Track Volume

Minnesota Pollution Control Agency. Tire Tracks. Volume 2, No. 3. August/September 1990. 

Fig. 5 shows the volume of the wear track in 0.5 M H2SO4 solution versus applied (or free) potential. One can observe from the figure that wear is negligible when a cathodic potential (- 0.9 V versus Ag / AgCl) is applied. At open circuit potential (OCP) some wear is measured and at an applied anodic potential the wear track volume is increasing as applied anodic potential is increased. These results suggest that the formation of oxide is indispensable to the wear process and that the wear rate is related to the oxide formation. 

Fig. 5 Wear track volume versus applied (or fi e) potential for experiments conducted in 0.5 M H2SO4...

Interfacial flow modeling Surface capturing Surface tracking Volume tracking... 

There is a basic process to track volume of products to be discontinued (retired) from the portfolio, but there are frequently write offs for raw materials and finish goods. 

There is a formal process to track volume and inventory for all products to be retired. Exceptions are identified and there are clear actions implemented to reduce product or raw material write offs, which shows a downward trend in the last 2 years. 

Volume Dielectric Dielectric Dissipation Surface Arc Tracking Volume Dielectric Dielectric Dissipation Surface Arc Tracking ... 

The main track Volume fader and the FX fader can operate as another set of Dry/Wet faders to control the mix of the effect. By default. Assignable FX are applied after the track volume is set (Post Volume), which means that if the track volume is set to —Inf., nothing leaves the track to be processed by the Assignable FX. Right-click the Multipurpose Fader and change when the Assignable FX is processed by selecting Pre Volume. 

Figure 7. Plot of the wear track volume as a function of the corresponding anodic volumes determined on independent tribocorrison tests of carbon steel under applied passive potential in different solutions (data from reference[9j).

This is a fairly accurate and convenient method for measuring the surface tension of a liquid-vapor or liquid-liquid interface. The procedure, in its simpli-est form, is to form drops of the liquid at the end of a tube, allowing them to fall into a container until enough have been collected to accurately determine the weight per drop. Recently developed computer-controlled devices track individual drop volumes to = 0.1 p [32]. 

A recent design of the maximum bubble pressure instrument for measurement of dynamic surface tension allows resolution in the millisecond time frame [119, 120]. This was accomplished by increasing the system volume relative to that of the bubble and by using electric and acoustic sensors to track the bubble formation frequency. Miller and co-workers also assessed the hydrodynamic effects arising at short bubble formation times with experiments on very viscous liquids [121]. They proposed a correction procedure to improve reliability at short times. This technique is applicable to the study of surfactant and polymer adsorption from solution [101, 120]. 

Magnesium is employed ki a wide variety of appHcations, based on its chemical, electrochemical, physical, and mechanical properties. The International Magnesium Association (IMA) divides the markets for magnesium kito 10 categories and tracks the volume of primary magnesium shipments to each market area on an annual basis. 

---