Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Single-crystal surfaces electrochemical results

The results obtained in the system k x hkl)/Cv , where 2D Me UPD phenomena occur followed by a Stranski-Krastanov growth mechanism in the OPD range, show that electrochemical 3D Me phase formation processes can be used for structuring and modification of metal single crystal surfaces in the nanometer range. Local electrochemical processes are initiated by in situ local probe methods using appropriate polarization routines. [Pg.302]

Growing interest in detailed information related to particular locations at an electrochemical interface (e.g. steps on a single crystal surface or particular features at a modified electrode surface) combined with instrumental developments have resulted in experimental methods providing localized information. In cases where this information is obtained point-by-point (sequentially), the procedure is called a scanning one and the method may be called mapping. In some cases (e.g. with focal plane... [Pg.36]

Water is involved in most of the photodecomposition reactions. Hence, nonaqueous electrolytes such as methanol, ethanol, N,N-d i methyl forma mide, acetonitrile, propylene carbonate, ethylene glycol, tetrahydrofuran, nitromethane, benzonitrile, and molten salts such as A1C13-butyl pyridium chloride are chosen. The efficiency of early cells prepared with nonaqueous solvents such as methanol and acetonitrile were low because of the high resistivity of the electrolyte, limited solubility of the redox species, and poor bulk and surface properties of the semiconductor. Recently, reasonably efficient and fairly stable cells have been prepared with nonaqueous electrolytes with a proper design of the electrolyte redox couple and by careful control of the material and surface properties [7], Results with single-crystal semiconductor electrodes can be obtained from table 2 in Ref. 15. Unfortunately, the efficiencies and stabilities achieved cannot justify the use of singlecrystal materials. Table 2 in Ref. 15 summarizes the results of liquid junction solar cells prepared with polycrystalline and thin-film semiconductors [15]. As can be seen the efficiencies are fair. Thin films provide several advantages over bulk materials. Despite these possibilities, the actual efficiencies of solid-state polycrystalline thin-film PV solar cells exceed those obtained with electrochemical PV cells [22,23]. [Pg.233]

The kinetics of CO oxidation from HClOi, solutions on the (100), (111) and (311) single crystal planes of platinum has been investigated. Electrochemical oxidation of CO involves a surface reaction between adsorbed CO molecules and a surface oxide of Pt. To determine the rate of this reaction the electrode was first covered by a monolayer of CO and subsequently exposed to anodic potentials at which Pt oxide is formed. Under these conditions the rate of CO oxidation is controlled by the rate of nucleation and growth of the oxide islands in the CO monolayer. By combination of the single and double potential step techniques the rates of the nucleation and the island growth have been determined independently. The results show that the rate of the two processes significantly depend on the crystallography of the Pt surfaces. [Pg.484]


See other pages where Single-crystal surfaces electrochemical results is mentioned: [Pg.2749]    [Pg.128]    [Pg.498]    [Pg.68]    [Pg.123]    [Pg.642]    [Pg.2]    [Pg.106]    [Pg.208]    [Pg.218]    [Pg.810]    [Pg.571]    [Pg.150]    [Pg.229]    [Pg.294]    [Pg.353]    [Pg.116]    [Pg.5]    [Pg.5]    [Pg.309]    [Pg.572]    [Pg.34]    [Pg.927]    [Pg.394]    [Pg.1271]    [Pg.82]    [Pg.122]    [Pg.160]    [Pg.161]    [Pg.164]    [Pg.182]    [Pg.217]    [Pg.225]    [Pg.229]    [Pg.288]    [Pg.386]    [Pg.524]    [Pg.318]    [Pg.224]    [Pg.17]    [Pg.174]    [Pg.308]    [Pg.208]    [Pg.323]    [Pg.13]    [Pg.182]    [Pg.276]   
See also in sourсe #XX -- [ Pg.43 ]




SEARCH



Electrochemical surface

Single crystal surfaces

Single-surface

© 2024 chempedia.info