Thin coatings magnetic materials

XPS has been used in almost every area in which the properties of surfaces are important. The most prominent areas can be deduced from conferences on surface analysis, especially from ECASIA, which is held every two years. These areas are adhesion, biomaterials, catalysis, ceramics and glasses, corrosion, environmental problems, magnetic materials, metals, micro- and optoelectronics, nanomaterials, polymers and composite materials, superconductors, thin films and coatings, and tribology and wear. The contributions to these conferences are also representative of actual surface-analytical problems and studies [2.33 a,b]. A few examples from the areas mentioned above are given below more comprehensive discussions of the applications of XPS are given elsewhere [1.1,1.3-1.9, 2.34—2.39]. 

Dr. Hui has worked on various projects, including chemical sensors, solid oxide fuel cells, magnetic materials, gas separation membranes, nanostruc-tured materials, thin film fabrication, and protective coatings for metals. He has more than 80 research publications, one worldwide patent, and one U.S. patent (pending). He is currently leading and involved in several projects for the development of metal-supported solid oxide fuel cells (SOFCs), ceramic nanomaterials as catalyst supports for high-temperature PEM fuel cells, protective ceramic coatings on metallic substrates, ceramic electrode materials for batteries, and ceramic proton conductors. Dr. Hui is also an active member of the Electrochemical Society and the American Ceramic Society. 

When preparing coatings from reactive compositions, a thin layer of material is first applied to the item. The coating material adheres to the item by gravitational, magnetic, centrifugal or adhesion forces. The prepared article with its reactive layer is then placed in a chamber where the final polymeric coating is formed. 

Miscellaneous Extrusion-Applied Polymers. As mentioned earlier, there is a tendency to develop solventless magnet wire enamel formulations, and extrudable polymer systems would fulfill that requirement. There have been reports about extrusion of thin coatings of polyesters over copper wire. At this point, the state of the art allows extrusion of thin insulating films only with thermoplastic materials. The reliable extrusion of uniform and concentric insulating films of approximately 0.001-0.002 in. wall thickness is already an improvement over the more traditional extrusions of polyethylene, poly(vinyl chloride), and several fluoropolymers in much greater wall thicknesses. Because cross-linked insulation is ultimately required for most magnet wire applications, further materials development needs to be done to provide polymer compositions that are both extrudable as thin films and can be cross-linked in an economical process suitable for large-scale industrial application. 

Many specialised applications of magnetic materials involve the utilisation of ferrite thin films, such as magnetic and magnetooptic recording media, microwave devices in integrated circuits and coatings for microwave shielding. To prepare these ferrite thin fihns, a wide variety of techniques has been devised. 

---