Silane From ether

An excellent synthesis of a,/J-unsaturated acyl silanes from allyl silyl ethers is shown in Scheme 4020. This simple two-step procedure hinges on the Wittig rearrangement127 128,... 

The most versatile synthesis of w./i-unsaUi rated acyl silanes involves the use of allene methodology, developed by a number of groups14,22. Deprotonation and silylation of allenyl ethers followed by hydrolysis gives rise directly to ,/3-unsaturated acyl silanes via their enol ethers, 1-alkoxy-l-trimethylsilylallenes (Scheme 43). Indeed, the first example of an a,/l-unsaturated acyl silane was prepared by such a route223, as was the first example of an allenic acyl silane (from a l-trimethylsilyl-l-trimethylsilyloxy-l,2,3-alkatriene)22b. 

Miginiac et al. [97] synthesized oxepin 233 and oxocin 234 starting from allyl-silane silyl ether 237, which was condensed with various aldehydes in the presence of Et20 BF3 (1.0 equivalent) (Scheme 13.85). The resulting seven- and eight-membered rings were obtained in moderate to excellent yields. 

Scheme 7.21. Formation of silylmethyl allylic silanes from gem-disubstituted homoallylic ethers.

The accelerated rate for alcoholysis with le, which was observed for the 10 % Pd/C catalytic system, was also seen with the Mn(CO)sBr catalyst. Reactions of le with primary, secondary or tertiary alcohols resulted in moderate yields of the corresponding silyl ketals after 2 h (Table 8 and 9). When mono-alkoxy silane from 3-hydroxy butyrate (lg) was treated with homoallyl alcohol in the presence of Mn(CO)sBr as the catalyst under the standard conditions, 76 % of the silyl ketal was obtained. These silyl ethers possess neighboring carbonyl groups that can participate in the reaction by forming a more reactive pentacoordinated silicon center upon addition of the silane to the metal center.. 

Diethyl (trimethylsilyl) phosphine has been prepared by the reaction of lithium diethylphosphide with chlorotrimethyl-silane in ether solution.4 The lithium diethylphosphide may be prepared by the reaction of an ether solution of phenyllithium with diethylphosphine.6 However, the dialkylphosphines are most conveniently prepared by the reduction of the corresponding tetraalkyldiphosphine disulfides with lithium tetrahydro-aluminate in ether.6 7 An alternative method for the preparation of dimethyl(trimethylsilyl)phosphine which eliminates the handling of the volatile dimethylphosphine involves the preparation of lithium dimethylphosphide from tetramethyldiphosphine. The latter is prepared by the reduction of tetramethyldiphosphine disulfide8 with tributylphosphine.9 The reaction of chlorotrimethylsilane with lithium dimethylphosphide is most conveniently carried out in a vacuum system without solvent at -78°. 

The reaction may be of some preparative interest for obtaining alkylbenzonitriles and various a-functionalized alkylbenzonitriles starting from polynitriles (see Scheme 4.10 and Scheme 4.11) [56,57]. Donors that can be conveniently used as the precursors of the radicals include Jt donors, such as alkenes [58,59] and alkyl aromatics [60-63], heteroatom-centered donors, such as carboxylic acids [64] and ierf-butyl esters [65], ethers [66], ketals [67] (as well as cyclopropanone sUyl ketals) [68] and amines, organometallic donors such as silanes, silyl ethers, and silyl amines [69-71] as well as germanes, stannanes, and borates [72]. 

Silanes react with alkyllithium compounds, forming various alkylsilanes. Complete substitution is generally favored however, less substituted products can be isolated by proper choice of solvent. AH four methylsHanes, vinylsHane [7291-09-1and divinylsilane [18142-56-8] have been isolated from the reaction of SiH and the appropriate alkyllithium compound with propyl ether as the solvent (35). MethylsHane and ethyldisHane [7528-37-2] have been obtained in a similar reaction (36). 

Alkylation and arylation of organosilanes occur readily with alkyl and aryl alkaU metal compounds. Yields from these reactions are good but are iafluenced by steric requirements on both silane and metal compounds. There is Httie iaductive effect by the organic groups attached to siUcon, as measured by the yield of products (126,127). These reactions proceed more readily ia tetrahydrofuran and ethyl ether than ia ligroin or petroleum ether, where R and are alkyl or aryl and M is Li, Na, or K. 

Dianion formation from 2-methyl-2-propen-l-ol seems to be highly dependent on reaction conditions. Silylation of the dianion generated using a previously reported method was unsuccessful in our hands. The procedure described here for the metalation of the allylic alcohol is a modification of the one reported for formation of the dianion of 3-methyl-3-buten-l-ol The critical variant appears to be the polarity of the reaction medium. In solvents such as ether and hexane, substantial amounts (15-50%) of the vinyl-silane 3 are observed. Very poor yields of the desired product were obtained in dirnethoxyethane and hexamethylphosphoric triamide, presumably because of the decomposition of these solvents under these conditions. Empirically, the optimal solvent seems to be a mixture of ether and tetrahydrofuran in a ratio (v/v) varying from 1.4 to 2.2 in this case 3 becomes a very minor component. 

Vinyl Acetate CH3COOCH=CH2 OH compds, HCN, Halides, Halogens, Mer-cap tans, Amine, Silanes Oxygen Vap in Air 2.6 to 13.4% > Ambient > Ambient Inhibitor—Methyl Ether of Hydroquinone or 3-5ppm Diphenylamine. Store in a dry, cool place shield from light impurities 20.9-21.5 402 427 Free-radical polymerization initiated by Benzoyl Peroxide... 

A mixture of p-chloroanisole (0.5 mol) and PhLi (0.5 mol, prepared from PhBr and Li in ether) in ether (600 ml) was stirred at ambient temperature for 50 h. A solution of TMSCI (0.5 mol) in ether (50 ml) was added with stirring, which was continued for a further 24 h. The mixture was poured into saturated ammonium chloride solution, the layers were separated, and the ethereal layer was dried. Concentration and fractional distillation gave 4-chloro-2-trimethylsilylanisole, b.p. 84°C/2mmHg. which crystallized in the receiver. Three crystallizations from ethanol gave the pure silane (0.3mol, 60%). m.p. 51-51.5°C. 

To a solution of trimethylsilylmethyl lithium (from chloromethyltrimethyl-silane (15.8mmoI) and lithium dispersion (196mmol)) in ether (30ml) was added cyclohexane carboxaldehyde (14.2 mmol) at ambient temperature, with stirring. After a further 10min at ambient temperature, the solution... 

The checkers found considerable variation in the rate of the reaction in different runs, the time required for its completion ranging from 3 to 10 hours. It is therefore advisable to monitor the progress of the reaction. For this purpose small aliquots (ca. 0.05 ml.) were withdrawn from the flask with a syringe and hydrolyzed by injection into a vial containing ether and saturated ammonium chloride. The relative amoimts of enol silane and cyclopropoxy sdane were determined by gas chromatography on an 0.6 cm. X 3.7 m. column of 3% OV-17 coated on 100-120 mesh Chromosorb W. With a column temperature of 120° and a carrier gas flow rate of 20 ml. per minute, the retention times for the enol silane and the cyclopropoxy silane are ca. 1.9 and 2.3 minutes, respectively. 

The hydrosilylation of carbonyl compounds by EtjSiH catalysed by the copper NHC complexes 65 and 66-67 constitutes a convenient method for the direct synthesis of silyl-protected alcohols (silyl ethers). The catalysts can be generated in situ from the corresponding imidazolium salts, base and CuCl or [Cu(MeCN) ]X", respectively. The catalytic reactions usually occur at room tanperature in THE with very good conversions and exhibit good functional group tolerance. Complex 66, which is more active than 65, allows the reactions to be run under lower silane loadings and is preferred for the hydrosilylation of hindered ketones. The wide scope of application of the copper catalyst [dialkyl-, arylalkyl-ketones, aldehydes (even enoUsable) and esters] is evident from some examples compiled in Table 2.3 [51-53],... 

Reduction of ketones to triphenylsilyl ethers is effected by the unique Lewis acid perfluorotriphenylborane. Mechanistic and kinetic studies have provided considerable insight into the mechanism of this reaction.186 The salient conclusion is that the hydride is delivered from a borohydride ion, not directly from the silane. Although the borane forms a Lewis acid-base complex with the ketone, its key function is in delivery of the hydride. 

General Considerations. The following chemicals were commercially available and used as received 3,3,3-Triphenylpropionic acid (Acros), 1.0 M LiAlH4 in tetrahydrofuran (THF) (Aldrich), pyridinium dichromate (Acros), 2,6 di-tert-butylpyridine (Acros), dichlorodimethylsilane (Acros), tetraethyl orthosilicate (Aldrich), 3-aminopropyltrimethoxy silane (Aldrich), hexamethyldisilazane (Aldrich), tetrakis (diethylamino) titanium (Aldrich), trimethyl silyl chloride (Aldrich), terephthaloyl chloride (Acros), anhydrous toluene (Acros), and n-butyllithium in hexanes (Aldrich). Anhydrous ether, anhydrous THF, anhydrous dichloromethane, and anhydrous hexanes were obtained from a packed bed solvent purification system utilizing columns of copper oxide catalyst and alumina (ether, hexanes) or dual alumina columns (tetrahydrofuran, dichloromethane) (9). Tetramethylcyclopentadiene (Aldrich) was distilled over sodium metal prior to use. p-Aminophenyltrimethoxysilane (Gelest) was purified by recrystallization from methanol. Anhydrous methanol (Acros) was... 

Leighton and coworkers [217] have also used this approach to develop efficient strategies for the synthesis of polyketide-derived natural products [218]. A main motif of these compounds is a skipped polyol structure, as in 6/2-94 this can easily be prepared by a novel Rh-catalyzed domino reaction of a diallylsilyl ether in the presence of CO, followed by a Tamao oxidation [219]. Thus, reaction of, for example, the silane 6/2-93, which is readily prepared from the corresponding ho-... 

Alkenes with two reactive carbon-carbon double bonds per molecule like 1,5-hexadiene or diallyl ether are used in the synthesis of silicone compounds which can be later crosslinked by hydrosilylation. A sufficiently high excess of double bonds helps to prevent the dienes from taking part in silane addition across both olefmic ends, but trouble comes from double bond isomerization (Eq. 2). 

---