Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

SRM selected reaction

SRM. selected reaction monitoring SSMS. spark source mass spectrometry... [Pg.446]

SIM, selected ion monitoring SRM, selected reaction monitoring MRM, multiple reaction monitoring. [Pg.41]

SRM (selected reaction monitoring), 693 Stability, oxidation indices, 656, 664-5 Standard enthalpy of formation see Heat of formation... [Pg.1490]

Fig. 2.2.9 High-performance liquid chromatography-tandem mass spectrometric analysis of AdoMet and AdoHcy. The analytes were evaluated by multiple reaction monitoring with the following transitions m/z 399 -> 250 for AdoMet m/z 402 -> 250 for the internal standard, tridenterated AdoMet (AdoMet +3) m/z 385 -> 135 for AdoHcy m/z 390 ->- 135 for the internal standard, pentadenterated AdoHcy (AdoHcy+5). Mass spectrometric conditions are described in the text. TIC total ion current, SRM selected reaction monitoring (Figure courtesy of Dr. Ries Duran, Amsterdam)... Fig. 2.2.9 High-performance liquid chromatography-tandem mass spectrometric analysis of AdoMet and AdoHcy. The analytes were evaluated by multiple reaction monitoring with the following transitions m/z 399 -> 250 for AdoMet m/z 402 -> 250 for the internal standard, tridenterated AdoMet (AdoMet +3) m/z 385 -> 135 for AdoHcy m/z 390 ->- 135 for the internal standard, pentadenterated AdoHcy (AdoHcy+5). Mass spectrometric conditions are described in the text. TIC total ion current, SRM selected reaction monitoring (Figure courtesy of Dr. Ries Duran, Amsterdam)...
DE, two-dimensional gel electrophoresis WB, Western blot MS, mass spectrometry LC, liquid chromatography 2DE DICE, two-dimensional difference gel electrophoresis, SRM, selected-reaction monitoring MRM, multiple reaction monitoring AQUA, absolute protein quantitation SMIM, selected MS/MS ion monitoring. ... [Pg.211]

SRM (Selected Reaction Monitoring) In MS/MS, a specific dissociation of a parent to daughter ion is monitored. lUPAC recommendations for terms for use in mass spectrometry can be found in (Todd 1991). [Pg.300]

TISP, turbo ion spray MRM, multiple reaction monitoring UHPLC, ultra-high-pressure liquid chromatography TOP, time-of-flight mass analyzer ISP, ion spray SRM, selected reaction monitoring ESI, electrospray interface APCI, Atmospheric pressure chemical ionization. [Pg.2071]

SRM selected reaction monitoring or Standard Reference Material S/N signal-to-noise ratio... [Pg.363]

AES, atomic emission spectrometry AP(C)I, atmospheric pressure (chemical) ionization CGC, capillary gas chromatography DAD, diode array detection ESI, electrospray ionization FI, fluorescence detection ICP, indcutively coupled plasma LIE, laser-induced fluorescence Nl, negative ion NMR, nuclear magnetic resonance PFPD, pulsed flame photometric detector SRM, selected reaction monitoring. [Pg.208]

GC, gas chromatography El, electronic impact PI, positive-ion mode LC, liquid chromatography ESI, electrospray ionization CID, collision-induced dissociation Q, quadrupole SIM, selected ion monitoring NI, negative-ion mode APCI, atmospheric pressure chemical ionization SRM, selected reaction monitoring Q-TOF, quadrupole-time-of-flight... [Pg.521]

Amelia Peterson et al, University Wisconsin, Prof Josh Coon group, published first results on the implementation of an EI/CI interface on a hybrid Orbitrap system for ultra-high resolution GC-MS using a GC-Quadrupole-Orbitrap configuration for full scan, SIM, MS/MS and SRM (selected reaction monitoring) at the ASMS conference. [Pg.6]

SIM (selected ion monitoring)/MID (multiple ion detection) or SRM (selected reaction monitoring)/MRM (multiple reaction monitoring) analyses give a chromatogram in the same way but no mass spectrum is retrievable. The TIC in this case is composed of the intensities of the selected ions. Analyses, where switching from individual masses to fixed retention times is planned, often show clear jumps in the base line (see Figure 2.162). [Pg.356]

The GC-MS/MS detection method described uses a timed-SRM (selected reaction monitoring) setup with three transitions for each analyte for a confirming ion ratio confirmation. The t-SRM window is typically set to 30—60s width for all compounds. The compliance with the calibrated compound ion ratios of standards is checked by the processing software for the peaks identified in the samples (Figure 4.35 and Table 4.9). [Pg.541]

Keywords pesticides food multi-residue method high throughput QuEChERS SRM (selected reaction monitoring) H-SRM (enhanced resolution selected reaction monitoring) MS/MS confirmation QED data-dependent acquisition... [Pg.570]

Duty cycle is calculated using the scan time for ion one (in a QMF, but the total ion time for ion traps.). SIM, selected ion monitoring SRM, selected reaction monitoring PID, photo induced dissociation SID, surface induced dissociation. [Pg.273]


See other pages where SRM selected reaction is mentioned: [Pg.16]    [Pg.760]    [Pg.27]    [Pg.34]    [Pg.217]    [Pg.168]    [Pg.2]    [Pg.969]    [Pg.501]    [Pg.603]    [Pg.179]    [Pg.446]    [Pg.224]    [Pg.2]    [Pg.383]    [Pg.152]    [Pg.274]    [Pg.302]    [Pg.539]    [Pg.52]    [Pg.383]    [Pg.389]    [Pg.1050]    [Pg.4389]    [Pg.354]    [Pg.125]    [Pg.497]    [Pg.506]    [Pg.226]   
See also in sourсe #XX -- [ Pg.193 ]




SEARCH



Reaction selective

Reactions selection

SRM

SRMs

Selected reaction monitoring (SRM)confirmation

Selected reaction monitoring, SRM

Selected reactions

Selectivity reactions

© 2024 chempedia.info