Single-walled carbon nanotubes SWNT

Formation of single-walled carbon nanotubes (SWNTs) was found to be catalyzed by metal nanoparticles [207]. Wang et al. [114] investigated bimetallic catalysts such as FeRu and FePt in the size range of 0.5-3 nm for the efficient growth of SWNTs on flat surfaces. When compared with single-component catalysts such as Fe, Ru, and Pt of similar size, bimetallic catalysts Fe/Ru and Fe/Pt produced at least 200% more SWNTs [114]. 

Single-walled carbon nanotubes SWNT anion intercalation. 

New applications of nitrile oxide 1,3-DC have been reported. Soluble, single-wall carbon nanotubes (SWNT) 32 functionalized with pentyl esters at the tips and pyridyl isoxazoline rings along the walls were prepared using pentyl ester-SWNT as dipolarophile. The complex... 

Transient transmittance of single-walled carbon nanotubes (SWNTs) in suspension was modulated at two periods of T40 and 21 fs, corresponding to the RBM and G mode, respectively [54,55]. The amplitude and the frequency of the coherent RBMs exhibited a clear excitation-wavelength dependence (Fig. 2.15) [54]. The different frequencies were attributed to SWNTs with different diameters coming to the excitonic resonance. The FT spectra of the coherent RBMs in Fig. 2.15 had noticeable differences from the resonant Raman spectra, such as the different intensities and better frequency resolution. 

As a third group of fullerene-like systems whose synthetic development is identified as a major future challenge are structurally defined single-walled carbon nanotubes (SWNTs) with uniform helicity and length, including their covalent and non-covalent derivatives. SWNTs can be considered as elongated giant fullerenes. 

In section 11D, we showed the sensitivity of TERS to distinguish different molecules by focusing on characteristic vibration modes of each molecule. In this section, we show another capability of TERS to characterize the structural difference of single-walled carbon nanotubes (SWNTs) as a sample. 

An other interesting strategy is the modification of the surface of the electrodes with multiwalled carbon nanotubes (MWNTs) or single-walled carbon nanotubes (SWNTs) [13,32]. The MWNTs are grown on the electrodes covered with a nickel catalyst film by plasma-enhanced chemical vapour deposition and encapsulated in Si02 dielectrics with only the end exposed at the surface to form an inlaid nanoelectrode array [13]. In the other case, commercial SWNTs are deposited on SPE surface by evaporation [32], The carbon nanotubes are functionalised with ssDNA probes by covalent attachment. This kind of modification shows a very efficient hybridisation and, moreover, the carbon nanotubes improve the analytical signal. 

---