Silyl nitronates cycloadditions

Hassner and coworkers have developed a one-pot tandem consecutive 1,4-addition intramolecular cycloaddition strategy for the construction of five- and six-membered heterocycles and carbocycles. Because nitroalkenes are good Michael acceptors for carbon, sulfur, oxygen, and nitrogen nucleophiles (see Section 4.1 on the Michael reaction), subsequent intramolecular silyl nitronate cycloaddition (ISOC) or intramolecular nitrile oxide cycloaddition (INOC) provides one-pot synthesis of fused isoxazolines (Scheme 8.26). The ISOC route is generally better than INOC route regarding stereoselectivity and generality. 

TABLE 2.41. INTRAMOLECULAR SILYL NITRONATE CYCLOADDITIONS WITH ALKYNES... 

Ishikawa T, Shimizu Y, Kudoh T, Saito S (2003) Conversion of D-glucose to cychtol with hydroxymethyl substituent via intramolecular silyl nitronate cycloaddition reaction application to total synthesis of (+)-cyclophelhtol. Org Lett 5 3879-3882... 

Hoveyda and co-workers employed nitroolefinic silanes 249 possessing a chiral center that bears a silicon substituent for the diastereoselective synthesis of isoxazolines 251 (Scheme 59) [160]. While the silyl nitronate cycloaddition provided the diastereomeric isoxazolines 251 in >20 1 ratio, the nitrile oxide route was much less selective (dr 1 2), in agreement with the findings by Hassner as shown in Scheme 49. The greater selectivity observed in the ISOC reaction was attributed to a possible 1,3-aUylic strain in the transition state leading to the minor isomer while no such strain was expected for nitrile oxides that have near-linear geometry. The authors also observed greater... 

Hoveyda s report of intramolecular silyl-nitronate cycloaddition governed by a remote stereocenter [12]... 

Intramolecular Silyl Nitronate-Olefin Cycloaddition (ISOC)... 

Although nitrile oxide cycloadditions have been extensively investigated, cycloadditions of silyl nitronates, synthetic equivalent of nitrile oxides in their reactions with olefins, have not received similar attention. Since we found that the initial cycloadducts, hl-silyloxyisoxazolidines, are formed with high degree of stereoselectivity and can be easily transformed into isoxazolines upon treatment with acid or TBAF, intramolecular silylnitronate-olefin cycloadditions (ISOC) have emerged as a superior alternative to their corresponding INOC reactions [43]. Furthermore, adaptability of ISOC reactions to one-pot tandem sequences involving 1,4-addition and ISOC as the key steps has recently been demonstrated [44]. 

One-pot tandem sequences involving 1,4-addition and ISOC as the key steps have been developed for the construction of N and 0 heterocycles as well as of carbocycles [44]. In this sequence, the nitronate arising from 1,4-addition to an a, -unsaturated nitro alkene is trapped kinetically using trimethyl silyl chloride (TMSCl). The resulting silyl nitronate underwent a facile intramolecular 1,3-dipolar cycloaddition with the unsaturated tether (e.g.. Schemes 20-22). 

ISOC reaction was employed to synthesize substituted tetrahydrofurans 172 fused to isoxazolines (Scheme 21) [44b]. The silyl nitronates 170 resulted via the nitro ethers 169 from base-mediated Michael addition of allyl alcohols 168 to nitro olefins 167. Cycloaddition of 170 followed by elimination of silanol provided 172. Reactions were conducted in stepwise and one-pot tandem fashion (see Table 16). A terminal olefinic Me substituent increased the rate of cycloaddition (Entry 3), while an internal olefinic Me substituent decreased it (Entry 4). 

The Michael addition of allyl alcohols to nitroalkenes followed by intramolecular silyl nitronate olefin cycloaddition (Section 8.2) leads to functionalized tetrahydrofurans (Eq. 4.15).20... 

Alkyl and silyl nitronates are, in principle, /V-alkoxy and /V-silyloxynitrones, and they can react with alkenes in 1,3-dipolar cycloadditions to form /V-alkoxy- or /V-silyloxyisoxaz.olidine (see Scheme 8.25). The alkoxy and silyloxy groups can be eliminated from the adduct on heating or by acid treatment to form 2-isoxazolines. It should be noticed that isoxazolines are also obtained by the reaction of nitrile oxides with alkenes thus, nitronates can be considered as synthetic equivalents of nitrile oxides. Since the pioneering work by Torssell et al. on the development of silyl nitronates, this type of reaction has become a useful synthetic tool. Recent development for generation of cyclic nitronates by hetero Diels-Alder reactions of nitroalkenes is discussed in Section 8.3. 

A series of 3-substituted-2-isoxazoles are prepared by the following simple procedure in situ conversion of nitroalkane to the silyl nitronate is followed by 1,3-dipolar cycloaddition to produce the adduct, which undergoes thermal elimination during distillation to furnish the isoxazole (Eq. 8.74). 5 Isoxazoles are useful synthetic intermediates (discussed in the chapter on nitrile oxides Section 8.2.2). Furthermore, the nucleophilic addition to the C=N bond leads to new heterocyclic systems. For example, the addition of diallyl zinc to 5-aryl-4,5-dihydroi-soxazole occurs with high diastereoselectivity (Eq. 8.75).126 Numerous synthetic applications of 1,3-dipolar cycloaddition of nitronates are summarized in work by Torssell and coworker.63a... 

Eguchi and Ohno have used silyl nitronate induced 1,3-dipolar cycloaddition for functionalization of fullerene C60 (Eq. 8.76).127a Nitrile oxides also undergo 1,3-dipolar cycloaddition... 

The use of silylketals derived from allylic alcohols and 1-substituted nitroethanols for the stereocontrolled synthesis of 3,4,5-trisubstituted 2-isoxazolines via intramolecular 1,3-dipolar cycloaddition has been demonstrated. Here again, the use of silyl nitronates (ISOC) increases the level of selectivity compared to INOC (Eq. 8.92).145... 

Synthesis of Dialkylboryl Nitronates Approaches to the synthesis of boryl nitronates are similar to the strategy for the synthesis of silyl nitronates developed in more detail (see Section 3.2.3). However, only four studies have dealt with the synthesis of boryl nitronates (217, 229-231). The absence of interest in this class of compounds is apparently attributed to the fact that they are not involved in 1,3-dipolar cycloaddition reactions and, consequently, are unlikely to find use in organic synthesis. 

I. Intermolecular [3+2]-Addition of Nitronates to Olefins Of all known types of nitronates (see Section 3.2), alkyl- and silyl nitronates as well as cyclic C5-C6 nitronates are involved in [3+ 2]-cycloaddition reactions. Detailed comparative kinetic studies for different types of nitronates have not been reported. However, a few data (162, 336, 337) allow one to deduce some sequences (Chart 3.10). 

Silyl Nitronates The characteristic features of the behavior of SENAs in [3+ 2]-addition reactions (75, 133, 175-177, 185, 186, 189, 201a, 203, 205, 206, 216, 355-362c) are virtually identical to those of acyclic alkyl nitronates considered in the previous section. As mentioned above, minor but more reactive Z-tautomers of SENAs derived from primary AN can be detected by cycloaddition reactions (see Section 3.3.4.1 and Scheme 3.128). 

Here two facts can be mentioned. For example, cycloaddition of nitronate (Me02C)CH=N(0)0SiMe3 to ethylene was observed (203), whereas its O -methyl analog does not react with ethylene. It is hardly probable that this fact is due to the high reactivity of the silyl nitronate. More likely, the negative result for alkyl nitronate is attributed to low stability of this derivative. 

Other Types of Nitronates in [3 + 2]-Cycloaddition Reactions with Olefins As mentioned above, of all known types of nitronates, only alkyl and silyl nitronates can be involved in [3 + 2]-cycloaddition reactions with olefins. However, furoxans (161), which can also be considered as cyclic nitronates, can react with active dipolarophiles under extreme conditions to give nitrosoacetals (162) (Scheme 3.131, Eq. 1). 

Silyl nitronates containing chiral inductors have not been as yet used in intermolecular [3 + 2]-cycloaddition reactions. In this case, the facial discrimination was generally created by introducing chiral nonracemic fragments into dipolarophiles (see review 433). 

In intramolecular [3+ 2]-cycloaddition reactions, silyl nitronates also lead to substantially higher stereoselectivity than intermolecular reactions (see, e.g., Scheme 3.178) (193). 

Silyl Nitronates in the Michael Reaction The Michael reactions with SENAs were unknown until recently. Competitive [3 + 2]-cycloaddition reactions have been used instead of this process (for more details, see Section 3.4.3.). 

On the basis of available experimental data, it is impossible to choose a definite pathway of elimination of silanol. However, study of silylation of methyl P -nitropropionate (411) with BSA in the presence of trapping agents rigorously proved that silyl nitronate D is initially formed. This compound can be detected in the [3 + 2]-cycloaddition reaction with methyl acrylate product (413). If silylation of AN (411) is performed in the presence of ethyl vinyl ether, a-nitrosoalkene E can be successfully trapped in as heterodiene a Diels-Alder reaction. Dihydroox-azine (414) is formed, and its silylation affords isolable product (415). 

If X = AcO, intermediate SENA can be trapped by methyl acrylate in the [3+ 2]-cycloaddition reaction (isoxazolidine (416)). If X=C1, attempts to trap silyl nitronate failed however, nitroethylene was detected in a Diels-Alder reaction. By contrast, SENAs, in which X=OSiMe3 or NHPh, are quite stable. Therefore, the substituents X can be arranged in the following series of increasing elimination rates of SiX Cl > AcO > > PhNH. 

Intramolecular cyclizations of silyl nitronates were also used in the preparation of aminosugars. In 2003 Kudoh et al. reported the stereoselective conversion of 2-nitroalkanols by silyl nitronate generation followed by an intramolecular nitronate-olefin [3 + 2] cycloaddition reaction (Scheme 51).88... 

Several years later, Ioffe et al. (16) demonstrated that silyl nitronates also could be engaged in the dipolar cycloaddition with alkenes. These silylated isoxazolidine cycloadducts were then converted to the corresponding isoxazolines by treatment with sodium methoxide (Scheme 2.2). 

This chapter is divided into four major sections. The first (Section 2.1) will deal with the structure of both alkoxy and silyl nitronates. Specifically, this section will include physical, structural, and spectroscopic properties of nitronates. The next section (Section 2.2) describes the mechanistic aspects of the dipolar cycloaddition including both experimental and theoretical investigations. Also discussed in this section are the regio- and stereochemical features of the process. Finally, the remaining sections will cover the preparation, reaction, and subsequent functionalization of silyl nitronates (Section 2.3) and alkyl nitronates (Section 2.4), respectively. This will include discussion of facial selectivity in the case of chiral nitronates and the application of this process to combinatorial and natural product synthesis. 

TABLE 2.31. STEREOSELECTIVITY IN THE INTRAMOLECULAR CYCLOADDITION OF SILYL NITRONATES... 

The [3 + 2] cycloaddition of silyl nitronates has been extensively investigated since the first pioneering studies by Ioffe et al. (16). This transformation is attractive because of the resulting isoxazolidine can be easily converted to the corresponding isoxazoline for which a myriad of transformations are known. Moreover, this procedure provides yields and selectivities different from those of the nitrile oxide [3 + 2] cycloaddition, which affords the isoxazoline directly. The reaction of silyl nitronates has been briefly reviewed in the context of the chemistry of nitronic acid derivatives (27,30). 

TABLE 2.32. DIPOLAR CYCLOADDITIONS OF MONOSUBSTITUTED SILYL NITRONATES WITH METHYL ACRYLATE... 

---