Steam high pressure generation

Figure 13.8 The grand composite curve for the whole process apparently requires only high-pressure steam generation from boiler feedwater.

Exampie A.3.1 The pressures for three steam mains have been set to the conditions given in Table A.l. Medium- and low-pressure steam are generated by expanding high-pressure steam through a steam turbine with an isentropic efficiency of 80 percent. The cost of fuel is 4.00 GJ and the cost of electricity is 0.07 h. Boiler feedwater is available at 100°C with a heat capacity... 

The problem with this approach is that if the steam generated in the boilers is at a very high pressure and/or the ratio of power to fuel costs is high, then the value of low-pressure steam can be extremely low or even negative. This is not sensible and discourages efficient use of low-pressure steam, since it leads to low-pressure steam with a value considerably less than its fuel value. 

Cyclohexylamine is miscible with water, with which it forms an azeotrope (55.8% H2O) at 96.4°C, making it especially suitable for low pressure steam systems in which it acts as a protective film-former in addition to being a neutralizing amine. Nearly two-thirds of 1989 U.S. production of 5000 —6000 t/yr cyclohexylamine serviced this appHcation (69). Carbon dioxide corrosion is inhibited by deposition of nonwettable film on metal (70). In high pressure systems CHA is chemically more stable than morpholine [110-91-8] (71). A primary amine, CHA does not directiy generate nitrosamine upon nitrite exposure as does morpholine. CHA is used for corrosion inhibitor radiator alcohol solutions, also in paper- and metal-coating industries for moisture and oxidation protection. 

The superheated steam generated in the superheater section is coHected in a header pipe that leads to the plant s high pressure steam turbine. The steam turbine s rotor consists of consecutive sets of large, curved, steel aHoy disks, each of which anchors a row of precision-cast turbine blades, also caHed buckets, which protmde tangentiaHy from the shaft and impart rotation to the shaft when impacted by jets of high pressure steam. Rows of stationary blades are anchored to the steam turbine s outer sheH and are located between the rows of moving rotor blades. 

In theory, whole-tree-energy plants have the potential to be more efficient than existing wood-fired generators, which are fueled by chipped wood with a relatively high moisture content (45%). The dried whole trees have a moisture content below 25%, and whole-tree plants potentially can be built to have a greater capacity and to employ high pressure, high temperature steam. 

---