Solid-phase microextraction sampler

Diffusive sampler Membrane extraction (MESI) Liquid-liquid extraction (LLE) Solid-phase extraction (SPE) SPE-PTV-GC Solid-phase microextraction (SPME) Headspace GC (SHS, DHS) Large-volume injection (LVI) Coupled HPLC-GC Membrane extraction (MESI) Difficult matrix introduction (DMI) Conventional solvent extraction methods 1 Pressurised solvent extraction methods Headspace GC (SHS, DHS) Thermal desorption (TD, DTD) Pyrolysis (Py) Photolysis Photon extraction (LD) Difficult matrix introduction (DMI)... 

Sampling of these substances has been carried out following three approaches liquid absorbents [47], solid-phase microextraction (SPME) fibres [43] and filter substrates (mostly quartz fibre filters but also PTFE membranes [1, 42, 48, 49]). When filter substrates are used, atmospheric particles are collected over 24-h periods using high-volume (dichotomous or single-filter instruments [1, 48]), medium-volume or low-volume samplers (operated to ensure collection of sufficient aerosol mass [37, 50]). Samples were always stored at low temperamres (refrigerated or frozen) to ensure sample preservation. 

Ouyang, G.F., W.N. Zhao, L. Bragg, Z.P. Qin, M. Alaee, and J. Pawliszyn. 2007. Time-weighted average water sampling in Lake Ontario with solid-phase microextraction passive samplers. Environ. Sci. Technol. 41 4026MO31. 

Elke, K., Jermann, E., Begerow, J., and Dunemann, L., Determination of benzene, toluene, ethylbenzene and xylenes in indoor air at environmental levels using diffusive samplers in combination with headspace solid-phase microextraction and high-resolution gas chromatography-flame ionization detection, J. Chromatogr. A, 826(2), 191-200, 1998. 

The concept of the equilibrium sampler is analogous to that of the octanol-water equilibrium partition coefficient (fQ,w) used since the 1970s to predict the potential for persistent nonpolar contaminants to concentrate in aquatic organisms [71]. The use of equilibrium-t) e passive samplers in the aquatic environment depends on the development of a sampler-water partition coefficient (fCs ) defined as the ratio of sampler to water concentration of the compound of interest at thermod)mamic equilibrium. The other key parameter determining the utility of an equilibrium-type passive sampler is the time taken to reach an approximate equilibrium condition. A range of approaches applied in developing equilibrium-t)q)e passive samplers include polyethylene or silicon sheets of various volume to surface area ratio [72] and solid-phase microextraction techniques [73]. 

Solid-phase microextraction (SPME) devices can be employed with solid samples as passive samplers, but this approach must be conducted in headspace mode and so it is limited to the more volatile PAHs [269], Furthermore, it appears that SPME is a better approach to extract primarily PAHs present in sediment porewater rather than in the colloidal phase [270], EPA method 8272 describes the determination of parent and alkyl polycyclic aromatics in sediment pore water by SPME-GC-MS. In a similar way, SPMDs have been mainly used for the determination of PAHs contained in sediment porewater [271],... 

---