Communications, 1801-2. 

In either case, the information on the vibrational transition is contained in the energy difference between the excitation radiation and the inelastically scattered Raman photons. Consequently, the parameters of interest are the intensities of the lines and their position relative to the Rayleigh line, usually expressed in wavenumbers (cm 1). As the actually recorded emissions all are in the spectral range determined by the excitation radiation, Raman spectroscopy facilitates the acquisition of vibrational spectra through standard VIS and/or NIR spectroscopy. 

Another technique of vibrational spectroscopy suited for the characterization of solids is that of Raman spectroscopy. In this methodology, the sample is irradiated with monochromatic laser radiation, and the inelastic scattering of the source energy is used to obtain a vibrational spectrum of the analyte [20]. Since... 

Inelastic scattering of light due to the excitation of vibrations had already been predicted in 1923 [37] and was confirmed experimentally a few years later by Raman [38], Because at that time the Raman effect was much easier to measure than infrared absorption, Raman spectroscopy dominated the field of molecular structure determination until commercial infrared spectrometers became available in the 1940s [10]. 

Infrared and Raman spectroscopy are related by the fact that both permit the detection of bond vibrations. Like IR spectroscopy, the spectral bands are reported in cnT1. An important difference is that the wavelength and intensity of inelastically scattered light is measured in the Raman spectroscopic method. The Raman effect causes the scattered radiation to shift according to the energies of molecular vibrations. Although Raman spectroscopy involves a physical principle different from that in IR spectroscopy, the two techniques are complementary. 

---