Single in-line

Many other variations of DIP technology are readily available, such as SH-DIP (shrink DIP), SIP (single in-line package), SOP (small outline package), and QFP (quad flat package, as shown in Fig. lb (courtesy of Shinko Electric Industries Co. Ltd.)). The basic techniques are the same as DIP, but the variants provide different form factors and different arrangements of the pins. 

The entire coating is applied in a single, in-line extrusion process. 

SINGLE-IN-LINE PACKAGE (sip) Component package system with one line of connectors, usually spaced 0.100 in apart. 

In most cases only a single tie line is required. When several are available, the choice of which one to use is somewhat arbitrary. However, our experience has shown that tie lines which are near the middle of the two-phase region are most useful for estimating the parameters. Tie lines close to the plait point are less useful, since no common models for the excess Gibbs energy can adequately describe the flat region near the... 

The continuous line in Figure 16 shows results from fitting a single tie line in addition to the binary data. Only slight improvement is obtained in prediction of the two-phase region more important, however, prediction of solute distribution is improved. Incorporation of the single ternary tie line into the method of data reduction produces only a small loss of accuracy in the representation of VLE for the two binary systems. 

Vacha M, Liu Y, Nakatsuka FI and Tani T 1997 Inhomogeneous and single molecule line broadening of terryiene in a series of crystalline n-alkanes J. Phys. Chem 106 8324-31... 

Kozankiewicz B, Bernard J and Orrit M 1994 Single molecule lines and spectral hole burning of terryiene in different matrices J. Phys. Chem 101 9377-83... 

To fill out Table 8-1, change the element symbols in the last line to Li, Be, or B and designate the charge and spin multiplicities as 1 1, 2 1, 3 1 in that order. In line 5, the first number is the single positive charge and the second number is the spin multiplicity, 1 for paired electronic spins and 2 for an unpaired election. A... 

Ions of different m/z values pass sequentially in time through the quadrupole mass filter to reach an in-line, single-point ion collector. 

If the fractions of triads could be measured, they either would or would not lie on a single vertical line in Fig. 7.9. If they did occur at a single value of p, this would not only give the value of p (which could be obtained from the fraction of one kind of triad), but would also prove the statistics assumed. If the fractions were not consistent with a single p value, higher-order Markov statistics are indicated. 

Example. A single pipe line, 100 miles in length consists of 10 miles lOVin. OD 40 miles 12Vin. OD and 50 miles of 22-in. OD lines. 

---