Vesicle interfacial potentials

All three methods give similar values of interfacial potentials typical results for some of micelles and vesicles are listed in Table 3. Also listed are estimates of interfacial dielectric constants (e), determined by comparing the position of absorption bands of solvatochromic indicators in the surfactant assemblies with that of reference 1,4-dioxane water mixtures with known e values. More generally, luminescence probe analysis [49], thermal leasing [50] and absorption spectroscopy [47, 51] are techniques that have all been utilized to measure local polarities in micelles and vesicles. It is important to note that these methods presume knowledge of the loca-... 

These examples should serve to underscore the difficulty in predicting the effects that interfacial potentials, membrane structure and microphase organization will have on electron-transfer reactions across the membrane interface and within the bilayer itself. The principles involved are common to micelles and vesicles, but the more anisotropic and highly ordered vesicles provide a more complex reaction environment for solubilized or adsorbed reactants. 

Functionalized polyelectrolytes are promising candidates for photoinduced ET reaction systems. In recent years, much attention has been focused on modifying the photophysical and photochemical processes by use of polyelectrolyte systems, because dramatic effects are often brought about by the interfacial electrostatic potential and/or the existence of microphase structures in such systems [10, 11], A characteristic feature of polymers as reaction media, in general, lies in the potential that they make a wider variety of molecular designs possible than the conventional organized molecular assemblies such as surfactant micelles and vesicles. From a practical point of view, polymer systems have a potential advantage in that polymers per se can form film and may be assembled into a variety of devices and systems with ease. 

As mentioned earlier, a great deal of literature has dealt with the properties of heterogeneous liquid systems such as microemulsions, micelles, vesicles, and lipid bilayers in photosynthetic processes [114,115,119]. At externally polarizable ITIES, the control on the Galvani potential difference offers an extra variable, which allows tuning reaction paths and rates. For instance, the rather high interfacial reactivity of photoexcited porphyrin species has proved to be able to promote processes such as the one shown in Fig. 3(b). The inhibition of back ET upon addition of hexacyanoferrate in the photoreaction of Fig. 17 is an example of a photosynthetic reaction at polarizable ITIES [87,166]. At Galvani potential differences close to 0 V, a direct redox reaction involving an equimolar ratio of the hexacyanoferrate couple and TCNQ features an uphill ET of approximately 0.10 eV (see Fig. 4). However, the excited state of the porphyrin heterodimer can readily inject an electron into TCNQ and subsequently receive an electron from ferrocyanide. For illumination at 543 nm (2.3 eV), the overall photoprocess corresponds to a 4% conversion efficiency. 

Abstract Vesicles prepared with synthetic amphiphiles constitute useful microreactors, where reaction rates can be delicately controlled. Here we review our work on quantitative analysis of reaction rates in vesicles and show that reaction at several vesicular sites can be probed and controlled. Vesicles prepared with dialkyldimethylammonium halides, (DODA)X, can accelerate bimolecular reactions by more than a million fold. Quantitative analysis of the vesicular effect on ester thiolysis, using a pseudophase ion exchange formaUsm, suggests that the rate increase is primarily due to reagent concentration in the bilayer and interfacial effects on ion distribution, as well as contributions from enhanced nucleophile reactivity. Vesicle-containing solutions exhibit a variety of potential reaction sites the inner and outer surfaces, bilayer and internal aqueous compartment. 

---