Diffusion coefficient translational

Sun Y-P and Saltiel J 1989 Application of the Kramers equation to stiibene photoisomerization in / -alkanes using translational diffusion coefficients to define microviscosity J. Phys. Chem. 93 8310-16... 

The hydrodynamic radius reflects the effect of coil size on polymer transport properties and can be determined from the sedimentation or diffusion coefficients at infinite dilution from the relation Rh = kBT/6itri5D (D = translational diffusion coefficient extrapolated to zero concentration, kB = Boltzmann constant, T = absolute temperature and r s = solvent viscosity). 

Dynamic light scattering (DLS) Translational diffusion coefficient, hydrodynamic or Stokes radius branching information (when Rh used with Rg) Fixed 90° angle instruments not suitable for polysaccharides. Multi-angle instrument necessary. [3]... 

In this relation a(r, t) is the experimentally observed signal, s represents random noise, axi r) represents the time invariant systematic noise and aRi(f) the radial invariant systematic noise Schuck [42] and Dam and Schuck [43] describe how this systematic noise is ehminated. x is the normahsed concentration at r and t for a given sedimenting species of sedimentation coefficient 5 and translational diffusion coefficient D it is normalised to the initial loading concentration so it is dimensionless. 

It is possible to get molecular weight from the sedimentation coefficient if we assiune a conformation or if we combine with other measurements, namely the translational diffusion coefficient via the Svedberg equation [50]... 

The translational diffusion coefficient in Eq. 11 can in principle be measured from boimdary spreading as manifested for example in the width of the g (s) profiles although for monodisperse proteins this works well, for polysaccharides interpretation is seriously complicated by broadening through polydispersity. Instead special cells can be used which allow for the formation of an artificial boundary whose diffusion can be recorded with time at low speed ( 3000 rev/min). This procedure has been successfully employed for example in a recent study on heparin fractions [5]. Dynamic fight scattering has been used as a popular alternative, and a good demonstra-... 

A number of bulk simulations have attempted to study the dynamic properties of liquid crystal phases. The simplest property to calculate is the translational diffusion coefficient D, that can be found through the Einstein relation, which applies at long times t ... 

Ionic, polar and amphiphilic solubilizates are forced to reside for relatively long times in very small compartments within the micelle (intramicellar confinement, compart-mentalization) involving low translational diffusion coefficients and enhancement of correlation times. 

We have applied FCS to the measurement of local temperature in a small area in solution under laser trapping conditions. The translational diffusion coefficient of a solute molecule is dependent on the temperature of the solution. The diffusion coefficient determined by FCS can provide the temperature in the small area. This method needs no contact of the solution and the extremely dilute concentration of dye does not disturb the sample. In addition, the FCS optical set-up allows spatial resolution less than 400 nm in a plane orthogonal to the optical axis. In the following, we will present the experimental set-up, principle of the measurement, and one of the applications of this method to the quantitative evaluation of temperature elevation accompanying optical tweezers. 

Under the condition that the Stokes-Einstein model holds, the translational diffusion coefficient, D, can be represented by Eq. (8.3). the diffusion time, Xd, obtained through the analysis is given by Eq. (8.4). 

Calibration of the MC time step in the simulation on the 2nnd lattice can be achieved by comparison of rr or DN with the results from a conventional MD simulation (as in the second and third columns of Table 4.8), or via comparison with a translational diffusion coefficient obtained from experiment with a... 

Zi(Air, x) and 7)(N2, x) are spin-lattice relaxation times of nitroxides in samples equilibrated with atmospheric air and nitrogen, respectively. Note that W(x) is normalized to the sample equilibrated with the atmospheric air. W(x) is proportional to the product of the local translational diffusion coefficient D(x) and the local concentration C(x) of oxygen at a depth x in the membrane, which is in equilibrium with the atmospheric air ... 

In contrast to normal diffusion, Ar2n does not grow linearly but with the square root of time. This may be considered the result of superimposing two random walks. The segment executes a random walk on the random walk given by the chain conformation. For the translational diffusion coefficient DR = kBT/ is obtained DR is inversely proportional to the number of friction-performing segments. 

Table 7. Molecular masses, functionalities, calculated and measured radii of gyration, and translational diffusion coefficients of the investigated polyisoprene stars...

A and B are instrumental factors and g(T) the electric field correlation function which is related to the translational diffusion coefficient D by... 

In the limit of infinite dilution the friction coefficient can be related to the single particle translational diffusion coefficient... 

For example, in the case of PS and applying the Smoluchowski equation [333], it is possible to estimate the precipitation time, fpr, of globules of radius R and translation diffusion coefficient D in solutions of polymer concentration cp (the number of chains per unit volume) [334]. Assuming a standard diffusion-limited aggregation process, two globules merge every time they collide in the course of Brownian motion. Thus, one can write Eq. 2 ... 

In addition to Ti and T2, which reflect the rotational motion of water, NMR can also be used to measure the translational motion of water. If an additional, relatively small (compared to B0), steady magnetic field gradient is incorporated into a pulsed NMR experimental setup, a translational diffusion coefficient (D, m2/s) can be measured (called pulsed field gradient NMR). 

Photon correlation spectroscopy (PCS) has been used extensively for the sizing of submicrometer particles and is now the accepted technique in most sizing determinations. PCS is based on the Brownian motion that colloidal particles undergo, where they are in constant, random motion due to the bombardment of solvent (or gas) molecules surrounding them. The time dependence of the fluctuations in intensity of scattered light from particles undergoing Brownian motion is a function of the size of the particles. Smaller particles move more rapidly than larger ones and the amount of movement is defined by the diffusion coefficient or translational diffusion coefficient, which can be related to size by the Stokes-Einstein equation, as described by... 

Measurement of the translational diffusion coefficient, D0, provides another measure of the hydrodynamic radius. According to the Stokes-Einstein relation... 

With the help of the Stokes-Einstein relation, the translational diffusion coefficient may be calculated according to... 

The translational diffusion coefficient on the molecular scale is then... 

In fluorescence correlation spectroscopy (FCS), the temporal fluctuations of the fluorescence intensity are recorded and analyzed in order to determine physical or chemical parameters such as translational diffusion coefficients, flow rates, chemical kinetic rate constants, rotational diffusion coefficients, molecular weights and aggregation. The principles of FCS for the determination of translational and rotational diffusion and chemical reactions were first described in the early 1970s. But it is only in the early 1990s that progress in instrumentation (confocal excitation, photon detection and correlation) generated renewed interest in FCS. 

For a single fluorescent species undergoing Brownian motion with a translational diffusion coefficient Dt (see Chapter 8, Section 8.1), the autocorrelation function, in the case of Gaussian intensity distribution in the x, y plane and infinite dimension in the z-direction, is given by... 

Translational diffusion coefficients of fluorophores like rhodamine 6G have been determined by FCS and reasonable values of 3 x 10-6 cm2 s 1 were found (Figure 11.12). Tests with latex beads showed good agreement with known values. 

The translational diffusion coefficient of micelles loaded with a fluorophore can be determined from the autocorrelation function by means of Eqs (11.8) or (11.9). The hydrodynamic radius can then be calculated using the Stokes-Einstein relation (see Chapter 8, Section 8.1) ... 

Figure Bll.2.1 shows the normalized autocorrelation functions of various micelles loaded with octadecyl rhodamine B chloride (ODRB) at pH 7 (PBS buffer)3 . The differences in size of the micelles are clearly reflected by the differences in diffusion times td- The translational diffusion coefficients are reported in Table Bll.2.1, together with the hydrodynamic radii and the aggregation numbers.

Tab. Bll.2.1. Translational diffusion coefficients, hydrodynamic volumes and aggregation numbers of various micelles loaded with ODRB...

---