Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Uncompensated

Owing to the various uncompensated charges at the hiterface tliere will be associated changes in the potential, but there are subtleties about what can actually be measured that need some attention. [Pg.586]

Figure Bl.28.8. Equivalent circuit for a tliree-electrode electrochemical cell. WE, CE and RE represent the working, counter and reference electrodes is the solution resistance, the uncompensated resistance, R the charge-transfer resistance, R the resistance of the reference electrode, the double-layer capacitance and the parasitic loss to tire ground. Figure Bl.28.8. Equivalent circuit for a tliree-electrode electrochemical cell. WE, CE and RE represent the working, counter and reference electrodes is the solution resistance, the uncompensated resistance, R the charge-transfer resistance, R the resistance of the reference electrode, the double-layer capacitance and the parasitic loss to tire ground.
Ringer s lactate, in which lactate is added to Ringer s solution, is probably the most popular crystalloid (salt) solution for intravenous use in humans. The lactate is gradually converted to sodium bicarbonate within the body so that an uncompensated alkalosis is prevented (13). These crystalloid solutions cannot support life without red cells saline passes rather quickly into the tissue spaces of various organs (14), especially the Hver (15). [Pg.160]

Figure 24.5 Receiving-end voltage phasor diagram on load, in an uncompensated line... Figure 24.5 Receiving-end voltage phasor diagram on load, in an uncompensated line...
For the system to remain stable under all conditions of loading, switching, or any other line disturbances it is essential that an uncompensated line is loaded at much below this level. Otherwise disturbances of a minor nature may result in undampened oscillations, and may even swing the receiving-end voltage beyond acceptable limits. It may even cause an outage of the system. It is therefore not practicable to operate an uncompensated line to its optimum level. For this we will analyse this equation for sin 0 and sin S as follows. [Pg.794]

A study of various systems has revealed that the load angle for an uncompensated line should be maintained at about 30° only. This means that an uncompensated line may be loaded to just nearly half its steady-state level to retain a high level of stability during load fluctuations, particularly during light loads or load rejections, switching of large inductive loads or any type of minor or major line fault. [Pg.794]

Figure 24.21 A comparative study of load transfers for different line lengths at different p.fs. for an uncompensated line... Figure 24.21 A comparative study of load transfers for different line lengths at different p.fs. for an uncompensated line...
Reactive control can alter the line length ( f LC) to the level at which the system will have the least possible swings. It is evident from these curves that an uncompensated line of a much shorter length may not be able, to transfer even its natural load (Pq) successfully. This is due to the steeply drooping characteristics of the voltage profile at about this load point, which may subject the... [Pg.796]

Application of series capacitors and analysis of an uncompensated transmission line and the capability of power transfer and system regulation with and without series compensation are also presented. [Pg.990]

Fig. 6.33 Nichols chart for uncompensated laser guided missile. Fig. 6.33 Nichols chart for uncompensated laser guided missile.
The Nichols chart for the uncompensated and compensated system (curve (a)) is shown in Figure 6.34 (see also Appendix, fig634.m). From Figure 6.34, curve (a)... [Pg.184]

Figure 6.35 shows the Bode gain and phase for both compensated and uncompensated systems. From Figure 6.35, it can be seen that by reducing the open-loop gain by 5.4dB, the original modulus crossover frequency, where the phase advance is a maximum, can be attained. [Pg.184]

The compensated and uncompensated open-loop frequency response is shown in Figure 6.41. From this Figure the compensated gain margin is 12.5 dB, and the phase margin is 48°. In equation (6.117), K does not need to be adjusted, and can be set to unity. When responding to a step input, the steady-state error is now 4.6%. [Pg.191]

Fig. 6.41 Lag compensated and uncompensated open-loop bode diagram for Example 6.7. Fig. 6.41 Lag compensated and uncompensated open-loop bode diagram for Example 6.7.
Figure 6.34 is generated usmgfig634.m and shows the Nichols Chart for the uncompensated system. Curve (a) is when the compensator gain K =, and curve (b) is when K = 0.537 (a gain reduction of 5.4dB). [Pg.396]

A number of groups have criticized the ideas of Dauben and Noyce, especially the concept of PDC. Kamernitzsky and Akhrem, " in a thorough survey of the stereochemistry of addition reactions to carbonyl groups, accepted the existence of SAC but not of PDC. They point out that the reactions involve low energies of activation (10-13 kcal/mole) and suggest that differences in stereochemistry involve differences in entropies of activation. The effect favoring the equatorial alcohols is attributed to an electrostatic or polar factor (see also ref. 189) which may be determined by a difference in the electrostatic fields on the upper and lower sides of the carbonyl double bond, connected, for example, with the uncompensated dipole moments of the C—H bonds. The way this polar effect is supposed to influence the attack of the hydride is not made clear. [Pg.69]

Finally, the total charge per unit area due to the uncompensated donors in the depletion region is given by... [Pg.246]

The magnitude on the left is the heat absorbed in the isothermal change, and of the two expressions on the right the first is dependent only on the initial and final states, and may be called the compensated heat, whilst the second depends on the path, is always negative, except in the limiting case of reversibility, and may be called the uncompensated heat. From (3) we can derive the necessary and sufficient condition of equilibrium in a system at constant temperature. [Pg.96]

It should be pointed out that not all of the iR drop is removed by the potentiostatic control. Some fraction, called iRu (where Ru is the uncompensated solution resistance between the reference and working electrodes) will still be included in the measured potential. This component may be significantly large when resistive nonaqueous media are used, and thus may lead to severe distortion of the... [Pg.105]

Quantitatively, however, it is evident that directly measured A0 values are on average 0.2 to 0.3 eV higher than AX values. This shift in the potential scale has been discussed by Trasatti,31 34 who has attributed such a systematic difference to the different conditions of measurement (different temperatures, nonequivalence between thin water layers and bulk water, uncompensated partial charge transfer in UHV). For a more detailed discussion, the reader is referred to the original papers. [Pg.170]

Figure 15 shows a set of complex plane impedance plots for polypyr-rolein NaC104(aq).170 These data sets are all relatively simple because the electronic resistance of the film and the charge-transfer resistance are both negligible relative to the uncompensated solution resistance (Rs) and the film s ionic resistance (Rj). They can be approximated quite well by the transmission line circuit shown in Fig. 16, which can represent a variety of physical/chemical/morphological cases from redox polymers171 to porous electrodes.172... [Pg.577]

Figure 16. General transmission-line model for a conducting polymer-coated electrode. CF is the faradaic pseudo-capacitance of the polymer film, while Rt and Rt are its electronic and ionic resistance, respectively. R, is the uncompensated solution resistance. Figure 16. General transmission-line model for a conducting polymer-coated electrode. CF is the faradaic pseudo-capacitance of the polymer film, while Rt and Rt are its electronic and ionic resistance, respectively. R, is the uncompensated solution resistance.
Figure 4.10. Use of the current interruption technique to measure the uncompensated ohmic drop, T 0hmic,wr> between the working (W) and reference (R) electrode. Figure 4.10. Use of the current interruption technique to measure the uncompensated ohmic drop, T 0hmic,wr> between the working (W) and reference (R) electrode.

See other pages where Uncompensated is mentioned: [Pg.279]    [Pg.114]    [Pg.51]    [Pg.502]    [Pg.782]    [Pg.783]    [Pg.783]    [Pg.785]    [Pg.793]    [Pg.794]    [Pg.795]    [Pg.802]    [Pg.396]    [Pg.67]    [Pg.67]    [Pg.100]    [Pg.504]    [Pg.464]    [Pg.161]    [Pg.205]    [Pg.96]    [Pg.543]    [Pg.22]    [Pg.209]    [Pg.575]   
See also in sourсe #XX -- [ Pg.35 ]




SEARCH



Acidosis uncompensated metabolic

Calculating the Uncompensated Solution Resistance for a Few Simple Geometries

Clients. Owners, and Customers about Avoiding Uncompensated Scope Creep

Creation of uncompensated heat

Effects Due to Uncompensated Resistance and Capacitance

Preventing Uncompensated Scope Creep

Reasons for uncompensated damage

Resistance uncompensated

Resolving Uncompensated Scope Creep

Uncompensated Scope Creep

Uncompensated electrolyte resistance

Uncompensated heat

Uncompensated heat, Clausius

Uncompensated metal

Uncompensated ohmic drops

Uncompensated resistance systems

Uncompensated respiratory

Uncompensated solution resistance

Uncompensated solution resistance in NPSV

Uncompensated spins

Uncompensated transformations

Uncompensated transmission lines

Voltammetry uncompensated resistance

© 2024 chempedia.info