Surface tension compounds

The surface tensions for solutions of organic compounds belonging to a homologous series, for example, R(CH2)nX, show certain regularities. Roughly, Traube [145] found that for each additional CH2 group, the concentration required to give a certain surface tension was reduced by a factor of 3. This rule is manifest in Fig. lll-15b the successive curves are displaced by nearly equal intervals of 0.5 on the log C scale. 

This database provides thermophysical property data (phase equilibrium data, critical data, transport properties, surface tensions, electrolyte data) for about 21 000 pure compounds and 101 000 mixtures. DETHERM, with its 4.2 million data sets, is produced by Dechema, FIZ Chcmic (Berlin, Germany) and DDBST GmhH (Oldenburg. Germany). Definitions of the more than SOO properties available in the database can be found in NUMERIGUIDE (sec Section 5.18). 

For the majority of compounds the dependence of the surface tension y on the temperature can be given as ... 

The surface tension of a liquid, -y, is the force per unit length on the surface that opposes the expansion of the surface area. In the literature the surface tensions are expressed in dyn cm 1 dyn cm = 1 mN in the SI system. For the large majority of compounds the dependence of the surface tension on the temperature can be given as... 

Revised material for Section 5 includes the material on surface tension, viscosity, dielectric constant, and dipole moment for organic compounds. In order to include more data at several temperatures, the material has been divided into two separate tables. Material on surface tension and viscosity constitute the first table with 715 entries included is the temperature range of the liquid phase. Material on dielectric constant and dipole... 

Revised material in Section 5 includes an extensive tabulation of binary and ternary azeotropes comprising approximately 850 entries. Over 975 compounds have values listed for viscosity, dielectric constant, dipole moment, and surface tension. Whenever possible, data for viscosity and dielectric constant are provided at two temperatures to permit interpolation for intermediate temperatures and also to permit limited extrapolation of the data. The dipole moments are often listed for different physical states. Values for surface tension can be calculated over a range of temperatures from two constants that can be fitted into a linear equation. Also extensively revised and expanded are the properties of combustible mixtures in air. A table of triple points has been added. 

FLUORINECOMPOUNDS,ORGANIC - FLUORINATEDALIPHATICCOMPOUNDS] (Volll) -surface tensions of [FLUORINE COMPOUNDS, ORGANIC - INTRODUCTION] (Volll)... 

The low surface tension of highly fluorinated organic compounds is commercially important for their appHcation in surfactants, antisoiling textile treatments, lubricants, and specialty wetting agents. 

Properties. The physical properties of aHphatic fluorine compounds containing chlorine are similar to those of the PECs or HECs (3,5). They usually have high densities and low boiling points, viscosities, and surface tensions. The irregularity in the boiling points of the fluorinated methanes, however, does not appear in the chlorofluorocarbons. Their boiling points consistently increase with the number of chlorines present. The properties of some CECs and HCECs are shown in Tables 3 and 4. 

Release agents function by either lessening intermolecular interactions between the two surfaces in contact or preventing such close contact. Thus, they can be low surface-tension materials based on aUphatic hydrocarbon, fluorocarbon groups, or particulate soHds. The principal categories of material used are waxes, fatty acid metal soaps, other long-chain alkyl derivatives, polymers, and fluorinated compounds. 

---