Surface cleaning properties Plate

Intrinsic Steei Quaiity refers to the metallurgical and chemical properties of steel products (plate, pipe, tubes, structurals, castings, forgings) supplied to the fabricator for conversion into process equipment. Factors related to deoxidation, controlled finishing temperatures in rolling, and cleaning up of surface defects are included. 

The resulting monolayer of methyl groups is chemically attached and completely alters the wetting properties of the surface. Again, to prevent contamination these plates must be handled only with tweezers and stored in cleaned, sealed containers. 

Specific properties of polysilanes have been linked to the method of synthesis.35 For example, in the case of anionic polymerization of poly[l-(6-methoxy-hexyl)-l,2,3-trimethyldisilanylene] a new type of chromism was induced in the polysilane film by the difference in the surface properties of substrates and was termed a surface-mediated chromism. The polysilane exhibited thermochromism with an absorption maximum at 306 nm at 23°C, but <15°C a band at 328 nm began to appear. A monolayer of the polysilane was transferred onto both a clean hydrophilic quartz plate and a hydrophobic one treated with hexamethyldisilazane by the vertical dipping method. With the hydrophobic plate, a broad UV absorption at 306 nm is obtained, whereas the absorption on a hydrophilic plate shifts to 322 nm. The conformation of the polysilane is preserved by hydrogen bonding between the silica surface and the ether section of the substituent on the hydrophilic plate. The polysilane is attached to the hydrophobic surface only by van der Waals forces, and this weaker interaction would not sustain the thermodynamically unstable conformational state that is attained on the water surface. 

Plate-fin exchangers provide a very large heat transfer surface per unit volume and are relatively inexpensive per unit area. They are not mechanically cleanable and are ordinarily used only with very clean fluids. This combination of properties fits them very well for a wide variety of cryogenic applications, such as air separation helium separation, purification, and liquefaction liquefied natural gas production and separation of light hydrocarbons. They are also used in higher-temperature gas-to-gas services. 

Mercury-plated electrodes. Platinum can be plated with mercury to form an electrode with many of the properties of a mercury surface. This is done by cleaning a platinum electrode in nitric acid, connecting it as the cathode in perchloric acid solution over a pool of mercury, and then dipping it into the mercury while it is still connected in the circuit. The method works well for plating a planar platinum inlay electrode to give a flat mercury-coated surface, but it can be used for electrodes of any shape.112... 

---