Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Tower press

Originally designed for the continuous filtration of conditioned sewage sludges, as were most of the filter belt presses available, the Manor Tower press is increa singly used for the treatment of paper mill sludge, coal, or flocculated clay slurries. [Pg.408]

Manor tower press, 11 379-381 Manson-Haferd parameter, 13 478 Manson-Succop parameter, 13 478... [Pg.550]

Tower Presses This press is similar to the stacked horizontal diaphragm presses, but only one filter belt is used (Fig. 18-191). The operation is also fully automatic. The primary applications are in chemical, mineral and pharmaceutical industries. The testing method is the same as the diaphragm presses. One important factor in designing a tower press is the sohds need to be able to be cleared from the chamber sed, otherwise leakage will occur in the following filtration cycle. [Pg.2081]

Multi-element candle Multi-element leaf Plate frame press Precoat Nutsche and multielement leaf Precoat plate frame press Recessed plate filter press Sheet filter Single leaf Nutsche Bag Cartridge Dead-end membrane Fibre bed Low shear crossflow Sand bed Simplex strainer Belt press Duplex strainer High shear crossflow Rotary disc Rotary drum Sand bed Tower press Diaphragm filter press Expression (screw) press Horizontal element tube press Vertical diaphragm filter press Vertical element tube press... [Pg.2]

A vertically oriented press where two endless, slightly off-vertical, filter cloths move continuously over a series of rollers. These moving belts are sealed at their edges by two other stationary belts in a manner that allows the feed suspension to be mechanically squeezed and cake filtration to occur. The maximum squeeze pressure is restricted to -250 kPa and controlled as appropriate via the gap between the moving cloths at the base of the unit. Typical cake discharge thickness ranges between 6 and 8 mm. The tower press as described here, which should not be confused with the similarly named, but very different, unit described in Section 1.4.2.5, has now been largely superseded by the belt press (see earlier in this section). [Pg.50]

Figure 12.17 Scheme to show the principle of the Manor Tower press... [Pg.404]

The double belt press is similar in layout to the filter shown in Figure 3.74, except that the lower belt is impervious. Once the dewatering sludge is caught up between the belts, there is no reason for the belts to be horizontal, so they can be monnted vertically as in the Manor tower press. [Pg.190]


See other pages where Tower press is mentioned: [Pg.408]    [Pg.408]    [Pg.959]    [Pg.147]    [Pg.1640]    [Pg.1640]    [Pg.1286]    [Pg.45]    [Pg.50]    [Pg.213]    [Pg.218]    [Pg.403]    [Pg.1240]    [Pg.99]    [Pg.188]   


SEARCH



Manor Tower Press

© 2024 chempedia.info