Separation Factor a

Separation factor a Spin-spin coupling constant AB... 

Separation Factor The separation factor, a, is defined consistent with other separation methods. It is important to recall that in membranes, a is the result of differing rates, and that it has no eqm-librium implications. The convention in membrane separations is to define the separation so that a > I. 

Enantioseparation is typically achieved as a result of the differences in interaction energies A(AG) between each enantiomer and a selector. This difference does not need to be very large, a modest A(AG) = 0.24 kcal/mol is sufficient to achieve a separation factor a of 1.5. Another mechanism of discrimination of enantiomers involves the preferential inclusion of one into a cavity or within the helical structure of a polymer. The selectivity of a selector is most often expressed in terms of retention of both enantiomers using the separation factor a that is defined as ... 

For example, only those dihydropyrimidines that contained a hydrogen-bonding donor at position 3 next to the chiral center were separated. Remarkably, dihydropyrimidines with non-substituted nitrogen atoms at positions 1 and 3 resulted in separations with longer retention times and decreased separation factors a. Increas-... 

In the elucidation of retention mechanisms, an advantage of using enantiomers as templates is that nonspecific binding, which affects both enantiomers equally, cancels out. Therefore the separation factor (a) uniquely reflects the contribution to binding from the enantioselectively imprinted sites. As an additional comparison the retention on the imprinted phase is compared with the retention on a nonimprinted reference phase. The efficiency of the separations is routinely characterized by estimating a number of theoretical plates (N), a resolution factor (R ) and a peak asymmetry factor (A ) [19]. These quantities are affected by the quality of the packing and mass transfer limitations, as well as of the amount and distribution of the binding sites. 

Racemate Separation factor a Resolution Note factor R S Refe- rence... 

Enantiomer separation factors (a values) for valine and phenylalanine as well as their esters of 5-10 for phenylalanine and 4-10 for valine have been shown at the 0.1-1 g ChiraLig scale. These a values vary as a function of solvent and other loading matrix factors (pH, salts, etc.). However, all of these cases show a values high enough to obtain reasonable enantiometric purity in less than or equal to three stages. The system with a value of = 6 for the valine methyl ester enantiomers has the ability to load the valine onto the resin in H,0 containing LiClO and also to... 

The distribution coefficient can be determined by batch experiments in which a small known quantity of resin is shaken with a solution containing a known concentration of the solute, followed by analysis of the two phases after equilibrium has been attained. The separation factor, a, is used as a measure of the chromatographic separation possible and is given by the equation,... 

Multiple-Component Separation Separation Factor Consistent with the characterization of different separation methods, one can define a separation factor a,j (also called selectivity) for components i andj that compares their relative concentrations in the permeate stream to those in the feed stream ... 

The steady state separation factor (a) for the two gases (C02 and CH4) is defined as the ratio of their individual permeabilities. 

The capacity factor tells us where the peaks elute relative to VQ. The separation factor (a) tells us where the peaks elute relative to each other. It is defined, for two peaks, as the ratio of the capacity factors, with the larger one in the numerator. 

Compound Separation factor (a) Configuration of the earlier eluting isomer... 

Aboul-Enein and Ali [78] compared the chiral resolution of miconazole and two other azole compounds by high performance liquid chromatography using normal-phase amylose chiral stationary phases. The resolution of the enantiomers of ( )-econazole, ( )-miconazole, and (i)-sulconazole was achieved on different normal-phase chiral amylose columns, Chiralpak AD, AS, and AR. The mobile phase used was hexane-isopropanol-diethylamine (400 99 1). The flow rates of the mobile phase used were 0.50 and 1 mL/min. The separation factor (a) values for the resolved enantiomers of econazole, miconazole, and sulconazole in the chiral phases were in the range 1.63-1.04 the resolution factors Rs values varied from 5.68 to 0.32. 

The chiral recognition ability of a CSP is quantitatively evaluated from the results of chromatographic separation of enantiomers. Figure 3.4 shows a chromatogram of the resolution of benzoin (19) on cellulose tris(3,5-dimethylphenylcarbamate). The (+)-isomer elutes first followed by the (—)-isomer complete baseline separation is achieved. The results of the separation can be expressed by three parameters—capacity factors (k1), separation factor (a), and resolution factor (Rs)—defined as follows ... 

The effect on sample resolution with changes in k, N or a values is shown in Fig. 15.10. For example, an increase in separation factor a results in a displacement of one band center relative to the other, and a... 

Total resolution of [269] into its two enantiomers was achieved by liquid-liquid chromatography through complexation to L-valine adsorbed initially on diatomaceous earth (Timko et al., 1978). On the basis of comparative chromatographic studies, the separation factors (a) and the EDC values were correlated (Cram et al., 1975) (Table 59). 

Temp. /°C RNHJ (PFf) Separation factor, a EDC (KJKB) Configuration of the more stable complex... 

---