Teflon, preparation

FIGURE 5. Computer simulation of the 19F spectrum of polyfluoromethylene(teflon) prepared at 0 °C and observed in acetone solution. The deviation of the simulated spectrum (full trace) from the observed spectrum (light trace) is greatest for the rmmm and mrrm peaks. Reprinted with permission from Reference 57. Copyright (1980) American Chemical Society... 

Cast the SDS-PAGE slab gel with a Teflon preparative comb, which results in one large well along the top of the gel. 

Fep2 was first prepared by the action of gaseous hydrogen fluoride over FeCl2 ia an iron boat (2). The reaction of anhydrous FeCl2, FeCl2 4H20, or FeSO and anhydrous HF in plastic reaction vessels such as vessels of polyethylene, polypropylene, or Teflon results in quantitative yields of very... 

AgF2 is prepared by the action of elemental fluorine on AgF or AgCl at 200°C. Both processes result in quantitative yields. Silver difluoride should be stored in Teflon, passivated metal containers, or in sealed quartz tubes. 

Titanium tetrafluoride may be prepared by the action of elemental fluorine on titanium metal at 250°C (5) or on Ti02 at 350°C. The most economical and convenient method is the action of Hquid anhydrous HF on commercially available titanium tetrachloride in Teflon or Kynar containers. Polyethylene reacts with TiCl and turns dark upon prolonged exposure. The excess of HF used is boiled off to remove residual chloride present in the intermediates. 

Hexafluorozirconic acid [12021 -95-3]], H2ZrP, is formed by dissolving freshly prepared oxide, fluoride, or carbonate of zirconium in aqueous HP. This acid is produced commercially in a concentration range of 10 to 47%. The acid can be stored at ambient temperatures in polyethylene or Teflon containers... 

Beakers and other related equipment made of polyethylene, polypropylene, Teflon or glassy carbon are usually used in the preparation of such solutions. 

TABs are a mixture of a Teflon emulsion and acetylene black, which is prepared by a special vigorous mixing technique. 

Irradiation Procedure. Reaction mixtures were prepared at room temperature by transferring desired quantities of reactants from their storage bulbs to the reaction vessel, a 500-cc. spherical borosilicate glass flask attached to the vacuum line by a section of glass capillary tubing and a 4-mm. bore threaded glass valve with a Teflon plug (Fischer and Porter 795-609). Prior to each experiment this vessel was baked under vacuum at 500°C. for 12 or more hours. 

Raw foods were freeze-dried and analyzed for carbon isotopes using mass spectrometry. Cooked foods were prepared following historic recipes, then were freeze-dried prior to analysis. For the trace element analysis, foods (both raw and cooked) were wet ashed using nitric acid in Teflon lined pressure vessels and digested in a CEM Microwave oven. Analysis of Sr, Zn, Fe, Ca and Mg was performed using Atomic Absorption Spectrometry in the Department of Geology, University of Calgary. 

MEAs used in this study were prepared in the following procedure [5]. The diffusion backing layers for anode and cathode were a Teflon-treated (20 wt. %) carbon paper (Toray 090, E-Tek) of 0.29 mm thickness. A thin diffusion layer was formed on top of the backing layer by spreading Vulcan XC-72 (85 wt. %) with PTFE (15 wt. %) for both anode and cathode. After the diffusion layers were sintered at a temperature of 360 C for 15 min., the catalyst layer was then formed with Pl/Ru (4 mg/cm ) and Nafion (1 mg/cm ) for anode and with Pt (4 mg/cm ) and Nafion (1 mg/cm ) for cathode. The prepared electrodes were placed either side of a pretreated Nafion 115 membrane and the assembly was hot-pressed at 85 kg/cm for 3 min. at 135 C. 

Animal treatment. Male 100-g MRC-Wistar or Sprague-Dawley rats were fasted from the evening of the previous day but were given water. Non-fasted 30-35 g Swiss mice were used. Except where specified otherwise, the animals received a standard commercial diet (Wayne Lab Blox, Allied Mills). In the standard experiments, animals were gavaged with 25 mg morpholine (Fisher Scientific Co.) in 10 mL water/rat or 2 mg morpholine in 0.2 mL water/mouse. A stream of NO2 was prepared by suitable mixing (using Teflon tubing) of gas from a cylinder of 106 ppm N0 in N (Linde Division, Union Carbide Corp.) and compressed air. 

Reactions that simnlate tropospheric conditions have been carried ont in Teflon bags with volumes of ca. 6 m htted with sampling ports for introduction of reactants and snbstrates, and removal of samples for analysis. Substrates can be added in the gas phase or as aerosols that form a surface him. The primary reactants are the hydroxyl and nitrate radicals, and ozone. These mnst be prepared before use by reactions (a) to (c). 

---