Single-crystal surfaces surface energy

Figure 1 Schematic of eiectron energy-loss scattering process for electrons of energy striking a Rh single-crystal surface with adsorbed CO molecules present. The actual energy-loss spectrum, due to excitation of CO vibrations, is shown also.

Usually, the collection of LEED 7-Vcurves requires single crystal surfaces with long-range order in the upper-most layers. Structural information can, however, also be obtained in a similar way for certain disordered surfaces, when the energy dependence of the diffusely scattered intensity is analyzed (diffuse LEED [2.264, 2.265]). 

Figure 9.14 Kinetic current density (squares) at 0.8 V for O2 reduction on the Pt monolayer deposited on various metal single-crystal surfaces in a 0.1 M HCIO4 solution, and calculated binding energies (circles) of atomic oxygen (BEq), as a function of calculated d-band center (relative to the Fermi level, ej — sp) of the respective surfaces. The data for Pt(lll) were obtained from [Markovic et al., 1999] and are included for comparison. Key 1, PIml/ Ru(OOOl) 2, PtML/Ir(lll) 3, PtML/Rh(lH) 4, PtML/Au(lll) 5, Pt(lll) 6, PIml/ Pd(lll). (Reproduced with permission from Zhang et al. [2005a].)...

In conclusion, TDS of adsorbates on single crystal surfaces measured in ultrahigh vacuum systems with sufficiently high pumping speeds provides information on adsorbate coverage, the adsorption energy, the existence of lateral interactions between the adsorbates, and the preexponential factor of desorption, which in turn depends on the desorption mechanism. Analysis of spectra should be done with care, as simplified analysis procedures may easily give erroneous results. 

This chapter deals with the study of structural properties of catalysts and catalytic model surfaces by means of interference effects in scattered radiation. X-ray diffraction is one of the oldest and most frequently applied techniques in catalyst characterization. It is used to identify crystalline phases inside catalysts by means of lattice structural parameters, and to obtain an indication of particle size. Low energy electron diffraction is the surface sensitive analog of XRD, which, however, is only applicable to single crystal surfaces. LEED reveals the structure of surfaces and of ordered adsorbate layers. Both XRD and LEED depend on the constructive interference of radiation that is scattered by relatively large parts of the sample. As a consequence, these techniques require long-range order. 

LEED is used to determine the surface structure of single crystal surfaces and the structure of ordered adsorbate layers [18-21], The principle is illustrated in Fig. 6.7 a beam of monoenergetic low energy electrons (50-200 eV, minimum mean free... 

The link between the microscopic description of the reaction dynamics and the macroscopic kinetics that can be measured in a catalytic reactor is a micro-kinetic model. Such a model will start from binding energies and reaction rate constants deduced from surface science experiments on well defined single crystal surfaces and relate this to the macroscopic kinetics of the reaction. 

---