Sinter forces

During pressure sintering, interiDarticle compressive stress, approximated by the externally applied stress and nonnalized by the relative density of the compact p, supplements the surface tension driving force for pore shrinkage ... 

Aqueous dispersions are used for spinning PTEE fibers. The dispersion is mixed with a matrix-forming medium (116,117) and forced through a spinneret into a coagulating bath. The matrix material is removed by heating and the fibers are sintered and drawn molten to develop their full strength. 

The primary driviag force for material transport comes from the chemical potential difference that exists between surfaces of dissimilar curvature within the system. The greater the curvature, ie, the finer the particle size, the greater the driving force for material transport and sintering. 

Particle shape also affects the sintering of a powder compact. Jagged or irregular shaped particles, which have a high surface area to volume ratio, have a higher driving force for densification and sinter faster than equiaxed particles. High aspect ratio platey particles, whiskers, and fibers, which pack poorly, sinter poorly. 

Porous Media Packed beds of granular solids are one type of the general class referred to as porous media, which include geological formations such as petroleum reservoirs and aquifers, manufactured materials such as sintered metals and porous catalysts, burning coal or char particles, and textile fabrics, to name a few. Pressure drop for incompressible flow across a porous medium has the same quahtative behavior as that given by Leva s correlation in the preceding. At low Reynolds numbers, viscous forces dominate and pressure drop is proportional to fluid viscosity and superficial velocity, and at high Reynolds numbers, pressure drop is proportional to fluid density and to the square of superficial velocity. 

In die operation of die first source, the driving force for sintering is the difference in curvature between the neck and the surface of the sphere. The curvature force A l, is given by... 

The values of m given above conform to Hemng s scaling law (1950) which states that since the driving force for sintering, the transport length, the area over which uansport occurs and the volume of matter to be transported are proportional to a, and respectively, the times for equivalent change in two powder samples of initial particle size ai q and 2,0 are... 

---