Stripping equipment

Adequate comparisons of the efficiencies of the many types of stripping devices in existence have never been made actually, such comparisons are not necessary, nor is it necessary to consider the purchase or construction by each group of a standardized piece of stripping equipment. Rather, it is proposed that the efficiency of each such apparatus be determined as the time of stripping required to attain equilibrium of concentration of the insecticide between extracting solvent and substrate—i.e., when the plot of quantity of insecticide in solvent vs. time levels off. Then, if all stripping operations in a given ap-... 

FIGURE 8.1 Schematic showing conventional air stripping equipment configuration. (After Knox et al., 1986.)... 

Material B. stearotbermopbilus strips Equipment portable Kaye validator TR-140... 

It should be recognized at the outset that the driving forces for the installation of metal-ion stripping equipment may also be quite diverse, namely ... 

Test strip equipped with sorghum leaf oxalate oxidase cross-linked with... 

MAR 01] Martin J.-L., Quincy R., Crossover crashes at median strips equipped with barriers on a french motorway network. Transportation Research Record No. 1758, pp. 6-12,2001. 

Time, Cost, and Equipment Commercial instrumentation for voltammetry ranges from less than 1000 for simple instruments to as much as 20,000 for more sophisticated instruments. In general, less expensive instrumentation is limited to linear potential scans, and the more expensive instruments allow for more complex potential-excitation signals using potential pulses. Except for stripping voltammetry, which uses long deposition times, voltammetric analyses are relatively rapid. 

Shell process. Universal Oil Pro-ducts sulfolane sulfolane selectivity and capacity insensitive to water content caused by steam-stripping during solvent recov-ery heavy paraffinic countersolvent use 120 rotating-disk contactor, up to 4 m in diameter the high selectivity and capacity of sulfolane leads to low solvent-feed ratios, and thus smaller equip-ment... 

The western phosphates are sedimentary deposits in adjoining areas of Wyoming, Idaho, and Utah derived from a former inland sea. They consist of layers of limestone, phosphate, and chert, now budded and faulted so they are rarely horizontal. The phosphate ore is strip-mined using large earth-moving equipment such as shovels, scrappers, dump tmcks, and bulldozers to mine the overburden and phosphate ore. Mining ratios of overburden to metric ton of recovered ore are from 1—3 m /1 (2—4 yd /short ton). The typical mining practice is to remove ore and overburden from a pit in discrete layers (Lifts) of 10—20 m in depth. Overburden from the pit is back-hauled to a previously mined pit. Extensive land reclamation practices are later carried out to return the mine areas to natural states. 

After the compound is prepared, it is whipped either on a batch or continuous basis. The Oakes continuous mixer is the standard piece of equipment ia the iadustry. Then the gelling agents, ie, Na2SiFg and ZnO, are added, the foam poured iato molds and cured, and the product stripped from the mold for further cure. 

---