Staged operations single-stage

In most compounding operations, single- and twin-screw extruders are involved at some stage to melt, convey, compress and mix different compounds such as additives, colourants and different polymer types. 

The calculation of single-stage equilibrium separations in multicomponent systems is implemented by a series of FORTRAN IV subroutines described in Chapter 7. These treat bubble and dewpoint calculations, isothermal and adiabatic equilibrium flash vaporizations, and liquid-liquid equilibrium "flash" separations. The treatment of multistage separation operations, which involves many additional considerations, is not considered in this monograph. 

Separation of mixtures of condensable and non-condensable components. If a fluid mixture contains both condensable and noncondensable components, then a partial condensation followed by a simple phase separator often can give a food separation. This is essentially a single-stage distillation operation. It is a special case that deserves attention in some detail later. 

The urea solution stream is then fed to the vacuum concentrator unit which operates at 17.3 kPa (130 mm Hg abs) and produces 88.7 wt % urea. It then goes to either two-stage evaporators if prills are made, or a single-stage unit for granule production. 

Another hydrogenation process utilizes internally generated hydrogen for hydroconversion in a single-stage, noncatalytic, fluidized-bed reactor (41). Biomass is converted in the reactor, which is operated at about 2.1 kPa, 800°C, and residence times of a few minutes with steam-oxygen injection. About 95% carbon conversion is anticipated to produce a medium heat value (MHV) gas which is subjected to the shift reaction, scmbbing, and methanation to form SNG. The cold gas thermal efficiencies are estimated to be about 60%. 

Wetox uses a single-reactor vessel that is baffled to simulate multiple stages. The design allows for higher destmction efficiency at lower power input and reduced temperature. Its commercial use has been limited to one faciHty in Canada for treatment of a complex industrial waste stream. Kenox Corp. (North York, Ontario, Canada) has developed a wet oxidation reactor design (28). The system operates at 4.1—4.7 MPa (600 to 680 psi) with air, using a static mixer to achieve good dispersion of Hquid and air bubbles. 

By contrast, the single-screw and double-hehcal screw compressors (Fig. 6) can operate at high or low pressure ratios. They can be appHed at pressure ratios below 2 1 and above 20 1 in a single stage. These compressors are suitable for use with higher pressure refrigerants such as CFC-12, HCFC-22, or ammonia. 

The dominance of distiHation-based methods for the separation of Hquid mixtures makes a number of points about RCM and DRD significant. Residue curves trace the Hquid-phase composition of a simple single-stage batch stiHpot as a function of time. Residue curves also approximate the Hquid composition profiles in continuous staged or packed distillation columns operating at infinite reflux and reboil ratios, and are also indicative of many aspects of the behavior of continuous columns operating at practical reflux ratios (12). 

---