Transition carbonyl complexes

The photochemistry of transition carbonyl complexes of chromium or iron with phosphirane or l//-phosphirene ligands is studied with time-dependent DFT theory to explore the propensity of the excited metal-phosphine-carbonyl complexes to expel their ligands <2003JA3558>. The complexes of these phosphorus heterocycles show similar behavior as carbonyl complexes with the PH3 ligand and they differ mainly in their enhanced a-donating ability. The calculations point that the excited complexes prefer the expulsion of the phosphorus substituents, which can be an alternative method to demetalate transition metal complexes of organophosphorus compounds. 

Tertiary stibines have been widely employed as ligands in a variety of transition metal complexes (99), and they appear to have numerous uses in synthetic organic chemistry (66), eg, for the olefination of carbonyl compounds (100). They have also been used for the formation of semiconductors by the metal—organic chemical vapor deposition process (101), as catalysts or cocatalysts for a number of polymerization reactions (102), as ingredients of light-sensitive substances (103), and for many other industrial purposes. 

Carbon monoxide [630-08-0] (qv), CO, the most important 7T-acceptor ligand, forms a host of neutral, anionic, and cationic transition-metal complexes. There is at least one known type of carbonyl derivative for every transition metal, as well as evidence supporting the existence of the carbonyls of some lanthanides (qv) and actinides (1) (see AcTINIDES AND THANSACTINIDES COORDINATION COMPOUNDS). 

Because transition metals even in a finely-divided state do not readily combine with CO, various metal salts have been used to synthesize metal carbonyls. Metal salts almost always contain the metal in a higher oxidation state than the resulting carbonyl complex. Therefore, most metal carbonyls result from the reduction of the metal in the starting material. Such a process has been referred to as reductive carbonylation. Although detailed mechanistic studies ate lacking, the process probably proceeds through stepwise reduction of the metal with simultaneous coordination of CO (90). 

There are only a few weU-documented examples of catalysis by metal clusters, and not many are to be expected as most metal clusters are fragile and fragment to give metal complexes or aggregate to give metal under reaction conditions (39). However, the metal carbonyl clusters are conceptually important because they form a bridge between catalysts commonly used in solution, ie, transition-metal complexes with single metal atoms, and catalysts commonly used on surfaces, ie, small metal particles or clusters. 

Elemental Huonne as a Legitimate Reagent for Selective Fluonnation of Orgamc Compounds Fluoroaromatic Compounds Synthesis, Reactions, and Commercial Applications New Aspects of Carbonylations Catalyzed by Transition Metal Complexes Polyfluoroaromatics An Excursion m Carbamon Chemistry ... 

Direct carbonylation of heterocycles at C—H bond catalyzed by transition metal complexes 98YGK443. 

Two commonly used synthetic methodologies for the synthesis of transition metal complexes with substituted cyclopentadienyl ligands are important. One is based on the functionalization at the ring periphery of Cp or Cp metal complexes and the other consists of the classical reaction of a suitable substituted cyclopentadienyl anion equivalent and a transition metal halide or carbonyl complex. However, a third strategy of creating a specifically substituted cyclopentadienyl ligand from smaller carbon units such as alkylidynes and alkynes within the coordination sphere is emerging and will probably find wider application [22]. 

The chemistry of carbonyl sulphide (COS) and its interaction with transition metal complexes. K. K. 

The lobes of electron density outside the C-O vector thus offer cr-donor lone-pair character. Surprisingly, carbon monoxide does not form particularly stable complexes with BF3 or with main group metals such as potassium or magnesium. Yet transition-metal complexes with carbon monoxide are known by the thousand. In all cases, the CO ligands are bound to the metal through the carbon atom and the complexes are called carbonyls. Furthermore, the metals occur most usually in low formal oxidation states. Dewar, Chatt and Duncanson have described a bonding scheme for the metal - CO interaction that successfully accounts for the formation and properties of these transition-metal carbonyls. 

Liicke et al. have prepared other phosphinated POSS compounds Tg[(CH2)2-PMe2]8 and Tg[(CH2)3-PMe2]8 by treating T8[CH = CH2]8 or T8[CH2-CH = CH2]8 with H-PMe2 under UV irradiation. The former compound has shown to have good coordination properties to carbonyl transition metal complexes such as CpMn(CO)3 (Table 15). 

Few quantitative data are available on the relative nucleophilicities of L toward various alkyl carbonyls. The rates of the reaction of CpMo(CO)3Me with L in toluene (Table II) decrease as a function of the latter reactant P( -Bu)3 > P( -OBu)j > PPhj > P(OPh)j, but the spread is relatively small (<8). The above order is that customarily observed for 8 2 reactions of low-valent transition metal complexes (J, 214). Interestingly, neither CpMo(CO)3Me nor CpFe(CO)2Me reacts with 1 or N, S, and As donor ligands 28, 79). This is in direct contrast to the insertion reactions of MeMn(CO)5 which manifest much less selectivity toward various L (see Section VI,B,C,D for details). 

Introduction to the study of transition metal complexes and their use in organic synthesis Carbonylation and related reactions... 

To this category belong, e.g., homogeneous photocatalytic systems based on soluble metal complexes or organic dyes as photocatalysts. Instructive examples are photoreactions assisted by heteropolyacids (HPAs), transition meal complexes with carbonyl, phosphine or some other ligands, and metal porphyrins. 

Besides dissociation of ligands, photoexcitation of transition metal complexes can facilitate (1) - oxidative addition to metal atoms of C-C, C-H, H-H, C-Hal, H-Si, C-0 and C-P moieties (2) - reductive elimination reactions, forming C-C, C-H, H-H, C-Hal, Hal-Hal and H-Hal moieties (3) - various rearrangements of atoms and chemical bonds in the coordination sphere of metal atoms, such as migratory insertion to C=C bonds, carbonyl and carbenes, ot- and P-elimination, a- and P-cleavage of C-C bonds, coupling of various moieties and bonds, isomerizations, etc. (see [11, 12] and refs, therein). 

IR spectroscopy of adsorbed carbon monoxide has been used extensively to characterize the diluted, reduced Cr/silica system [48-54,60,76,77]. CO is an excellent probe molecule for Cr(ll) sites because its interaction is normally rather strong. The interaction of CO with a transition metal ion can be separated into electrostatic, covalent a-dative, and 7r-back donation contributions. The first two cause a blue shift of the vco (with respect to that of the molecule in the gas phase, 2143 cm ), while the last causes a red shift [83-89]. From a measurement of the vco of a given Cr(II) carbonyl complex, information is thus obtained on the nature of the Cr(II)- CO bond. 

In the early work on the thermolysis of metal complexes for the synthesis of metal nanoparticles, the precursor carbonyl complex of transition metals, e.g., Co2(CO)8, in organic solvent functions as a metal source of nanoparticles and thermally decomposes in the presence of various polymers to afford polymer-protected metal nanoparticles under relatively mild conditions [1-3]. Particle sizes depend on the kind of polymers, ranging from 5 to >100 nm. The particle size distribution sometimes became wide. Other cobalt, iron [4], nickel [5], rhodium, iridium, rutheniuim, osmium, palladium, and platinum nanoparticles stabilized by polymers have been prepared by similar thermolysis procedures. Besides carbonyl complexes, palladium acetate, palladium acetylacetonate, and platinum acetylac-etonate were also used as a precursor complex in organic solvents like methyl-wo-butylketone [6-9]. These results proposed facile preparative method of metal nanoparticles. However, it may be considered that the size-regulated preparation of metal nanoparticles by thermolysis procedure should be conducted under the limited condition. 

---