Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Transverse optical branch

This band called iTOLA because it is attributed to a combination of two intra-valley phonons the first from the in-plane transverse optical branch (iTO) and the second phonon from the longitudinal acoustic (LA) branch, iTO-t-LA, where the acoustic LA phonon is responsible for the large dispersion that is observed experimentally [69]. [Pg.145]

Fig. A.5-22 BaTiOs. Phonon dispersion relation determined by neutron scattering along the [100] direction in the cubic phase, v is the phonon frequency. LA, longitudinal acoustic branch TA, transverse acoustic branch TO, transverse optical branch. The frequency of the TO branch is lower (softer) at 230 °C than at 430 " C, indicating mode softening... Fig. A.5-22 BaTiOs. Phonon dispersion relation determined by neutron scattering along the [100] direction in the cubic phase, v is the phonon frequency. LA, longitudinal acoustic branch TA, transverse acoustic branch TO, transverse optical branch. The frequency of the TO branch is lower (softer) at 230 °C than at 430 " C, indicating mode softening...
Hereby, the branches with E - and / -symmetry are twofold degenerated. Both A - and / d-modes are polar, and split into transverse optical (TO) and longitudinal optical (LO) phonons with different frequencies wto and wlo, respectively, because of the macroscopic electric fields associated with the LO phonons. The short-range interatomic forces cause anisotropy, and A - and / d-modcs possess, therefore, different frequencies. The electrostatic forces dominate the anisotropy in the short-range forces in ZnO, such that the TO-LO splitting is larger than the A -E splitting. For the lattice vibrations with Ai- and F -symmetry, the atoms move parallel and perpendicular to the c-axis, respectively (Fig. 3.2). [Pg.83]

Indium nitride has twelve phonon modes at the zone centre (symmetry group Cev), three acoustic and nine optical with the acoustic branches essentially zero at k = 0. The infrared active modes are Ei(LO), Ei(TO), Ai(LO) and Ai(TO). A transverse optical mode has been identified at 478 cm 1 (59.3 meV) by reflectance [6] and 460 cm 1 (57.1 meV) by transmission [24], In both reports the location of a longitudinal optical mode is inferred from the Brout sum rule, giving respective values of 694 cm 1 (86.1 meV) and 719 cm 1 (89.2 meV). Raman scattering of single crystalline wurtzite InN reveals Ai(LO) and E22 peaks at 596 cm 1 and at 495 cm 1 respectively [25],... [Pg.124]

Wurtzite ZnO structure with four atoms in the unit cell has a total of 12 phonon modes (one longitudinal acoustic (LA), two transverse acoustic (TA), three longitudinal optical (LO), and six transverse optical (TO) branches). The optical phonons at the r point of the Brillouin zone in their irreducible representation belong to Ai and Ei branches that are both Raman and infrared active, the two nonpolar 2 branches are only Raman active, and the Bi branches are inactive (silent modes). Furthermore, the Ai and Ei modes are each spht into LO and TO components with different frequencies. For the Ai and Ei mode lattice vibrations, the atoms move parallel and perpendicular to the c-axis, respectively. On the other hand, 2 modes are due to the vibration of only the Zn sublattice ( 2-low) or O sublattice ( 2-high). The expected Raman peaks for bulk ZnO are at 101 cm ( 2-low), 380 cm (Ai-TO), 407 cm ( i-TO), 437 cm ( 2-high), and 583 cm ( j-LO). [Pg.429]

The dispersion curves are conveniently labelled in Fig. 5.1, the transverse acoustic (TA) and longitudinal acoustic (LA) branches are seen rising from the Brillouin zone centre at zero energy transfer. The optical branches (TO, LO) lie fairly flat across the zone in the energy range about 150 to 300 cm. ... [Pg.186]

Figure 7. Bulk phonon dispersion curves for KBr and RbCl in their <100> and <111> high-symmetry directions. Both crystals have fee lattices and rocksalt structures. Note that the transverse branches, labeled TA (transverse acoustic) and TO (transverse optical), are doubly degenerate in these directions. (Adapted from Fig. 3 of Ref. 32.)... Figure 7. Bulk phonon dispersion curves for KBr and RbCl in their <100> and <111> high-symmetry directions. Both crystals have fee lattices and rocksalt structures. Note that the transverse branches, labeled TA (transverse acoustic) and TO (transverse optical), are doubly degenerate in these directions. (Adapted from Fig. 3 of Ref. 32.)...
In the case of strongly polar or concentrated species (which is typically the case for an oxide), the vibrational contribution to e(co) may become larger than Boo in the region of the resonance. The shapes of the functions -lm[g(< )] and lm[l/g(< )] then become different, the former exhibiting its maximum for (o=(Oo, whereas for the latter the maximum turns out to be shifted to a o=(coo+Ne lBoBcoR). If one considers the phonon modes in the infinite 3D material, the two modes o coq appear as the zero-wavevector limit of the transverse-optical (TO) and longitudinal-optical (LO) phonon branches, and for that reason are generally termed TO mode and LO mode [94]. [Pg.219]

Several theoretical and experimental studies assess the vibrational properties of the high-pressure phases of silicon. A group-theoretical analysis of lattice vibrations in the -tin structure has been made by Chen [98]. In the vicinity of the F point, the optical modes consist of one longitudinal optical (LO) branch and at higher frequencies of a doubly degenerate transverse optical (TO) branch, both of which are Raman active. Zone-center phonon frequencies of Si-11 have been calculated as a function of pressure using the ab initio pseudopotential method... [Pg.374]

Some interesting and important conclusions were drawn by separating the phonon spectrum in accordance with the polarization of the oscillations [15]. The whole spectrum was divided into six branches, each of which has an almost Gaussian form of the distribution curve g( ). For cubic crystals, these six branches consist of three acoustical branches (one branch of longitudinal and two branches of transverse waves) and three optical branches (one longitudinal and two transverse waves). The acoustical vibrations can be compared with the vibrations of atoms in a unit cell, and the optical vibrations with mutual oscillations of the sublattices in relation to one another. The curves of the density distribution of oscillations in each [Pg.180]

Fig. 9. Magnon dispersion for Tb in the ferromagnetic phase along the three principal axis directions. Symbols along the top of the diagram label the directions in the conventional notation shown in fig. 4. Dashed curves labelled PH are [longitudinal acoustic (LA), transverse acoustic (TA), and transverse optic (TO)] phonon branches which interact with the magnons. (After Mackintosh and Bjerrum-Moller 1972.)... Fig. 9. Magnon dispersion for Tb in the ferromagnetic phase along the three principal axis directions. Symbols along the top of the diagram label the directions in the conventional notation shown in fig. 4. Dashed curves labelled PH are [longitudinal acoustic (LA), transverse acoustic (TA), and transverse optic (TO)] phonon branches which interact with the magnons. (After Mackintosh and Bjerrum-Moller 1972.)...
Fig. 6.5 Vibrations of a linear atomic structure. Note TO transverse vibrations of then optical branch LO longitudinal vibrations of the optical branch TA transverse vibrations of the acoustic branch LA longitudinal vibrations of the acoustic branch. The frequency and energy of vibrations normally increase in the sequence LA < TA < LO < TO at each wavelength... Fig. 6.5 Vibrations of a linear atomic structure. Note TO transverse vibrations of then optical branch LO longitudinal vibrations of the optical branch TA transverse vibrations of the acoustic branch LA longitudinal vibrations of the acoustic branch. The frequency and energy of vibrations normally increase in the sequence LA < TA < LO < TO at each wavelength...
A very efficient coupling between photons and transverse phonons can occur in the vicinity of fc = 0 in the optical branch leading to strong absorption at frequencies given by... [Pg.320]

We denote this natural frequency as coj, symbolizing this as the frequency of the transverse phonon spectrum in the optical branch. Putting this back into the particular solution (Equation 23.13),... [Pg.443]

It is evident Irom Fig. 10 that there are six distinct phonon modes in the monolayer graphite. The LO branch is a longitudinal optical mode. The LA branch is a longitudinal acousticlike mode. The ZO branch is a vertically vibrating transverse optical mode. The ZA branch is a vertically vibrating acoustic-like mode. The SHO branch is a shear horizontal optical mode. The SHA is a shear horizontal acoustic-like mode. The last two SH modes appear because of the lack of mirror symmetry in these experiments (39). [Pg.279]

Lattice vibrations are also classified as optical branch and acoustical branch modes or as transverse optical (TO) and longitudinal optical (LO) modes. These are not important to us. Lattice vibrations disappear if the crystal is destroyed by any means—e.g., by melting or solution. They are a cooperative phenomenon of a highly ordered system. [Pg.354]

In the spectra of CdSe, three modes at 258, 359 and 950 cm are clearly observed. In general, the LO and TO phonons are observed along with the surface modes in polar nanocrystals in resonance Raman spectra and/or surface enhanced Raman spectra [275]. However, LO and TO modes are observed simultaneously only in randomly oriented nanoparticles. Resonance Raman Spectra (RRS) of CdTe nanoparticles give band due to Longitudinal optical (LO) phonons at 170 cm (LO), 340 cm (2LO) and 510 cm (3LO) mode frequency is found to shift due to quantum confinement effect and confined phonons are observed using surface enhanced Raman spectroscopy [275]. Transverse optic (TO) phonon is reported at 145 cm and its position is invariant with decreasing particle size as the dispersion curve for TO phonon branch is almost fiat [275]. In CdSe nanoparticles, LO phonons are reported in the range 180- 200 cm, wheras in ZnSe at 140 cm [Ref. 275 and references therein]. Thus, the Raman spectra observed in the present work well identifies the phonons in these nanoparticles. [Pg.216]

The results are shown in Fig. 2.26. Thus, for the three-dimensional motion of a diatomic chain there is one pair of dispersion curves (one acoustical and one optical branch) for each direction in space. In the three-dimensional motions of a diatomic chain, the transverse directions x and y are equivalent. Consequently, only one transverse optic and acoustic dispersion curve is displayed, as they are degenerate (i.e., have the energy or vibrational motion). [Pg.70]


See other pages where Transverse optical branch is mentioned: [Pg.19]    [Pg.19]    [Pg.104]    [Pg.37]    [Pg.529]    [Pg.383]    [Pg.386]    [Pg.174]    [Pg.163]    [Pg.141]    [Pg.143]    [Pg.163]    [Pg.174]    [Pg.72]    [Pg.33]    [Pg.507]    [Pg.284]    [Pg.318]    [Pg.108]    [Pg.108]    [Pg.339]    [Pg.38]    [Pg.23]    [Pg.24]    [Pg.84]    [Pg.76]    [Pg.281]    [Pg.274]   
See also in sourсe #XX -- [ Pg.915 ]

See also in sourсe #XX -- [ Pg.915 ]




SEARCH



Optical branches

Transversal optical

Transverse optic

© 2024 chempedia.info